Jump to content
SAU Community

Recommended Posts

NO!!

they are good for popping airbags. think there are 8 or so on these so I would only use a meter in them. if it is a LED one then that is a different story. still prefer a meter.

jon,

I'm bored so I'm tearing yours to bits.

Dammit! I'll leave it to you then. I can't wait to hear the result....

  • Replies 44
  • Created
  • Last Reply

Top Posters In This Topic

NO!!

they are good for popping airbags. think there are 8 or so on these so I would only use a meter in them. if it is a LED one then that is a different story. still prefer a meter.

jon,

I'm bored so I'm tearing yours to bits.

Cool...hope you find more cool stuff! The G35 guys keep on talking about their remotes ability to wind down all four windows by just pressing the unlock button 3 times and holding it...I tried but no dice...

partial PDF from the 05/06 service manual.

that is relevant to what we are talking about.

its missing a relay so the whole concept of adding a switch is a myth. there is more to it that that. I would say: fuses,relays, switches,seats.

I'll know more over the next day or so.

jon,

you may want to stay away for a few days whilst I find this missing relay :)

g35sedan_heatedseat.pdf

Ok my 04 coupe is a 70th and has the seat warmers,

you can push the switches up or down, what is the difference ?

up is for high heat, down is for low

as in the thicker and longer bar for up, and thinner and shorter bar down low

can you do us a favour and open you console and take a pic of where the wires go form the switches?

its as simple as

- pull down the plastic around the bottom of the shifter

- pop out the pin

- lift off the gearknob

- lift up the armrest

- then lift the console from where the switches are

this takes about 2-3mins and requires no screwdriver or anything

i would just like to see on a coupe where the wires go after they coem out of the switches

thanks mate!

Warren

warren,

easier way.

remove covers on seat bolts. remove 4x14mm bolts position seat so it lays back out of the way:(DO NOT DISCONNECT IT!)

look at 4 pin white plug in middle of seat. it has 2 wires: a heavy red and black in it for the seat power ONLY. IF it has 4 wires going THROUGH the plug into the seat itself then you have heated seats.

based on the 05/06 sedan passenger seat you will have a LT GRN/BLK & GRY/BLU in that plug from teh car side - those will match with the ones in the centre console

the car (in the case of the 05/06 sedan I have here) is set up for them its a case of swapping seats, adding switches and finding the relay and fuse for it.

jon,

yours is wired for it but thats it.

Edited by Chris Rogers
  • 2 weeks later...

just to update this..

i have found a company that sells carbon fibre heating elements

http://www.heatedseatkits.com/index.html

costs $180 for the pair for front seats

they are OEM items in many cars in the USA..

and i've also recieved my heated seat switches from the G35 :)

so once my exams are over, my plan is to find out if i have the heating elements or not, and if i don't i'm going to look at getting a set of heating elements and wiring them up using the stock switches to control it

it should suit those cold summer mornings just fine!

haven't checked as yet..

i'm studying for exams which are on friday which means i can procrastinate all day on the computer and be guilt free (as my notes are open in an adjacent window), but if i leave the vicinity of my computer/books (ie to go to the car) i get massive guilt about not studying..

i know i'm weird

i will check for the wiring before i think about getting any elements though

Just noticed my car has rectangular marks where the heated seats buttons should be. Seems to be a lump there on both sides of the console. Does anyone else have this? Looks kinda dodgey.

yes I have these too.

Unless the vehicle is equiped with heated seats there will be covers in place of the switches. So 99% of 35's will have these covers.

on some of them the covers are knockouts. in the case of warrens car they are visible but not punched.

warren,

re: question - yes.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • For these last 7 years of ownership, I've always had to use a small scissor jack under one of the front tow hooks to raise the front just enough so my low-profile jack fits under to reach my subframe jack point. I'm beginning to get annoyed of always having to do this. Are there any lower low-profile jacks that fit under the gtr lip on a dropped car?
    • Seat of the pants assessment of the new intake: The car is way less "doughy" when hitting the loud pedal, especially off idle when stopped or in traffic, I did use a cheapo lazer thermal thingo to measure the temp around where the pod filter got its air, it was between 55 - 60°C, in saying this the car was shut off and not moving, so the OEM intake pipe was not supplying any fresh air to where the pod was when the car was at least moving A weird bonus was induction noise on the throttle in the cabin increased a bit,  I was worried that I was actually going to lose some of that induction noise I love so much, outside though, when I got the daughter to do a WOT drive by pass for me, the induction noise has increased alot when on the throttle, not quite ITB doort, but well up there I'm extremely happy with the results and have been exploring the country roads in the region  As for house mods: 1.New front fence is up and is awesome, it really upgraded how the joint looks from the street, and the added security is nice 2. Electricians have replace some interior lights, and with more lighting in the garage, a few new motion detecting lights out the front above the garage, front room, and at the front door, which I have already found heaps helpful coming and going, also now has fancy pants CCTV all round the house The only hold point for power though is the solar and batteries due to supply issues, although this will happen over the next few weeks 3. I have done a heap of landscaping out the front and I'm almost ready to do a new small retaining wall with some nice blocks to replace the brick and cemented in rocks around the raised garden beds cemented in river stone "was the fashion at the time" the house was built. I currently have a pallet of retaining wall blocks and 2 bulka bags of 20mm blue metal to replace the wood chip that is in the raised garden beds around the house 4. I now have 3 big raised garden beds for out the back to grow some vegetables, about 70cm high, 200cm long and 100cm wide 5. My 2 compost bins are already pretty full with brown, green and kitchen waste from the landscaping I'vedone so far, but they will probably take a few months to break down, so anything else that gets chopped, trimmed, and kitchen waste will just start filling the base of the raised garden beds to about 30cm before I start throwing 40cm of good compost, and stuff, for the vegetables to grow in, I'll need a few ton of compost and soil, but the local supplier can sent me bulka bags of the stuff Basically the logs, wood chips and a few strategically placed rocks for drainage, will give the beds some good organic materials down low to break down over time, and they will hold moisture during the warmer months to save the water in my big arse water tank if we don't get alot of rain So, all in all, the car and house mods are going well, and I'm really enjoying being retired, I sleep in too 0700 and slowly plod around inside until I feel like actually doing anything, and only work in the yard for as long as want, which has actually been alot over the last few weeks,  although when you look at it, it seems that not a huge amount of work has been done,  until I look at the before I started the work pics Happy days and good times indeed 
    • hahaha yeah. Plan is to get side skirts and probably just rear pods. But going to do them one-by-one. I've got a set that I really like from RHDJapen, but that one isn't shipped to AU. So need to find someone who can get it for me
    • Here's an idea, answer the questions I asked you as they are trying to work out WHY the LSD will be binding up in a straight line.
×
×
  • Create New...