Jump to content
SAU Community

Recommended Posts

Item: Mines ecu

Age: No idea

Condition: Good

Price: $300

To Fit: (What car) R33 (rb25det) SERIES 1, MANUAL

Location: Darra, Brisbane

Contact: 0415773334

Comments: I havent even had time to put it in. Putting my head back together and need the cash to fund it.

Also got standard dump pipe for $30 if anyone wants one. Message my number provided if you want any more info.

Edited by Jamie88
Link to comment
https://www.sau.com.au/forums/topic/199977-r33-rb25det-mines-ecu/
Share on other sites

What benifit does this have over the standard ECU??

- Removes speed limiter

- Increased revs limiter

- Run more BOOST (my car was running 14 psi on a standard engine)

- Increases performance dramatically over standard ecu

- Improves fuel economy

- save on hasles using aftermarket ecu's just plug in and go

- Genuine MINES aproved and stamped (as pictured)

You MAY need a tune to run it, I couldnt tell you as I havent yet tried it as my car is in pieces. The ecu plugs straight into the standard plug

- Removes speed limiter

- Increased revs limiter

- Run more BOOST (my car was running 14 psi on a standard engine)

- Increases performance dramatically over standard ecu

- Improves fuel economy

- save on hasles using aftermarket ecu's just plug in and go

- Genuine MINES aproved and stamped (as pictured)

You MAY need a tune to run it, I couldnt tell you as I havent yet tried it as my car is in pieces. The ecu plugs straight into the standard plug

if you can confirm this will work on an auto i'll probably take it

if you can confirm this will work on an auto i'll probably take it

Cant confirm anything, only because I havent had it running in my car man, if your willing to risk it gimme a call.

- Removes speed limiter

- Increased revs limiter

- Run more BOOST (my car was running 14 psi on a standard engine)

- Increases performance dramatically over standard ecu

- Improves fuel economy

- save on hasles using aftermarket ecu's just plug in and go

- Genuine MINES aproved and stamped (as pictured)

You MAY need a tune to run it, I couldnt tell you as I havent yet tried it as my car is in pieces. The ecu plugs straight into the standard plug

Does this actually allow you to run more boost? Do you actually know what its tuned for at all or just guessing? Does it actually increase rpm limit etc if you haven't tried it how would you know? Its just that you state one minute your car was running 14psi on a standard motor but at the end of the same post you state you haven't yet tried it as your car is in pieces and in the subsequent post 'Cant confirm anything, only because I havent had it running in my car man' ?????

You also put you may need a tune to run it but is it actually retunable? Just incase you didn't know the R33 stores its maps on the actual main CPU which requires complete replacement to change fuel maps so unless this ECU has something trick it wouldn't be retunable.....

Edited by nigelswazi
Does this actually allow you to run more boost? Do you actually know what its tuned for at all or just guessing? Does it actually increase rpm limit etc if you haven't tried it how would you know? Its just that you state one minute your car was running 14psi on a standard motor but at the end of the same post you state you haven't yet tried it as your car is in pieces and in the subsequent post 'Cant confirm anything, only because I havent had it running in my car man' ?????

You also put you may need a tune to run it but is it actually retunable? Just incase you didn't know the R33 stores its maps on the actual main CPU which requires complete replacement to change fuel maps so unless this ECU has something trick it wouldn't be retunable.....

Ok my mistake I copy and pasted that off the information I was sent on ebay apon purchase. So to clear things up. This guy had it running on his car, on 14psi with front mount and full exhaust made 210kw at the wheels. Now, everything else Ive said makes sense. I havent tried it on my car as the head is off. It is a genuine mines ecu, Stamped/plated , still sealed has not been taken apart and tampereed with so other than what Ive provided I cant tell you much else about it. Has new air/fuel maps etc. Im sure someone must know a bit more about them than I do, Im just getting rid of it to help me get my car back running. Hope it helps. Sorry for the confusion

to clear things up, i'll lend a hand

i am CURRENTLY USING a Mines ecu.

NO they are not remappable coz they are factory locked. so for those of you looking to use then remap, no good.

it removes boost cut, rev limit (yes i have driven into redline before), speed cut.

you are right in stating it is a good increase in power and torque but the fuel economy is no better than standard, in many cases worse! you might also want to stating whether for series one or two cos they might be different.

cheers

i dont see why you would want to remove your rev limiter or make it higher with stock engine:S

stoopid i think...

and how would it be saving you fuel in this case??????

no it doesnt help on the fuel side. think of it as a remap but more aggressive. it will be a plug in replacement with the standard computer with the simple case of pull out the old one and plug in the new. does NOT require to be retuned, or rather should i say it CANNOT be retuned/mapped unless you ship your car back to the Mines factory as it is done to your vehicle specs.

over-revving is not recommended coz it pushes the engine beyond its intended measures, but to see what it can do i did it anyways hahaha

in regards to the speed limiter, i havent been able to go beyond 260 yet (my radiator blew) so cant see any limit placed on it.

.... but the fuel economy is no better than standard, in many cases worse! you might also want to stating whether for series one or two cos they might be different.

cheers

either way it is more than likely tuned to an exhaust and pod filter at least, with some chance of it been mapped to fmic and other minor mods.

NOTE...it WILL be running rich...VERY rich lol expect to change plugs more often with smokey exhausts and big flames :blink: hahaha

either way it is more than likely tuned to an exhaust and pod filter at least, with some chance of it been mapped to fmic and other minor mods.

NOTE...it WILL be running rich...VERY rich lol expect to change plugs more often with smokey exhausts and big flames :blink: hahaha

Thanks for your help and input man, I havent had a lot to do with ecu's. The guy that sold me it had it in a series one r33 manual transmission

Thanks for your help and input man, I havent had a lot to do with ecu's. The guy that sold me it had it in a series one r33 manual transmission

same as mine then. no worries bud-

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • The rain is the best time to push to the edge of the grip limit. Water lubrication reduces the consumption of rubber without reducing the fun. I take pleasure in driving around the outside of numpties in Audis, WRXs, BRZs, etc, because they get all worried in the wet. They warm up faster than the engine oil does.
    • When they're dead cold, and in the wet, they're not very fun. RE003 are alright, they do harden very quickly and turn into literally $50 Pace tyres.
    • Yeah, I thought that Reedy's video was quite good because he compared old and new (as in, well used and quite new) AD09s, with what is generally considered to be the fast Yokohama in this category (ie, sporty road/track tyres) and a tyre that people might be able to use to extend the comparo out into the space of more expensive European tyres, being the Cup 2. No-one would ever agree that the Cup 2 is a poor tyre - many would suggest that it is close to the very top of the category. And, for them all to come out so close to each other, and for the cheaper tyre in the test to do so well against the others, in some cases being even faster, shows that (good, non-linglong) tyres are reaching a plateau in terms of how good they can get, and they're all sitting on that same plateau. Anyway, on the AD08R, AD09, RS4 that I've had on the car in recent years, I've never had a problem in the cold and wet. SA gets down to 0-10°C in winter. Not so often, but it was only 4°C when I got in the car this morning. Once the tyres are warm (ie, after about 2km), you can start to lay into them. I've never aquaplaned or suffered serious off-corner understeer or anything like that in the wet, that I would not have expected to happen with a more normal tyre. I had some RE003s, and they were shit in the dry, shit in the wet, shit everywhere. I would rate the RS4 and AD0x as being more trustworthy in the wet, once the rubber is warm. Bridgestone should be ashamed of the RE003.
    • This is why I gave the disclaimer about how I drive in the wet which I feel is pretty important. I have heard people think RS4's are horrible in the rain, but I have this feeling they must be driving (or attempting to drive) anywhere close to the grip limit. I legitimately drive at the speed limit/below speed the limit 100% of the time in the rain. More than happy to just commute along at 50kmh behind a train of cars in 5th gear etc. I do agree with you with regards to the temp and the 'quality' of the tyre Dose. Most UHP tyres aren't even up to temperature on the road anyway, even when going mad initial D canyon carving. It would be interesting to see a not-up-to-temp UHP tyre compared against a mere... normal...HP tyre at these temperatures. I don't think you're (or me in this case) is actually picking up grip with an RS4/AD09 on the road relative to something like a RE003 because the RS4/AD09 is not up to temp and the RE003 is closer to it's optimal operating window.
    • Either the bearing has been installed backwards OR the gearbox input shaft bearing is loosey goosey.   When in doubt, just put in a Samsonas in.
×
×
  • Create New...