Jump to content
SAU Community

Does anybody have a steep driveway?? + low bumper = BAD!

Scotty

By Scotty,
in General Maintenance

 Share

Recommended Posts

Evil Mentor

Evil

Posted
Posted

I just got a letter from the council (after owning my car 8 months) telling me that there is no problem my drive. What a laugh! Being an Italian I am going to do the best concreting job I can :) I don't know if it is illegal, I don't care! I tried to do the right thing and the council has fcuked me...

Dawzey Collaborator

Dawzey

Posted
Posted

my bar is only 8..5 cm off the ground.

just take it slow and go hela sideays over bumps and stuff and u will be fine.

i have only got some minor scratches on mine.

unless my dad drives it...... arrrrre crap

oh well.

NA_R33 Grand Master

NA_R33

Posted
Posted

my kit was only totally finished on monday, and i cracked the front bar tuesday on my driveway, i could not express my feelings in words at that point in time and it still shlts me that i did it. Oh well back to the shop next week.

Craved Grand Master

Craved

Posted
Posted

Had a similar issue to NA_R33, only this happened when someone tried to steal the car from the front of a club!!!

Got the car back, only after being dragged 400+m down the road at about 90 Km/h.... definatley not the best time i've had in the 33!

Craved Grand Master

Craved

Posted
Posted

insurance, wouldn't be worth claiming since i got the keys out of the ignition while the car was going!!!

put in a claim for damages with the police, they sure no worries i'll put it through with the DUI, theft, driving in a manner dangerous to the public charges!!!!

Didn't hear from them again!!!

typical, will take your money, but them chasing it for you... good luck!

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • GTSBoy
      New kid on the block

      By GTSBoy · Posted

      The wiring diagram for the R33 RB25 is freely available, and is essentially the same same as most other RBs (just with differences as to which pin # does which job). To get the ECU to power up, you just need to provide power to the ECCS relay, and have the other power feeds that come in from the top left of the wiring diagram (wrt the ECU) that give perma power to the fuel pump relay, the ECU itself, etc etc, all connected. When you put power on all these it will just come to life. It's pretty clear from the diagram what needs to happen. Just follow the lines from the 12V + supply stuff in the top left over towards the ECU. I've even posted snips of such diagrams (not for vanilla 25, I think for Neo and 26) to various threads here in the last few months, talking about what it takes to get the fuel pump and FPCM up and going. Search these up and they will help get you started on doing the same with the vanilla 25 diagram. Hell, for all I know, I've done the same with that one in years past and have forgotten.
    • Duncan
      New kid on the block

      By Duncan · Posted

      Yep...so unless someone posts up the answer you will need to probe from the ECU connector to the dash plug with a multi meter in continuity mode to trace the wires.  Note the ECU has multiple - and + (and across different key settings - Battery, IGN and Start) and most likely the power is fed from the connector(s) that is normally near the left hand headlight.
    • Songo
      New kid on the block

      By Songo · Posted

      Thanks Duncan, I am actually just trying to get the Rb turning and running with the RB25DET S2 original loom itself  I am just trying to get it going outside the body and not thinking about the S15 or trying to match anything to the S15 loom at all I am only trying to see if anyone has done this and what pin they found to be the ignition trigger and ECU+/- on the dash connector, that's about it. Thanks  
    • iain_ST44GA
      M35 VQ25DET starter motor

      By iain_ST44GA · Posted

      Hi Guys, Does anyone know any aftermarket part numbers for a starter motor to suit the VQ25DET? I can find lots of alternative part number for the VQ35DE, which I assume would fit, but there is a lot of conflicting information out there. Thanks..
    • Murray_Calavera
      R33 GTR running -9 with no tune

      By Murray_Calavera · Posted

      I don't understand how this hasn't boiled down to - Upgrade the turbo when you have everything required. ECU, injectors, fuel pump, turbo, etc. Do it all at once.  If you don't have everything required, just enjoy the car as it is and keep saving up your pennies. 
×
×
  • Create New...