Jump to content
SAU Community

Recommended Posts

Hey guys and girls

I just sold my rx7 because it was a petrol hungry beast, am now looking at a 34 non turbo

anyone know much bout them?

looks nice but is it good on fuel??? ive had enough with the petrol hungry cars looking for something more tame.

any suggestions or tips about the 34?

Link to comment
https://www.sau.com.au/forums/topic/203276-r34/
Share on other sites

Hey guys and girls

I just sold my rx7 because it was a petrol hungry beast, am now looking at a 34 non turbo

anyone know much bout them?

looks nice but is it good on fuel??? ive had enough with the petrol hungry cars looking for something more tame.

any suggestions or tips about the 34?

The Term "Petrol hungry cars" can be very wild, so in your standard how much Litre/100kms is too hungry for you mate thats the question.

So if you want a car that need next to nothing to run buy:

"Smart 4 Two" A.K.A Smart-car

Echo

Yaris

Getz

Swift

If you don't want a small or a compact car but yet uses less fuel then:

Camry

Aurion

VE commodore

Accord Euro

New lancer

If you want a car that have a sporting looks or go fast feel but yet retain some sort of fuel economy then:

Mini

FTO

Civic Type-R

Integra Type-R

350Z

Non turbo Version of R34,R33,R32, WRX Rs, Supra

Edited by MRR34
Link to comment
https://www.sau.com.au/forums/topic/203276-r34/#findComment-3605711
Share on other sites

if you can keep your foot out of it and drive sedately it will be MUCH better than a rotor.

I have a wagon that will chew 60lt of 98 octane petrol in 290k if I drive it wild. sedate it will do 550 on the same tank.

Link to comment
https://www.sau.com.au/forums/topic/203276-r34/#findComment-3606416
Share on other sites

a 34 NA is no more fuel guzzling than a 6 cyl commodore...and should definately be much better compared to a rotor.

althought my mrs gets 500-600 a full tank fuel using the cheaper ethnol blends.. FYI the NA auto RWD dynoed at 160hp @ rear wheel this is after a major service and tune as well

Link to comment
https://www.sau.com.au/forums/topic/203276-r34/#findComment-3611720
Share on other sites

They are decent for a six cylinder with mine getting about 10liters per 100kms on average, thats better than my 2006 hilux ute which is a 4cylinder. I wouldn't waste your time getting an na (thats wat i have) nice car and all drives great, but is pretty slow and also don't get an auto (extra slow). A manual might be alright, but power wise i raced my old r31 manual with just extractors and exaust against my stock auto 34 and there was nothing between them, over 120km the 34 would flog it. You would probly get a bit better fuel economy out of the manual version as well.

Edited by turtlepower
Link to comment
https://www.sau.com.au/forums/topic/203276-r34/#findComment-3623391
Share on other sites

  • 8 months later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • The oil pressure sensor for logging, does it happen to be the one that was slowly breaking out of the oil block? If it is,I would be ignoring your logs. You had a leak at the sensor which would mean it can't read accurately. It's a small hole at the sensor, and you had a small hole just before it, meaning you could have lost significant pressure reading.   As for brakes, if it's just fluid getting old, you won't necessarily end up with air sitting in the line. Bleed a shit tonne of fluid through so you effectively replace it and go again. Oh and, pay close attention to the pressure gauge while on track!
    • I don't know it is due to that. It could just be due to load on track being more than a dyno. But it would be nice to rule it out. We're talking a fraction of a second of pulling ~1 degree of timing. So it's not a lot, but I'd rather it be 0... Thicker oil isn't really a "bandaid" if it's oil that is going to run at 125C, is it? It will be thicker at 100 and thus at 125, where the 40 weight may not be as thick as one may like for that use. I already have a big pump that has been ported. They (They in this instance being the guy that built my heads) port them so they flow more at lower RPM but have a bypass spring that I believe is ~70psi. I have seen 70psi of oil pressure up top in the past, before I knew I had this leak. I have a 25 row oil cooler that takes up all the space in the driver side guard. It is interesting that GM themselves recommend 0-30 oil for their Vette applications. Unless you take it to the track where the official word is to put 20-50w oil in there, then take that back out after your track day is done and return to 0-30.
    • Nice, looks great. Nice work getting the factory parts also. Never know when you'll need them.
    • Thanks @jtha7 I will have a look around tomorrow but it is a prick of a spot. These are some photos i tried taking 
    • I take it that the knock retard is from bearings tapping a little tune? Thicker oil is a fragile bandaid. You need a much bigger oil cooler and probably the bigger pump being discussed.
×
×
  • Create New...