Jump to content
SAU Community

Recommended Posts

Hey people

My specifications of my car are listed below

My car after getting its new-found power has beeen buring oil alot

I had a perfect compression before the upgrade of all 155psi

At first it was running Full synthetic ROYAL PURPLE 10W-40W.... and that will only last Max 2000km

Now im running PENRITE HPR 30 20w-60w and the Not bad but still my catch can is spitting out.

Am i using the wrong oil or do i have an engine problem

It usually does the damage when @ high revs

Now what might the problem ?????

cheers in advanced

Link to comment
https://www.sau.com.au/forums/topic/220064-oil-problem/
Share on other sites

hrmm, standard engine? yes you will have to get used to it. unless you replace the pistons. you have got ring flutter. very common on engines with "factory ring gaps"

unfortunatly not much you can do. just get a custom catch can made that drains back to the sump.

no matter what oil you use it will come out. have you checked the compression latly? doesnt take much to crack a ring land on the initial tune following the mods.

also, check the turbo. i have seen worn bearings in them alow boost to leak past the compressor wheel and presurise the sump..

(happenend to me, filled the can in 5 mins up the old road once)

Link to comment
https://www.sau.com.au/forums/topic/220064-oil-problem/#findComment-3880886
Share on other sites

Nice........... I hear a slap...i think it is from the Timing belt

i know that need to be replaced

These catch can the return oil to the sump................ where can purchase these catch cans

Link to comment
https://www.sau.com.au/forums/topic/220064-oil-problem/#findComment-3881014
Share on other sites

I'm not sure thats good advice? I have 314rwkw on stock internals, and same turbo. I don't even have a catch can, and I don't burn a single drop of oil. Mate, whever tuned your car might have done it too agressively now its stuffed a ring land.

The catch can back into the sump idea is also a bad one, as that oil is trashed and shouldn't be used again. I'd do a compression and leak down test, and start putting aside about $4k for a rebuild just in case. Also

Also, I've been running Shell Helix 5w40 for the past 3 years and it seems to be really good as I have almost no engine wear. All of these expensive oils seem to be a bit of a waste to me.

Link to comment
https://www.sau.com.au/forums/topic/220064-oil-problem/#findComment-3881259
Share on other sites

I'm not sure thats good advice? I have 314rwkw on stock internals, and same turbo. I don't even have a catch can, and I don't burn a single drop of oil. Mate, whever tuned your car might have done it too agressively now its stuffed a ring land.

The catch can back into the sump idea is also a bad one, as that oil is trashed and shouldn't be used again. I'd do a compression and leak down test, and start putting aside about $4k for a rebuild just in case. Also

Also, I've been running Shell Helix 5w40 for the past 3 years and it seems to be really good as I have almost no engine wear. All of these expensive oils seem to be a bit of a waste to me.

Sounds like Right.............. Mafia im still running off a stock manifold too

The oil in the catch can looks pretty clean man......i dunno what going on

4k for a rebuild you sure............bel garage said about 7k without the manifolds

BTW penrite hpr 30 only cost $28 for 3L

Link to comment
https://www.sau.com.au/forums/topic/220064-oil-problem/#findComment-3881741
Share on other sites

hrmm, standard engine? yes you will have to get used to it. unless you replace the pistons. you have got ring flutter. very common on engines with "factory ring gaps"

unfortunatly not much you can do. just get a custom catch can made that drains back to the sump.

no matter what oil you use it will come out. have you checked the compression latly? doesnt take much to crack a ring land on the initial tune following the mods.

also, check the turbo. i have seen worn bearings in them alow boost to leak past the compressor wheel and presurise the sump..

(happenend to me, filled the can in 5 mins up the old road once)

did u notice any noise with the worn bearings in the turbo?

Link to comment
https://www.sau.com.au/forums/topic/220064-oil-problem/#findComment-3894362
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Seat of the pants assessment of the new intake: The car is way less "doughy" when hitting the loud pedal, especially off idle when stopped or in traffic, I did use a cheapo lazer thermal thingo to measure the temp around where the pod filter got its air, it was between 55 - 60°C, in saying this the car was shut off and not moving, so the OEM intake pipe was not supplying any fresh air to where the pod was when the car was at least moving A weird bonus was induction noise on the throttle in the cabin increased a bit,  I was worried that I was actually going to lose some of that induction noise I love so much, outside though, when I got the daughter to do a WOT drive by pass for me, the induction noise has increased alot when on the throttle, not quite ITB doort, but well up there I'm extremely happy with the results and have been exploring the country roads in the region  As for house mods: 1.New front fence is up and is awesome, it really upgraded how the joint looks from the street, and the added security is nice 2. Electricians have replace some interior lights, and with more lighting in the garage, a few new motion detecting lights out the front above the garage, front room, and at the front door, which I have already found heaps helpful coming and going, also now has fancy pants CCTV all round the house The only hold point for power though is the solar and batteries due to supply issues, although this will happen over the next few weeks 3. I have done a heap of landscaping out the front and I'm almost ready to do a new small retaining wall with some nice blocks to replace the brick and cemented in rocks around the raised garden beds cemented in river stone "was the fashion at the time" the house was built. I currently have a pallet of retaining wall blocks and 2 bulka bags of 20mm blue metal to replace the wood chip that is in the raised garden beds around the house 4. I now have 3 big raised garden beds for out the back to grow some vegetables, about 70cm high, 200cm long and 100cm wide 5. My 2 compost bins are already pretty full with brown, green and kitchen waste from the landscaping I'vedone so far, but they will probably take a few months to break down, so anything else that gets chopped, trimmed, and kitchen waste will just start filling the base of the raised garden beds to about 30cm before I start throwing 40cm of good compost, and stuff, for the vegetables to grow in, I'll need a few ton of compost and soil, but the local supplier can sent me bulka bags of the stuff Basically the logs, wood chips and a few strategically placed rocks for drainage, will give the beds some good organic materials down low to break down over time, and they will hold moisture during the warmer months to save the water in my big arse water tank if we don't get alot of rain So, all in all, the car and house mods are going well, and I'm really enjoying being retired, I sleep in too 0700 and slowly plod around inside until I feel like actually doing anything, and only work in the yard for as long as want, which has actually been alot over the last few weeks,  although when you look at it, it seems that not a huge amount of work has been done,  until I look at the before I started the work pics Happy days and good times indeed 
    • hahaha yeah. Plan is to get side skirts and probably just rear pods. But going to do them one-by-one. I've got a set that I really like from RHDJapen, but that one isn't shipped to AU. So need to find someone who can get it for me
    • Here's an idea, answer the questions I asked you as they are trying to work out WHY the LSD will be binding up in a straight line.
    • You haven't driven many modern cars then have you? Most of them have sfa steering feel with their stupid electric bullshit steering systems.
×
×
  • Create New...