Jump to content
SAU Community

Recommended Posts

  • Replies 116
  • Created
  • Last Reply

Top Posters In This Topic

hey any rims avaliable?

Have a few sets of rims available, pick up in SA or postage at your expense

http://www.skylinesaustralia.com/forums/17...85#entry3509985

rear subframe?

still have it on the car $100 but you need to give me a hand to pull it off, comes with lower control arms and HICAS too.

or $180 and I'll pull it off myself

  • 2 weeks later...

Engine has now been sold but some parts were split, these include

-RB25DET clutch fan assembly $80

-engine loom $80

-standard ECU $100

-entire loom from car, uncut one entire piece $80

^^^ALL of above $150

-standard R33 turbo (no shaft play) and manifold $500

-all oil/water lines plus banjo fittings $60

-stock dump/front pipes $40

^^^ALL of above $500

-RB25 AFM (no mesh) $100

-rubber intake pipe $30

(includes the re-circ pipes etc)

-Simota pod filter and RB/Z32 AFM adaptor $30 (not from the skyline, previously used on my old car for ~4 months)

^^^ALL of above $120

-standard clutch cover and organic clutch plate $50

Edited by PT
  • 2 weeks later...

still got the rear parcel shelf with speaker covers avail? my 96 came in with messy holes cut, looking for something neater icon9.gif

Edited by Blayz

hi im in sa too do you still have the coil pack loom is it for s2 thoe pl ease just pm me back when you can dude

still got the rear parcel shelf with speaker covers avail? my 96 came in with messy holes cut, looking for something neater icon9.gif

still have parcel shelf, excellent condition, no mark/sholes

hi im in sa too do you still have the coil pack loom is it for s2 thoe pl ease just pm me back when you can dude

sorry don't think I have it, reckon I left it on the engine in the end, if I can find it I'll send you a PM

still have parcel shelf, excellent condition, no mark/sholes

PM sent wit my email addy, defin8ly interested so hit me back on there or wit a PM on here

also, might b a stupid q, but the lil cap that sits inside the right side door handle (covering the screw holding door in place), you wouldn be willing to let go of that 2 would ya? mines gone missing, no idea when or how, but its niggling @ me and im not gonna go source a whole new door for jus a cap :thumbsup:

Edited by Blayz

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • What copper washer do you guys use on the bleeder bolts? The existing one I have I had no idea where to find it in a local store, I did buy some online but that are only 1mm thick whereas my old one is 2mm+ thick and when I put the new washer out and squeeze the top radiator hose I can hear a bit of air but not with the old one. Does this matter? The new one doesn't leak, but the inner diameter is a bit loose whereas the old one threads on the bolt.
    • Howdy all, after being out a few weeks ago on a spirited drive in my GTR I have 2 issues that oddly have appeared at the same time. Whilst accelerating quickly through the gears all of a sudden i’ve lost power at the top of third gear (below redline around 6000rpm) for no obvious reason.    From that point onwards the car has been running rich on idle, won’t really rev under load without a ton of black smoke and the odd backfire, and dying as a pull up to a set of lights unless I keep the revs up around 1500rpm. In addition when shutting down the car that same night (I was 10 minutes from home) I noticed one of the turbos was significantly noisy on wind down when shutting off the engine. After letting the car cool down overnight it starts up fine, although once it gets to temp the revs start to creep up and down, the exhaust is darker than it should be and it also sounds like it’s running rich (fat note) I’ve put a new set of plugs in it - no change, the old plugs all seemed OK with two of them being somewhat richer/fueled up than the other 3 with 1 being borderline. I’ve smoked tested the intake system via the front of the Turbos, found a split vacuum hose going to the factory boost gauge sender, which I have since replaced.  Also found another leak on the gasket coming off the rear turbo outlet, have also replaced this. After fixing both of these leaks - still have the running rich issue. I’ve also tried another pair of AFM’s - no change here After pulling off the front turbo intake pipes, there is obvious shaft play in the front turbo, which now hisses loudly on light revvs although I can’t see why this would make the car run funny even under idle. I’m curious to know why it’s running rich before I potentially replace/rebuild turbos. The car is completely stock <50,000kms  other than an exhaust. Oil and coolant are all clear. I haven’t bothered with coil packs as it looks like they won’t be the issue due to condition of the plugs. Any help appreciated as I cry myself to sleep!
    • No probs at all. I used to love trying to dig up obscure info for those in need where possible going back 20+ years on SAU.  I did have another look and couldn't come up with any closer match. I'm leaning towards those skirts in your first pic are custom fitments, cut down/extended or from another car entirely and modded to fit an R34 sedan. I would've thought someone in Japan had them and taken a photo at some stage over the last 2 decades but there's nothing. Someone out there must know surely.
    • Welcome mate. Any pics? Even with a DE I'd be well happy if I had that as a 1st car. 
×
×
  • Create New...