Jump to content
SAU Community

Recommended Posts

Hi all.

I have a set of 18" RAYS / Nismo LMGT2 3 piece wheels that came off an R33 GTR and another set that came off an R34 GTR. Question is, are they a direct bolt-on for a V35 Skyline GT coupe? I do not have the offsets in front of me (and I am not an expert on them anyway) but I hope the vehicle's they came off will give someone in the know a clue if they will fit. The exact wheels are in the pics attached.

Thanks in advance.

Out.

post-8525-1205276707_thumb.jpg

post-8525-1205276730_thumb.jpg

Edited by Garage Menace
Link to comment
https://www.sau.com.au/forums/topic/210020-gtr-nismo-wheels-on-a-v35-gt-coupe/
Share on other sites

It all depends on the offsets.

I've seen GTR offsets in the low teens. Something like this may not fit unless you do some serious guard rolling.

Being 18" the diameter will more than likely be fine, as I've seen V35's go to 11inch wide without too much drama.

The offset is really your only issue. If they are in the low 20's, high teens then you may be right. As an example a +22 offset is almost perfect for a V35.

Yeah, without offsets it'd be impossible to call.

They look a little sunken in on that R34 so its definitely possible, but I wouldn't stake my guards on it.

You can run an 18x9.5 +22 and 18x10.5 +22 on our cars without rolling the guards.

If you're willing to do some mods to the car (front and rear camber adjustment equipment, rolling the guards) you can fit aftermarket R34 GT-R rims onto our cars. There's a guy in the US running 18x10.5 +15 rims all round on his 350Z with 275 width tyres, with guard rolling and lots of camber.

Unfortunately he's taken his pics down from that thread (and other threads don't show it), but I remember that it did look retarded on the front since the tyres stick out with the amount of camber being run. An OK look if you're building a race car, but it looks a bit ghetto on a street car.

  • 3 months later...

I will say that they will fit for sure. They look to be the same or more sunken than standard R34 GTR rims which are 18x9 +30. I have seen 19x9.5 +17 and 19x10.5 +18 on both V35 and R34 GTR (same rims that we tried on) and the rears were flush with 275/35/19 tyres and the front we still a little sunken in but not as much as in your pics.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I got back to Japan in January and was keen to get back on track as quickly as possible. Europe is god-awful for track accessibility (by comparison), so I picked up a first-gen GT86 in December just to have something I could jump into right away. The Skyline came over in a container this time and landed in early January. It was a bit battered after Europe, though—I refused to do anything beyond essential upkeep while it was over there. The clutch master cylinder gave out, and so did the power steering. I didn’t even bother changing the oil; it was the same stuff that went in just before I left Japan the first time. Naughty. Power steering parts would’ve cost double with shipping and taxes, so knowing I’d be heading back to Japan, I just postponed it and powered through the arm workout. It took a solid three months to get the car back on the road. Registration was a nightmare this time around. There were a bunch of BS fees to navigate, and sourcing parts was a headache. I needed stock seats for shaken, mistakenly blew 34k JPY on some ENR34 seats—which, of course, didn’t fit—then ended up having the car’s technical sheet amended to register it as a two-seater with the Brides. Then there’s the GT86. Amazing car. Does everything I want it to do. Parts are cheap, easy to find, and I don’t care what anyone says—it’s super rewarding to drive. I’ve done a few basic mods: diff ratio, coilovers, discs, pads, seat, etc. It already had a new exhaust manifold and the 180kph limiter removed, so I assume it’s running some kind of map. I’ve just been thrashing it at the track non-stop—mostly Fuji Speedway now, since I need something with higher speed after all that autobahn time. The wheels on the R34 always pissed me off—too big, and it was a nightmare getting tires to fit properly under the arches. So I threw in the towel and bought something that fits better. Looks way cleaner too (at least to me)—less hotboy, less attention-seeking. Still an R34, though. Now for future plans. There are a few things still outstanding with the car. First up, the rear subframe needs an overhaul—that’s priority one. Next, I need to figure out an engine rebuild plan. No timeline yet, but I want to keep it economical—not cutting corners, just not throwing tens of thousands at a mechanic I can barely communicate with. And finally, paint. Plus a bit of tidying up here and there.  
    • Nope, needed to clearance under the bar a little with a heat gun, a 1/2" extension as the "clearancer", and big hammer, I was aware of this from the onset, they fit a 2.0 with this intake no problems, but, the 2.5 is around 15mm taller than a 2.0, so "clearancing" was required  It "just" touched when test fitting, now, I have about 10mm of clearance  You cannot see where it was done, and so far, there's no contact when giving it the beans Happy days
    • It's been a while since I've updated this thread. The last year (and some) has been very hectic. In the second-half of 2024 I took the R34 on a trip through Germany, Italy, France and Switzerland - it was f*cking great. I got a little annoyed with the attention the car was getting around Europe and really didn't drive it that much. I could barely work on the car since I was living in an inner-city apartment (with underground parking). During the trip, the car lost power steering in France - split hose - and I ended up driving around 4,000kms with no power steering.  There were a few Nurburgring trips here and there, but in total the R34 amassed just shy of 7,000kms on European roads. Long story short, I broke up with the reason I was transferred to Europe for and requested to be moved back to Japan. The E90, loved it. It was a sunk cost of around EUR 10,000 and I sold it to a friend for EUR 1,500 just to get rid of it quickly. Trust me, moving countries f*cking sucks and I could not be bothered to be as methodical as I was the first time around.
    • I assume clearances were all a-okay?
    • Shock tower brace is in +5Kw....LOL  
×
×
  • Create New...