Jump to content
SAU Community

Recommended Posts

Item:

17 inch wheels

Location:

Brisbane Southside

Item Condition:

Great

Reason for Selling:

stick out too much on the rear

Price and Payment Conditions:

$1600 or swap for other wheels

Extra Info:

2 tyres are a few months old, but two others will need replacing

Contact Details:

0403 437 653 or pm

post-21729-1211171472_thumb.jpg

post-21729-1211171497_thumb.jpg

post-21729-1211171530_thumb.jpg

post-21729-1211171556_thumb.jpg

post-21729-1211171579_thumb.jpg

Link to comment
https://www.sau.com.au/forums/topic/219878-17-inch-wheels-for-sale/
Share on other sites

  • 2 weeks later...
  • 2 months later...

hey if your looking to change your wheels, i just bought a 33 gtr with 8 inch wheels and will probably be looking for 9 inch. they are silver OZ racing and the tyres are new falken 245/45/17.

i can't get the only pic i have to upload so if your interested email me at [email protected] and i'll send it to you.

  • 2 months later...

still got them, but sold my spare wheels, so unless you got some wheels to do a direct swap, can't really sell them

stretched some smaller tyres on these ones and they fit a lot better

still got them, but sold my spare wheels, so unless you got some wheels to do a direct swap, can't really sell them

stretched some smaller tyres on these ones and they fit a lot better

i still want to swap you, if you like white rims :P

  • 1 month later...
  • 1 month later...
  • 1 month later...
  • 1 month later...


  • Similar Content

  • Latest Posts

    • The final part arrived today to un-clampify and simplify the intake Who would have though a 1/2" hose stainless bulkhead fitting designed for below waterline bilge pumps would be what I needed Test fit on a 3" offcut I had laying around to see if it would work, and it worked a treat All going well the intake will be on its "final version" tomorrow 
    • Good luck on the weekend mate
    • Must have been an absolute nightmare to drive when the power steer was out, the rack ratio/wheel size/caster is all set up for power assistance
    • Welcome to SAU, what are you looking at buying?
    • I checked the injectors again (1 and 2, since they’re easiest to access) to make sure they weren’t clogged. Even though the entire fuel system had been cleaned, I wanted to be certain. Everything looked clean, so I reinstalled and connected everything. When I started the car to confirm everything was okay, it immediately revved up high, so I shut it off straight away. I checked to see if I’d missed a vacuum hose or something, but everything was connected. On the second attempt, the car ran without the high idle, but I noticed a distinct “compressed air” sound coming from the engine bay. Tracing the sound, I pushed injector #6 forward slightly and the noise stopped — it turned out it wasn’t seated properly, despite the fuel rail being bolted down. While holding it in place, the car idled steadily without stalling and ran for over 5 minutes. At this point, I pulled all six injectors out just in case I hadn’t seated them correctly or dirt had gotten onto the O-rings. Unfortunately, I discovered that I had damaged 3 out of 6 injectors (the OEM 270cc ones) during installation. So yes, this was my fault. Since only the pintle caps were damaged, I’ve ordered a Fuel Injector Service Kit from NZEFI to refurbish them. In the meantime, I reinstalled my new injectors – the car now idles fine for over 15 minutes without stalling. I have not attempted to drive it so far. It’s not perfect yet, as it hesitates when the throttle is pressed, but it’s a big improvement. Unplugging the IACV with the new injectors idles at around 800rpm, even with the IACV screw tightened fully. But this is probably due to tune.
×
×
  • Create New...