Jump to content
SAU Community

Recommended Posts

The stereo in my car was installed without a direct power or something so it resets every time you turn it off.

and I'm too much of a noob to re-do the install.

so.

it is a perfect timer.

and I start the car, get my bike on the back, bags in the boot, get in, belt on, in to reverse, and the radio says 12:02.

drive it at below 3000rpm and by the time I get to the freeway, the time says 12:06 and the engine temp is on half.

it has forged pistons too.

it has done about 50K kms since rebuild and has 323,000kms on the clock.

back awhile ago i use to do that, drive off without warming up, and the car feels really rough plus the gear change feels stiff too.

My 32 was just like that...so I used to set the turbo timer for about 5-6 mins and let it run while I ate my breakfast...very good idea

remote start while i'm brushing my teeth...

when i get in a minute later the climate control is just right, dvd is playing, cars starting to get warm and the back windscreen is demisted.

/bling

Yeah remote start rules :D

My 32 was just like that...so I used to set the turbo timer for about 5-6 mins and let it run while I ate my breakfast...very good idea

Waste of fuel + time in my opinion. Best advice is to get an oil temp gauge, and until its warm dont rev it.

I can't understand how anyone in their right mind would think warming up their car slowly is a good idea.

It just boggles the mind. A guy at work with a skyline does it, and i always say startin driving straight away, bring it up to temp sooner rather than later.

Most wear occurs when the engine is cold... so getting the temp up quicker is the best thing for it.

It doesn't mean rev it to redline it just means drive it like you would if your grandma was in the car until the temp gets up to normal.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • For these last 7 years of ownership, I've always had to use a small scissor jack under one of the front tow hooks to raise the front just enough so my low-profile jack fits under to reach my subframe jack point. I'm beginning to get annoyed of always having to do this. Are there any lower low-profile jacks that fit under the gtr lip on a dropped car?
    • Seat of the pants assessment of the new intake: The car is way less "doughy" when hitting the loud pedal, especially off idle when stopped or in traffic, I did use a cheapo lazer thermal thingo to measure the temp around where the pod filter got its air, it was between 55 - 60°C, in saying this the car was shut off and not moving, so the OEM intake pipe was not supplying any fresh air to where the pod was when the car was at least moving A weird bonus was induction noise on the throttle in the cabin increased a bit,  I was worried that I was actually going to lose some of that induction noise I love so much, outside though, when I got the daughter to do a WOT drive by pass for me, the induction noise has increased alot when on the throttle, not quite ITB doort, but well up there I'm extremely happy with the results and have been exploring the country roads in the region  As for house mods: 1.New front fence is up and is awesome, it really upgraded how the joint looks from the street, and the added security is nice 2. Electricians have replace some interior lights, and with more lighting in the garage, a few new motion detecting lights out the front above the garage, front room, and at the front door, which I have already found heaps helpful coming and going, also now has fancy pants CCTV all round the house The only hold point for power though is the solar and batteries due to supply issues, although this will happen over the next few weeks 3. I have done a heap of landscaping out the front and I'm almost ready to do a new small retaining wall with some nice blocks to replace the brick and cemented in rocks around the raised garden beds cemented in river stone "was the fashion at the time" the house was built. I currently have a pallet of retaining wall blocks and 2 bulka bags of 20mm blue metal to replace the wood chip that is in the raised garden beds around the house 4. I now have 3 big raised garden beds for out the back to grow some vegetables, about 70cm high, 200cm long and 100cm wide 5. My 2 compost bins are already pretty full with brown, green and kitchen waste from the landscaping I'vedone so far, but they will probably take a few months to break down, so anything else that gets chopped, trimmed, and kitchen waste will just start filling the base of the raised garden beds to about 30cm before I start throwing 40cm of good compost, and stuff, for the vegetables to grow in, I'll need a few ton of compost and soil, but the local supplier can sent me bulka bags of the stuff Basically the logs, wood chips and a few strategically placed rocks for drainage, will give the beds some good organic materials down low to break down over time, and they will hold moisture during the warmer months to save the water in my big arse water tank if we don't get alot of rain So, all in all, the car and house mods are going well, and I'm really enjoying being retired, I sleep in too 0700 and slowly plod around inside until I feel like actually doing anything, and only work in the yard for as long as want, which has actually been alot over the last few weeks,  although when you look at it, it seems that not a huge amount of work has been done,  until I look at the before I started the work pics Happy days and good times indeed 
    • hahaha yeah. Plan is to get side skirts and probably just rear pods. But going to do them one-by-one. I've got a set that I really like from RHDJapen, but that one isn't shipped to AU. So need to find someone who can get it for me
    • Here's an idea, answer the questions I asked you as they are trying to work out WHY the LSD will be binding up in a straight line.
×
×
  • Create New...