Jump to content
SAU Community

Recommended Posts

  • Replies 56
  • Created
  • Last Reply

Top Posters In This Topic

hey mate

At what point in the rev range did this thing start to spool and at what point did it come on full boost.

Thanks

I am also interested to know this as i am interested in ure turbo

yeah at times it will only chirp 3rd... haha

CREATD Motorsports did the work on the manifold, its a china manifold and been cleaned up and modified to work like any $1000 manifold would, the motor was built by them a while ago, tuning was done by them.. Give them a call if you want, speak to Daniel or Rob and ask them about my car if you require any more info.

well im about to purchase one for 1100 delivered.. if u can beat that price then ill buy it from u. or even if u can match the price coz ur in melb atleast.. the one im buyin is from my mate in adelaide :thumbsup:

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • With ordering the belt, you're doing water pump and the idler and tensioner at the same time too yes?
    • This is just a dumb way of keeping the wastegate closed to make more boost. Undo it and either follow the factory setup or redo it properly. Manual boost controllers just use a spring preload to determine when to close in response to boost pressure so it no longer vents to atmosphere.
    • So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
    • Bit difficult to follow. Have a look below and see what the standard R32 layout was like. Note there was a restrictor in place immediately before "turbocharged pressure control solenoid" that, if removed, magically got you 1 bar boost.
    • I might be way off the mark here.. there must be a T junction under the manifold. That takes manifold pressure through a check valve prior to the T, one side splits out to this bleed off orifice, the other straight to the wastegate actuators. 
×
×
  • Create New...