Jump to content
SAU Community

Recommended Posts

gtsii, I personally wouldn't buy one, as a number of people here have had major issues with there's due to it's inability to change the timing with load. Yes it will give you more power, but at what cost? A few engine rebuilds have been the result here:(

They are 2 dimensional only, adjusting timing at various rev ranges.

As GTS-t VSPEC says, they make no account for engine load (measured by AFM voltage in the case of a PFC).

I've found pinging to occur over a similar rev range but only under certain load condidtions (mainly coming on boost in higher gears).

With the ITC you either have to be real conservative and dial out timing across this rev range, which means that you lose a lot of punch in 1st and 2nd gears, or risk damaging your motor.

Your call, but personally I wouldn't risk it.

It won't do you any good because you're still running a stock cooler.

If you advance the timing on it it'll be good for all of about 15 seconds and then it will ping it's f*%king head off (literally) once the cooler soaks up the heat.

As with most gizmos that screw with the ecu's imputs, including SAFCs, boost cut defenders and ITCs, you can make some decent performance gains. The downside is that there is no real mechanisim programmed into the things for fluctuations of the input parameters after the initial setup.

Basically what I'm saying is that there is a performance gain to be had but dont get greedy. Set it up on a dyno in the first place and don't go looking for maximum outright power figures. If it starts to ping on the dyno and you only turn it back slightly you can pretty much garantee that it will ping like crazy on a hot day in traffic.

Adjust it in small increments and you will be happy with the results. Go crazy and you'l blow a hole in the top of a piston.

Dave

Guest RedLineGTR

The Super ITC adjusts ignition timing by +/- 15% by modifying the crank/cam angle signal on certain vehicles. The timing curve is adjusted by setting the timing at 5 different points along the RPM range and the values between are interpolated by the ITC from those 5 points. The Super ITC used in conjunction with the Super AFC fuel controller creates a new dimension of tuning with piggyback computers. Apexi recommends having the Super ITC installed and tuned by authorized shops

They're pretty old. The old SAFC's (like 1st and second generation) looked very similar.

I remember reading about an engine swap, SR20 into a stanza or something where they used both an SAFC and ITC but at the time they were about 700 each so I couldn't fgure out why they didn't just get a microtech or something fo the same money.

They'll do the job but I still say be very careful.

Hey redline, did you cut and paste or do you really talk about new dimensions of tuning? :P

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • For these last 7 years of ownership, I've always had to use a small scissor jack under one of the front tow hooks to raise the front just enough so my low-profile jack fits under to reach my subframe jack point. I'm beginning to get annoyed of always having to do this. Are there any lower low-profile jacks that fit under the gtr lip on a dropped car?
    • Seat of the pants assessment of the new intake: The car is way less "doughy" when hitting the loud pedal, especially off idle when stopped or in traffic, I did use a cheapo lazer thermal thingo to measure the temp around where the pod filter got its air, it was between 55 - 60°C, in saying this the car was shut off and not moving, so the OEM intake pipe was not supplying any fresh air to where the pod was when the car was at least moving A weird bonus was induction noise on the throttle in the cabin increased a bit,  I was worried that I was actually going to lose some of that induction noise I love so much, outside though, when I got the daughter to do a WOT drive by pass for me, the induction noise has increased alot when on the throttle, not quite ITB doort, but well up there I'm extremely happy with the results and have been exploring the country roads in the region  As for house mods: 1.New front fence is up and is awesome, it really upgraded how the joint looks from the street, and the added security is nice 2. Electricians have replace some interior lights, and with more lighting in the garage, a few new motion detecting lights out the front above the garage, front room, and at the front door, which I have already found heaps helpful coming and going, also now has fancy pants CCTV all round the house The only hold point for power though is the solar and batteries due to supply issues, although this will happen over the next few weeks 3. I have done a heap of landscaping out the front and I'm almost ready to do a new small retaining wall with some nice blocks to replace the brick and cemented in rocks around the raised garden beds cemented in river stone "was the fashion at the time" the house was built. I currently have a pallet of retaining wall blocks and 2 bulka bags of 20mm blue metal to replace the wood chip that is in the raised garden beds around the house 4. I now have 3 big raised garden beds for out the back to grow some vegetables, about 70cm high, 200cm long and 100cm wide 5. My 2 compost bins are already pretty full with brown, green and kitchen waste from the landscaping I'vedone so far, but they will probably take a few months to break down, so anything else that gets chopped, trimmed, and kitchen waste will just start filling the base of the raised garden beds to about 30cm before I start throwing 40cm of good compost, and stuff, for the vegetables to grow in, I'll need a few ton of compost and soil, but the local supplier can sent me bulka bags of the stuff Basically the logs, wood chips and a few strategically placed rocks for drainage, will give the beds some good organic materials down low to break down over time, and they will hold moisture during the warmer months to save the water in my big arse water tank if we don't get alot of rain So, all in all, the car and house mods are going well, and I'm really enjoying being retired, I sleep in too 0700 and slowly plod around inside until I feel like actually doing anything, and only work in the yard for as long as want, which has actually been alot over the last few weeks,  although when you look at it, it seems that not a huge amount of work has been done,  until I look at the before I started the work pics Happy days and good times indeed 
    • hahaha yeah. Plan is to get side skirts and probably just rear pods. But going to do them one-by-one. I've got a set that I really like from RHDJapen, but that one isn't shipped to AU. So need to find someone who can get it for me
    • Here's an idea, answer the questions I asked you as they are trying to work out WHY the LSD will be binding up in a straight line.
×
×
  • Create New...