Jump to content
SAU Community

Recommended Posts

Make:nissan skyline R34 GTT

Model:R34 GTT

Milage:83000 kms

Transmission:5 speed manual

Colour:red

Location:melbourne

Complied?yes

RWC supplied?yes

Currently registered?yes

Price:20000

Contact:Bob 0422358205 or email [email protected]

Comments / Modifications:all stock i am first owner lowered nismo factory exhaust

Images:at carsales.com.au type rego ugb168 all deatil in there

post-27470-1203147862_thumb.jpg

post-27470-1203147927_thumb.jpg

Edited by bobby09
  • 2 weeks later...
  • 2 months later...
  • 2 years later...

hey mate, if ur interested in swapping i have a vk group 3 repllica, very clean car, worked 308 engine probly done less than 15000kms, very clean engine, i have car listed on here to look at, have a look and let me no, cheers, 0421175527

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...