Jump to content
SAU Community

Recommended Posts

any engine will knock, whether it is PFC or stock ECU........ i would worry too much about it, a friend's R34 did that as well and he never mention anything about being worried about it, but if in doubt get it checked out by your mechanic/dyno dude :rolleyes:

any engine will knock, whether it is PFC or stock ECU........ i would worry too much about it, a friend's R34 did that as well and he never mention anything about being worried about it, but if in doubt get it checked out by your mechanic/dyno dude :)

lol no, only a PFC will trigger the CEL for engine knock, the stock ECU will not display the CEL if there is any knock detected....would be great if it did :rolleyes:

If it was a brief flash 9/10 it's the O2 sensor, if it goes on an remains on, most likely coil packs..run the diagnostic to be sure.

Paper clips at the ready!!!!!

As the document says, turns the ignition to "on" short the two terminals indicated on the consult plug (clipped covertly on the underside of the dash near where your right knee lives), count the flashes, look up the code

diagnostic.doc

Thanks Dan lol

  • 4 weeks later...

Hi all just to clarify... This happened to me today. The engine light turned on and stayed on after 10 minutes of driving. I didn't feel any change in the engine etc. car felt as usual no hesitation, shakes or missfires.

I pulled over waited a few seconds and restarted - engine light was off and never came back on.

I guess i'll have to drive the car more and observe if the issue comes back.

My car is an r34 non-turbo auto btw.

What is the consensus on this? Bung sensor or coilpacks about to give out or ecu glitch (if that even happens)???

Hi all just to clarify... This happened to me today. The engine light turned on and stayed on after 10 minutes of driving. I didn't feel any change in the engine etc. car felt as usual no hesitation, shakes or missfires.

I pulled over waited a few seconds and restarted - engine light was off and never came back on.

I guess i'll have to drive the car more and observe if the issue comes back.

My car is an r34 non-turbo auto btw.

What is the consensus on this? Bung sensor or coilpacks about to give out or ecu glitch (if that even happens)???

Definately coil packs, fitted Splitfires and iridium plugs to mine today. My engine light had been on for a week and a half but like yours had not yet shown any signs of hesitation or missfiring yet. Just ran the engine, no engine light on and appears to be running much smoother and cleaner than before.

Splitfire coilpacks, part# SF-DIS-008, Brought them from CRD in NSW for $510 delivered, awsome service as they arrived a day and a half after payment.

NGK Iridium spark plugs BKR5EIX-11 $90

Also have NA R34 Good luck, Nath.

post-26384-1220085513_thumb.jpg

this happened to me, engine light came on and it dropped a cylinder, car would shake quite a bit, so i unplugged the coilpack plug, replug back in and the shaking went away.

pin pointed it down to the one SOB coilpack so i replaced that.

hopefully its fixed now as i only did it 2 days ago but so far so good, the light would come on intermittently, sometimes it would last a week without issues or maybe a day... but then in future if more packs let go, its time for splitfires.

  • 2 weeks later...

My engine light came and and I got a service they hooked up the Nissan computer but they couldn't find the problem. I rang Power Road car sales where i bought my R34 Gt from and they identified the problem by just me explaining it over the phone.

I just got a new coil pack installed by them today, costing 240, (130 for the coil pack form Nissan) They also claim to have a machine that tells them which coil pack is playing up.The car runs smooth now, but my engine light is still on. I was told that the computer needs resetting, but I would have thought that the light would switch its self off once the problem is solved.

Does any one know how to reset computer or do i need to take the car to a specialist?

^ dc the battery, step on brake a few times to compeltely drain the power.. wait a few mins, connect battery back up & thats it.

but after u change the coilpack, u turn it off and then turn it back on and the engine light should go away.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • The incentives are mostly the same, yes. Ethanol is cheap compared to the cost of doing 98-100 RON with crude oil alone. 87 to 93-94 AKI all with E10. In 2020 Canada mandated E10 as a part of their "renewable fuel standard" and is supposedly going to go to E15 in 2030. In California where there are only 8 refineries with two threatening to shut down next year it's been over 20 years now of E10 and 91 AKI maximum because there's just not enough refinery capacity or crude oil supply relative to the demand for premium unleaded fuel. And CARB's low carbon fuel standard means functionally none of the diesel available at the pump is made from crude oil anymore. It's almost all entirely 20% biodiesel blended with 80% renewable diesel (hydrotreated vegetable oil) now. The number of gasoline vehicles that support E15 or higher ethanol concentrations is surprisingly low, I can't imagine it being wise to play tricks like this without flex fuel sensors in most of the fleet.
    • It's almost certainly the same as the one next to it. Have a fish around amongst these hits https://www.google.com/search?q=surface+mount+transistor+m33&sca_esv=9cb49794e0b2005d&source=hp&ei=2vJ5aNjTB7Kw0PEPldnS8QM&iflsig=AOw8s4IAAAAAaHoA6qkfmF6XcygtrZ4Vu9f92NXF_RFd&ved=0ahUKEwjYqIPP7MWOAxUyGDQIHZWsND4Q4dUDCA8&uact=5&oq=surface+mount+transistor+m33&gs_lp=Egdnd3Mtd2l6IhxzdXJmYWNlIG1vdW50IHRyYW5zaXN0b3IgbTMzMgUQIRigATIFECEYoAEyBRAhGKABMgUQIRigAUjKCFAAWABwAHgAkAEAmAHfAaAB3wGqAQMyLTG4AQPIAQD4AQL4AQGYAgGgAuYBmAMAkgcDMi0xoAfMBLIHAzItMbgH5gHCBwMyLTHIBwU&sclient=gws-wiz
    • South Australia, which is hardly as far behind as the rest pf Oz makes out, and who is also not a paragon of progressiveness (read that as over-legislation) in the area of vehicle standards, has this to say on the subject: Adjustable coil-over suspension Aftermarket adjustable coil-over suspension components are suspension units that incorporate an external thread on the main body and corresponding threaded spring saddle that allows the vehicle's suspension height to be varied. If fitting aftermarket or coil-over suspension components you must submit an Application to modify a light motor vehicle form and a report from a light vehicle engineering signatory (LVES).
    • Hi all, Long time since I've posted here. Looking for some advice on what I can remove to further identify the cause of my issues.  I can move the passenger seat forward and back but the knob used to adjust the seat angle is pretty much free spinning, there's very little resistance.  Removing the side cover I can see that the chain is intact but the shaft for the adjustment spins without the gear attached to it moving.  What's my next step for disassembly here? Is this a common fault? Just being a little cautious as I didn't want to start removing bolts for a spring to fly out or something equally as stupid.  Cheers
    • Those above shitboxes, mediocre and above usually have a turbo strapped to them, hence the slightly higher octane is required.  
×
×
  • Create New...