Jump to content
SAU Community

Recommended Posts

ok basically i got a 96 r33 gtst with the following mods

-hi flow turbo on 13 psi (no after market engine management - stupid i know)

-hks pod with metal intake

-splitfire coils

-cooler

-split dump to 3 inch straight through exhaust

-hks adjustable wastegate - no other form of boost control

thats about it, i use redline 10W40 engine oil as recommended by redline reps and a known redline distributor here in perth,

my oil shows full on the dipstick and basically i drive about 60km to and from work everyday with a bit of foot down action here and there!, by the end of the of the working week the oil is down to low on the dipstick, just wondering why this is happening?? should i change to a different type of oil, but if i do change, why only is it burning now after never burning any in 2 years?

any help would be great :blink:

Link to comment
https://www.sau.com.au/forums/topic/219568-my-rb25det-burning-oil/
Share on other sites

well check for obvious leaks.. look at the sump bolt, check the oil filter, wipe it with a rag, then check again in a day, does the oily goo come back?

are you checking the level at the same engine temp each time? does your oil pressure vary? leak marks on the driveway where you park ?

does it blow smoke ?

there isnt a single drop of oil any were, iv just gone and checked all things from were a leak could be, i check the oil when the car hasnt been running for a while and always on a flat surface in my garage, my oil pressure gauge has never shown anything unusual,

it does blow out what appears to be black smoke in the high revs wen i am giving it sh*t but every one says that it is just unburnt fuel because my car is running a bit on the rich side, the guy that did my dyno runs also said its unburnt fuel.

any signs of oil near the turbo? like the seals could be shagged or something, but thats a lot of oil to leak out the seals

what about the cooler pipes etc, do you see any signs of oil in there, undo one of the silicon joiners and check

again high unlikely you are loosing that much oil from say the turbo seal, but at least rule it out

Something isnt right, if your losing that much oil over 60km then you would surely be driving around with white/blue smoke poring from the exhaust everywhere you go, either you are checking your oil level incorrectly (allthough i dont see how anyone could get that wrong) or you have a mojor leak that you havent found yet, even though you have said you have checked everything, have you actually jacked the car up and had a look underneather it?

ok just took one of the cooler pipes off, 100% clean inside, no signs of sludge or anything in there, the egin bay is squeaky clean of any oil etc, iv just looked under and all through the engine bay again and there is nothing, also i change the oil very regularly so its always been very clean but lately the oil goes pitch black after a week, sort of looks like the oil has never been changed,

im def checking the oil properly and also the guys at work have also checked, aswell as my boss, its been happening for the last 3 weeks, iv just been topping it up, i think the next step is to take it to a workshop and see whats happening, hopfully nothing too serious :blink:

even the guys at work have been saying its very strange

ok just tried something that got suggested to my, i started my car, put a card board box about half a meter behind the exhaust and revved it to about 3000rpm a few times, looked at the cardboard box and has black shit all over it with the consistency of water, something is f*kked lol, but car still boost hard all the way to redline tho??

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • looking for some help and maybe some insight on others experience with a new LSD. R34 GT ran and drove beautifully, but always alot of grip loss due to the open R200 rear end, so I just installed a new 1.5 LSD way into the stock open R200 for a ER34. Simple. Everything seemed right. I test drove for the first time this weekend. as I started to back out the garage the first time slowly with tires straight it sounded and felt like I had a loose or half disconnected drive shaft...that was clucking around loose and shaking entire vehicle, and making it feel like the trans clutch was spontaneously slipping then grabbing very roughly while just letting out pedal slowly. I backed it out went to pull forward with the same noise, shake and slip grab feeling with hesitation, I turned the tires to back out more and then pulled ahead some same thing but worst because of added wheel resistance (which that I expected) puzzled … pulling it back in checking everything over and finding nothing wrong, I tried it the next day. same thing, couldn’t believe how it shook everything again making a terrible noise and making it feel like the trans clutch was slipping and grabbing, but I got it out of garage into the driveway, got it straight, drove forward and then reveres a few times in a straight line everything shaking , causing what felt like clutch slip and grab every time, sounded like right behind front driver tire and I could feel it in the floor board with my feet,... worst right when beginning to let clutch pedal out to engage slightly, shuttering and sounding terrible along the way…I managed to slowly get down the road, babying it the whole way, once I was rolling (out of 1st) seemed to be better and between shifts, then clutch felt closer to normal…not slip/ grab etc., but back down to any stop, straight road or turning, same thing. Made no difference if all tires were straight or if I was turning. All other gauge read out correct. with in 2 miles as planned I reached the empty parking lot and performed the break in procedure that came with lsd, essentially to drive in a figure 8 a bunch.  Did this, binding chattering, and shaking the car the whole way. I drove it back home seemed somewhat normal once I was in straight line and past 10 mph or so, and I know it will “bind” on corners and cause some tires squeal when turning especially from a stop, but when I begin to move it still causes what feels like the trans clutch to slip and jerk badly as well as shaking the entire car, and sounds terrible, that I didn’t expect. I used the fluid they supplied with LSD kit and did the breaking, planning to change fluid as they suggest after breaking, but wondering will it get smoother or less aggressive with use? maybe a 1.5 is just too aggressive for normal road driving?   I have a LSD that I put in my 71 cuda when I restored it, with amazing smooth , quite yet effective results. Different style LSD but that ones a joy to drive. maybe expecting too much from this R200?
    • Join SAU NSW for a flame-grilled feed & flame-spitting cruise! Sunday 17th August 2025 3:30PM Meeting Archies Flame Grille Sylvania Waters 4:45PM Cruise Departure 5:15PM Arrival at Cape Solander Kurnell Meet Location: Archies Flame Grille Final Destination: Cape Solander Kurnell *Disclaimer* There will be a lead and follow car so no one should get lost. If you would like to attend or bring others along please put your name down and a +1 as numbers will be needed prior! This is NOT a race and we will all be adhering to all road rules. If this is what you want please come to one of our many track days. This is an official SAU:NSW event and will be run under a CAMS permit. One of the things that really sets our club apart is our commitment to being true enthusiasts. When on normal roads we strive to maintain good relations with the authorities as well as the public in general. When attending one of Skylines Australia NSW events please try to: • Be aware of surrounding environment and act accordingly. • Drive courteously on the state’s roads as a true enthusiast should. • Understand how important it is to maintain the good name of SAU NSW and thus, treat others accordingly. • Any misbehavior will not be tolerated and you will be asked to leave.
    • Yeah good luck out there! Will be good to see a mighty GTST going harder than the GTRs
    • i will be there 😁
    • Hello!  i just finished manual swaping my r34 skyline with a r33 rb20de box(RB71C)box  When the car is running it squeaks crazy loud and it was smoking from the gearbox area. The gearbox is fine it was tested. The clutch slave cylinder seems like it doesn't fully releases the clutch. I want to ask if this noise is from the throw out bearing or could it be the clutch assembly or disk att.xFliq87Gzw6kImKBVqDebXkj0fBqymk0JaYeP3_3SlM.mp4
×
×
  • Create New...