Jump to content
SAU Community

Recommended Posts

18's definitely. 19's in that style would look too big in my opinion.

18's would be lighter, therefore car will be slightly faster. 18's would have cheaper tyres, therefore more money in the bank for other modifications.

Link to comment
https://www.sau.com.au/forums/topic/213537-18-or-19-rims/#findComment-3772116
Share on other sites

The clearing of the calipers will depend on the spoke design. You can't rely on the offset to clear it.

Check out the wheel offset thread Sydneykid made. It's pinned so you can't miss it.

There should be a thread recently made in the suspension section or cosmetic section about what you want as well.

Link to comment
https://www.sau.com.au/forums/topic/213537-18-or-19-rims/#findComment-3774081
Share on other sites

You haven't said what you want to use the car for at any point. If you only want to use it on the street, and want it to look good, you can go 19's, but I reckon its too big anyway. If you are planning to do any form of motorsport, 18's would be a lot better. Remember, every mod should suit your application.

Link to comment
https://www.sau.com.au/forums/topic/213537-18-or-19-rims/#findComment-3779613
Share on other sites

the use would be daily drive, i think im going 18's, nicer drive, and suits the car more than most 19's (IMO) . also my dad rekons r33's were made when 19's didnt even exist or used much and it dosnt suit the car (thats just one persons oppionion dont take it to heart) when you see like an old hk monaro in 20's it dosnt look right, coz that car was brought out with like 13's

Link to comment
https://www.sau.com.au/forums/topic/213537-18-or-19-rims/#findComment-3782904
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Wife wanted basket things in the wardrobe in our temporary house. Thought about ripping our the wardrobe and fitting the entire IKEA set, but it's a temporary house and we want to move in a few years. So IKEA advertises this as a 50cm unit, however the actually basket and rails measure 46cm wide. Only issue was depth, IKEA stuff is quite deep, where as the builder special junk is super shallow at less than 40cm. Send it, chopped the rails, then offset the mounting holes, job done, happy wife, less shit scattered all over the bedroom. Did the same to the other side too. Also drove the Skyline shit box today, dropped off oil at Supercheap Auto. I didn't realise they only now take max 2x bottles per visit. I visited 2x Supercheap Autos.  
    • I've seen similar actually in my situation. You never know what tables are attempted to be used when the car thinks it's -99C or +200C. The fail state is not usually that extreme but you know what I mean - it was in my case though! This is where being able to read all the sensors is useful cause you see this stuff really quickly.
    • The above is very important. However as long as you keep timing relatively low, it's plausible to make your own knock ears and plausible to learn to tune with a modern ECU that can do wideband O2 correction like a boost controller. I mean if you only have one viable road to even drive the car on, learning to tinker to this level may be worth doing given you can't do much else with the car...?
    • I find the fact that the rear plate has to be bent inwards at the rear not so bad: but the front is just awful: It's like come on. (these are my very old, now retired/turned in plates) TBH it is a lot of money to fix a minor issue, the fact I said "I'll never really spend the money on doing this" is why people ended up buying them as a gift for a 'car guy' who can be hard to shop for.. for car guy things.
    • I just bent the ends of my premo plates. It even went through Regency like that after the engine conversion and the inspector (a great bloke!) just squinted his eyes and said "I didn't see that". Plates, and how they look, are just something that have zero importance to me.
×
×
  • Create New...