Jump to content
SAU Community

Recommended Posts

Some a-hole defaced my car with some kind of paint eating liquid

which just means im bumping my respray schedual forward to ASAP

Just wondering How much i should be paying for a respray

To baby blue and possibly with a pearl coat.

My friend said hes uncle could probs do it for around 1.5-2k

My guess is the cheaper you get the worse it is...

p.s i dont want to buy my own paint and ask them to use it

Edited by Scottay
Link to comment
https://www.sau.com.au/forums/topic/206947-car-respray-costs/
Share on other sites

If you were in Perth I would do it for 4k windows out inside out (not the engine bay)etc .

I would have the windows taken out as it only cost around 300 to have all 4 taken out and the rear quarter window surounds are way to close to the panels to get a desent finsh around there .

Price will depend on what you want colour wise inside out makes a difference as well .

Cheap is not always good but nor is expensive

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Update: tested my spark plugs that are supposed to be 5ohms with a 10% deviation and one gave me a 0 ohms reading and the rest were 3.9ohm<, so one bad and the others on their way out.
    • 9" wheels are a little too wide for a RWD 32. They can fit. People have put R33 GTR wheels on 32s for years and years. But they are a very tight squeeze. This has been known for about 30 years. As I said - there is no difference between a 17 and an 18 in terms of what will fit. The rolling diameter needs to stay about the same as stock - not very much larger. If you increase that, you will start to have problems. If you increae rolling diamater at the same time as yo increase width, you will have problems earlier. as 9" wheels are pushing the boundaries already, you would need to be careful with tyre choice. I would put 8.5s on the front of mine, but would expect problems with 9s.
    • post up screen shots of your injector tables
    • Diagnostic flow for a code 21 says check signal at the ECU pins, on a voltmeter of some kind it should read 0.1V at idle, 0.12V cranking, 0.15-0.25V at 2000 rpm. Check each coil such that +1, -3 is infinite or very high resistance, -3, +2 should do the same. (-1, +3), (+3, -2), (+1, -2), and (-1, +2) should all be somewhere between 0 ohms and high resistance. If you trace the path from the coil pin all the way back to the ECU in the diagram the resistance you measure at the coil vs connected to the harness should be pretty much the same. 
    • I have an elite 2500 running an adapter harness on an rb25de neo r34. I took the butterfly out and removed all that junk. But I also went Plus+t at the same time. The butterfly thing works in reverse to the boost solenoid on the Gtt if that makes sense
×
×
  • Create New...