Jump to content
SAU Community

Recommended Posts

how come its more expensive than a private practice day ?

is there some difference from drive day to private practice ?

Last time i went to EC (i think this day is run by the same group) they had 4 or 5 instructors, so you'd expect it to be a bit more exy.

Got a set of Falken RT-615s fitted today, just got to cut off my rear brake dust shields and i'm ready.

I booked in on Monday and there were 20 spots left.

How much did the tyres set you back Mr Kotter? Size?

$308 for 255/40/17s from Castle Hill Jax, + $8 per tyre for nitrogen fill. CH Jax was recommended in another thread. Other places quoted $325/330. They look pretty chunky compared to the 595SS Federals i was running. I need to see what times i can do at Wakefield to make a comparison - i didnt time at EC the other time i went.

Well another track day done a dusted.

As far as i'm aware, everyone who drove there drove home (Adam did you get home ok?). Although not without some hickups.

On the first lap of my first session, my intercooler pipe popped off and i just rolled down the main strait and came to a halt in between turn 1 and 2. Anyway, i got a tow back to the pits, took the front bar off, refitted the intercooler pipe and i was up and running again in 20mins. It was more of a pain in the butt then anything. I took the intercooler out on the weekend to fit a power steering cooler. I must have left one of the pipe clamps loose. :cheers:

But after that little hickup, the day was smooth, albeit quite warm. 33 ambient in the pits, hotter on the track. My intake temps were at 65degs whilst on track in the last session of the day. A larger radiator, power steering cooler and oil cooler kept the hot elements at bay, and apart from a power hit due to the hotter day, i ran all day and the 20min session felt like 5mins.

I didn't beat my lap previous lap time. I threw everything at it though. Could be due to the temps?

Could be my last track before my new engine arrives, although I might squeeze out an OP track day in late Dec/early Jan.

andrew

Well another track day done a dusted.

As far as i'm aware, everyone who drove there drove home (Adam did you get home ok?).

Yeah i made it home - no damage. Thanks for the push :cheers:

I did a 2.05, but was still getting into the zone when the hose burst.

The RT-615s are a huge improvement over the Fed 595SSs :w00t:



  • Similar Content

  • Latest Posts

    • Yea - I mean I've seen my fuel pump which is decades old and uh, while I'm not saying this with real knowledge... but I sure get the ick at using anything in the fuel system that produced the state of that pump. Many years ago I went through multiple pumps (and strainers) before I dropped the tank to clean it out with extreme violence. I'm talking the car would do maybe 50km before coming to a halt, which resulted in me cleaning out the filter with some brake cleaner and going on my way. None of my stuff ever looked like what came out of your fuel tank. I don't think I'd be happy with it unless every single component was replaced (or at least checked/cleaned/confirmed to be clean here).
    • I'm not going to recommend an EBC pad. I don't like them. Just about anything else would suit me better. I've been using Intima pads for a while now.
    • Agreed, and in particular the earth strap that should go from the subframe to the chassis but it often broken or left off. There is a section in the R32 workshop manual you can follow for troubleshooting if you don't see anything suspicious, and depending where you are (there is no location on your user profile) you should be able to get your hands on a second hand replacement unit still if needed
    • Yeah they mention as a R34 for 2.5 Turbo...but then again thos "small" were also for R34 by that different site. But i look into it and that 310mm EBC is for R34 GTT. And by those you linked the specs are the same 🙂    EDIT: I found these on one site here: DBA 4000 series T3 DBA42304S They are 310mm...and it says are for R34GTT...are there good? EDIT2: ok they have pads too.  What "color" should i get for street use? I dont want/need some noisy ones...(and if they are not that dusty that is good too)
    • Yeah, shame. Maybe  driver's carpet is available 🙏. I am waiting for both amayama and nangun to confirm.
×
×
  • Create New...