Jump to content
SAU Community

Recommended Posts

Hi all after some advice.

I have $1100 to spend on my r33 gtst series 1.

What would be the best value next thing to go for i have as follows already done.

Kakimoto exhaust

HKS pod filter

Walbro fuel pump

Mongoose alarm

all stereo components as i want.

Lowered king springs

Roh holotype R 17" mags

Brand new tyres

Brand new exedy heavy duty clutch

100000 klm service just been done.

custom front bar

custom rear wing

windows tinted.

Ebc fitted set at 7 psi (usually drive with daughter in car so no need for big power)

After some ideas to do next.

everything else that isnt listed above is standard

any fuel air management options in that price range?

Thanks in advance for any advice

Link to comment
https://www.sau.com.au/forums/topic/197130-what-to-do/
Share on other sites

Dump and front pipe and large Cat (if not included in the "kakimoto exhaust")

or

SAFC NEO would fit in the under $1100 catagory installed and tuned.

or

Some new Shock absorbers to replace the dead old ones which have further been killed by the lowered springs.

Edited by GTST
Link to comment
https://www.sau.com.au/forums/topic/197130-what-to-do/#findComment-3525639
Share on other sites

Dump and front pipe and large Cat (if not included in the "kakimoto exhaust")

or

SAFC NEO would fit in the under $1100 catagory installed and tuned.

or

Some new Shock absorbers to replace the dead old ones which have further been killed by the lowered springs.

What he said if your looking at more power.

Also look into some steel braided brake lines, new fluid and good pads (makes the brakes fell new again), or perhaps some new suspension bushes/shock/springs/swaybars to get it driving really nice.

Link to comment
https://www.sau.com.au/forums/topic/197130-what-to-do/#findComment-3525647
Share on other sites

Thanks for suggestions guys should of mentioned all suspension and brake components are only a couple of months old, so all good in that department.

where in bris would be good to supply and fit an safc and tune?

Link to comment
https://www.sau.com.au/forums/topic/197130-what-to-do/#findComment-3526009
Share on other sites

If you have thoughts of putting a FMIC on, do it before you do the SAFC, you'll only have to retune afterwards otherwise.

Also, boost it up before you get it tuned (Boost to a happy level, around 10PSi should be plenty)

Then tune it.

Link to comment
https://www.sau.com.au/forums/topic/197130-what-to-do/#findComment-3527451
Share on other sites

Stock intercooler is a restrictive piece of junk that doesn't really cool anything down (Good at heat soaking)

So really, no, I wouldn't be calling it safe.

With exhaust, FMIC, boost and tune, the car will be TOTALLY different for you.

FMIC kit is like $300 - $400

Fit yourself.

Get a boost controller, (Those $22 ones are great!)

Then get a second hand SAFC2 and tune it.

All for under $1100 if you do stuff yourself (Dyno it to tune it though)

Link to comment
https://www.sau.com.au/forums/topic/197130-what-to-do/#findComment-3528012
Share on other sites

FMIC for $400 involves cuttong a hole in the chassis, trimming the fan blades, cutting the front bar and it's support.

$150 R34 GTT side mounted stock intercooler is bigger than the R33 one in each direction, yet is a straight swap (bit tight but still straight swap).

it has been proven number of times to be good for cooling and flow for around 220rwkw.

your stock turbo will not do any more than that anyway.

$150.

remove some hose clamps, remove some bolts, remove old intercooker, then reverse the steps with new intercooler.

ALSO, SAFC will be tuned on a dyno.

that is when I would increase the boost. not before.

better safe than sorry.

strap the car on.

increase boost to 10psi, dyno run, get result.

then the tuner goes and makes the adjustments and runs it again, then same step over and over to find the best compromise.

expect around 190-200kw

Then post a thread on here about your result so everyone can take out there online penises and compare. :w00t:

Link to comment
https://www.sau.com.au/forums/topic/197130-what-to-do/#findComment-3528140
Share on other sites

LOL @ online penises.

OK now to find an r34 intercooler?

also how much should i be paying to fit and tune the safc 2. One workshop which i wont name has quoted $150 to fit it then around $600 to tune on dyno and wants car for 2 days?

Link to comment
https://www.sau.com.au/forums/topic/197130-what-to-do/#findComment-3528468
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • It is a kunfine Android screen . Does anyone know the wirering diagram of the fuga ??
    • just an update to this, poor man pays twice  Tried sanding down the pulleys but it didnt do the trick. Chucked another second hand alternator in the na car which I got for free off my mate and its fixed the squelling. Must have been unlucky with the bearings.    As for my turbo car, I managed to pick up a cwc rb alternator conversion bracket + LS alternator for 250 off marketplace, looked to be in really good nick. Installed it , started the car and its not charging the battery.... ( Im not good with auto elec stuff so im not sure if this was all I needed to do but I verified such by using a multimeter on the battery when the engine was running and I was only getting 12.2v )   I had to modify the earth strap for the new LS alternator , factory earth strap was a 10mm bolt which did not fit the bolt on the LS alternator which was double the size so I cut it off , went to repco bought some ring terminals that fit, crimped it onto the old earth strap and bolted it up to the alternator , started the car and same issue. Ran like shit and was reading 12.2 at the battery.  For a "plug and play" advertised kit thats not very plug and play but alas.  My question is , am I missing something ? Ive been reading that some people recommend upgrading the stock 80 amp alternator fuse to a 140 amp but I dont see how that would stop the alternator charging especially at idle not under load.  Regardless ive pulled it out and am going to get it bench tested by an auto elec tomorrow but it would be handy to know if ive missed something silly or have done something wrong.   
    • My wild guess is that you have popped off an intake pipe....check all of the hoses between the turbo and the throttle for splits or loose clamps.
    • Awesome, thanks for sharing!
    • To provide more specific help, more information is needed. What Android screen? What is its wiring diagram? Does the car's wiring have power at any required BAT and ACC wires, and is the loom's earth good?
×
×
  • Create New...