Jump to content
SAU Community

Recommended Posts

  • Replies 51
  • Created
  • Last Reply

Top Posters In This Topic

I am not getting into ANOTHER "east side ppl are too lasy/tight to drive their cars!" arguement ;)

I chose Westgate bridge, as it is central to most people. Some of us (low-lux, etc.) has to come from sunbury which is almost an hour drive to the westgate! I wouldn't want to make him, or others, drive 1.5-2 hrs just for a general meet.

Funky: Where is this "usual" spot you mentioned? Have you been cruising/meeting with you imaginary friends again?:)

Link to comment
https://www.sau.com.au/forums/topic/21593-weekly-meetup/#findComment-457909
Share on other sites

Alright to be fair, I voted Albert Park. Than we can play Schumacher afterward hehe.

I think the location is pretty good too for cruise as it is close to Princess for any cruise in the SE, E and is not that far from Westgate as well.

Pretty central and not in the heart of the City. But don't know of any big carpark thu.

Link to comment
https://www.sau.com.au/forums/topic/21593-weekly-meetup/#findComment-458032
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...