Jump to content
SAU Community

Greddy Profec B-spec 2 Boost Controller- Best Price!

Access Autoworks
 Share

Recommended Posts

Access Autoworks Rising Star

Access Autoworks

Posted
Posted

Greddy PRofec B-spec II

Features

- LCD screen to monitor boost pressures in real time

- Controlls boost up to 43.5psi (this may vary depending on turbo set up and system)

- 2 preset settings that can be selected by a single switch

- The response and the consistency of the boost can be adjusted by using the GAIN, START BOOST setting

- WARNING feature will alert the driver when the boost exceeds the set boost pressure with an alarm and a message in the display.

- When the WARNING feature is activated, the LIMITER feature can lower the boost to a safe pressure.

- PEAK boost feature will allow the user to check the highest boost recorded

English instruction manual included.

Comes with everything you need -

- Main unit

- Valve unit

- 4mm hose (2m)

- Valve unit harness (2.5m)

- Power harness (1.0m)

- 6mm hose (1m)

- M6 bolt x 1, Rubber washer x 2

- 6mm hose fitting x 2

- Hose clamp x 2

- Bracket, M4 bolt x 2

- 3 way fitting

- Double sided tape

- Air filter

profec1lw2.jpg

kitmw3.jpg

$425

  • 1 year later...
  • 1 month later...
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • MBS206
      NC MX5

      By MBS206 · Posted

      This sounds like someone who would have owned an R33 in their past... It's okay, I'm 100% picking up what you're putting down Mark.
    • MBS206
      Jacks that fit under GTR lips that can reach the subframe?

      By MBS206 · Posted

      Just back on what was raised about jacking off the the tow/tie down point on the front of cars. I've used it plenty. I've also watched it on a car where you could see it move the front end of the car. It was like the front end/whole car being tweaked and twisted a bit. I will say, I struggle to find good jacking points on MOST cars. The ones that have good points, I then normally struggle to find a jack tall enough to make the car change height!   One of my go to points for either the jack, or the axel stands though, is either a suspension pickup point, OR a subframe to chassis major bolting point. I actually think its the subframe on my R33 that has a bit of a bend in it, from being jacked in the middle too. However, it could have been one of my many other cars I've had over the years! Or it could also be the from me jacking it up, and the fact the top of the front radiator support isn't there, so it can allow the front of the car to move and bend etc.
    • GTSBoy
      M35 Aftermarket Fuel Pump

      By GTSBoy · Posted

      My apologies. I forgot we were talking about weird beard M series stuff. Had been talking elsewhere with someone about an R33 with similar subject and got confused.
    • The Bogan
      NC MX5

      By The Bogan · Posted

      Nope, I don't like the look of ND RF, or any ND really, I don't like their faces or arses, why, because of their "modern" lines, the NC, whilst "modernish" has a more rounded shape that I like Well, that's how my overly judgemental eyes see it anyway  
    • Dose Pipe Sutututu
      M35 Aftermarket Fuel Pump

      By Dose Pipe Sutututu · Posted

      Should be more than fine, especially the overall fuel pressure would never exceed 3.5bar (assuming that thing never gets more than 0.5bar of boost in stock form). According to the chart, it's 11amps.
×
×
  • Create New...