Jump to content
SAU Community

Rda Rotor (& Ebc Pads) Group Buy Is Back In 2008!


Recommended Posts

all cleared, group buy sent off yesterday. today is public holiday in VIC so it may not be fully processed again until tomorrow, but that shouldn't be a problem.

  • Replies 548
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

If they're all in stock they can be shipped out of their warehouse as soon as wed or thu. but if I heard anything from them about anything that may be out of stock and may cause delay then I'll post it here.

Most likely front R32 Gtst rotors. Measure it then I'll know. Rears are the same.

If your front rotors is 280mm (28cm) diameter across then it's the R32 gtst rotors, rear should be 297mm across (close to 30cm).

If front is also 296mm (about 30cm) across then you've got the front R32 gtr rotors.

Update to Group Buy 40 :

1. Muz (payment cleared)

2. scorp (payment cleared)

3. SevenAngryPenguins (waiting for payment to clear)

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Nice car! I’m glad folks in the US have gotten past the FnF and are buying real cool cars like the 260RS I was with a bunch of mates in Portland about a year ago and spotted a green Stagea (just a regular 2.5T AWD) parked about 2 blocks away and they were like “a what?” So I made a bet with them for a round of beers and said “ok one of you run down there and tell me if the steering wheel is on the correct side” 5 mins later the American comes trudging back up the hill and goes “he’s right guys. Ok what beer do you want?”
    • Should replace OR drop the tank, give it's good clean. Might be worth replacing that entire fuel level/pump/cradle thing with this: https://frenchysperformancegarage.com/products/fpg-s13-180sx-r32gtst-single-pump-hanger-kit-billet-hat-6-v3-fpg-089?gQT=2  
    • Thank you so much for the help
    • Yes it is ATF. I quote @Duncan "it takes a good synthentic auto trans fluid like Castrol Transmax Z" It's not a diff. It's a transfer case. Totally different thing. Yes, fluid will come out the sender hole. No you do not really need to drain it. Just pull the old, quickly poke the new, clean up and top up. But realistically, you should probably take the opportunity to change it anyway.
    • Hey all. I’m looking on replacing my speed sensor on my R33 GTR. Will the center differential need to be drained, and if so, the center diff uses ATF fluid D? I found information on the transmission, front diff and rear diff. Can’t find a for sure answer for the center diff. Any help will be greatly appreciated.
×
×
  • Create New...