Jump to content
SAU Community

Recommended Posts

I just bought some new turbos for more power so these need to go.

There R32 N1 turbos with no leaks.

Brand new stainless dump pipes with seperate wastegate tube plumbed back in. To suit 33gtr but can I can supply them to suit 32. The exhaust gas sensor is a different thread thats all.

Also a really good pfc tune to suit this setup.

I was running stock afms, injectors etc and they have made 292.5rwkw but I had the pfc retuned to a safer more through tune using the injectors and timing maps not just tuning off the afms and it now makes 280rwkw and has seen a little track time with no detination.

If you bought this setup all that would be needed would be a little tidy up of the tune to suit your car. Maybe 1 hours dyno time instead of a full remap. Save big $.

I'm after $1000 for the lot which is cheap considering if your ceramic turbo shits itself an engine rebuild is 5g plus and you also get more power. They are still in the car atm.

Phone if your really interested

Gareth 0417370869

Melbourne

It rises up to 20psi and it drops off to 18psi up top so max about 1.3bar. We couldn't get the boost controller to hold the boost up there but in a way it reduces the chance of killing an engine at the higher rpms so its not really a problem.

These turbos have really good response on the track and at motocarna's so it gives the car really good traction/drive out of corners compared to a few cars running singles and there also nice on the street.

If your after really cheap power you can't go past this setup. Its kept me more than happy for the last few years.

I don't know about when they start making boost and full boost but I can tell you that it makes full boost way before a gtr with a to4z due to how it pulls away out of corners and when it was overlapped over a gtr with 2560-5 turbos with around 10rwkw more power the power curves were almost identical apart from the 2560-5's making about 5-10rwkw more once the power graph began to rise.

Hope this answered your question in a round about way. There is no problem with response. Its all about your right foot and how good you are. What are you planning on using the car for? I have used it for track and motocarna and have had performed very well with what I have and have had no problems with lag at any time.

  • 2 weeks later...
Must go. any offers

hey mate,

i am running a stock R32 GTR, was thinking about upgrading the stock ceramic turbos.

what mods did you have when you got 280rwkw?

i am only looking at replacing the turbos and getting a FMIC and Power FC i dont want to have to change internals.

Brezza you already have a fmic and its good for over 350rwkw so keep it. Save the cash for an exhaust system and cam gears and the pfc and you have the same mods as my car. Replacing the ceramics is a great idea. I've had a exhaust wheel go through a rb26 and its not cheap to repair in a old car. As for internals there are guys in the club running 350rwkw out of rb26's with stock internals so the N1's will be fine.

hey mate,

is the N1 just a rebuilt stock turbo with better bearings and steel wheels?

also what boost were you running to get 280kw?

i would be aiming for around 260kw, something a little more safer and something i can use without stopping for fuel all the time

Brez

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • What copper washer do you guys use on the bleeder bolts? The existing one I have I had no idea where to find it in a local store, I did buy some online but that are only 1mm thick whereas my old one is 2mm+ thick and when I put the new washer out and squeeze the top radiator hose I can hear a bit of air but not with the old one. Does this matter? The new one doesn't leak, but the inner diameter is a bit loose whereas the old one threads on the bolt.
    • Howdy all, after being out a few weeks ago on a spirited drive in my GTR I have 2 issues that oddly have appeared at the same time. Whilst accelerating quickly through the gears all of a sudden i’ve lost power at the top of third gear (below redline around 6000rpm) for no obvious reason.    From that point onwards the car has been running rich on idle, won’t really rev under load without a ton of black smoke and the odd backfire, and dying as a pull up to a set of lights unless I keep the revs up around 1500rpm. In addition when shutting down the car that same night (I was 10 minutes from home) I noticed one of the turbos was significantly noisy on wind down when shutting off the engine. After letting the car cool down overnight it starts up fine, although once it gets to temp the revs start to creep up and down, the exhaust is darker than it should be and it also sounds like it’s running rich (fat note) I’ve put a new set of plugs in it - no change, the old plugs all seemed OK with two of them being somewhat richer/fueled up than the other 3 with 1 being borderline. I’ve smoked tested the intake system via the front of the Turbos, found a split vacuum hose going to the factory boost gauge sender, which I have since replaced.  Also found another leak on the gasket coming off the rear turbo outlet, have also replaced this. After fixing both of these leaks - still have the running rich issue. I’ve also tried another pair of AFM’s - no change here After pulling off the front turbo intake pipes, there is obvious shaft play in the front turbo, which now hisses loudly on light revvs although I can’t see why this would make the car run funny even under idle. I’m curious to know why it’s running rich before I potentially replace/rebuild turbos. The car is completely stock <50,000kms  other than an exhaust. Oil and coolant are all clear. I haven’t bothered with coil packs as it looks like they won’t be the issue due to condition of the plugs. Any help appreciated as I cry myself to sleep!
    • No probs at all. I used to love trying to dig up obscure info for those in need where possible going back 20+ years on SAU.  I did have another look and couldn't come up with any closer match. I'm leaning towards those skirts in your first pic are custom fitments, cut down/extended or from another car entirely and modded to fit an R34 sedan. I would've thought someone in Japan had them and taken a photo at some stage over the last 2 decades but there's nothing. Someone out there must know surely.
    • Welcome mate. Any pics? Even with a DE I'd be well happy if I had that as a 1st car. 
×
×
  • Create New...