Jump to content
SAU Community

Recommended Posts

While I haven't actually seen one I was aware of a factory five stud, four door, NA, R33 kicking around Hobart. It was recently for sale.

Also we can sit around and debate the kilometers all day but from the photos I've seen its in bloody good condition. So even if we ignore the kilometers question its certainly in "as new condition".

Short of going around to this blokes house and looking at the car ourselves, us keyboard warriors are going to wear our fingers out arguing here but what will happen is a new and potentially donating member will disappear off the face of the earth.

The skyline looks nice and clean. Congrats on the good buy de Powa.

  • Replies 42
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

cheers mate finally some1 that understands!!

a fellow series 2 4 door owner has proof that this is a factory 5 stud..

the non turbo series 2 was called the type x and the turbo 4 door was known as the type m-spec 2

i should have scanned copy of the brochure hopefully by tomorrow night!

Was talking about who would restore a non turbo r33?? but yea there is probably someone out there..

but thats a very nice gtr..

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
    • Bit difficult to follow. Have a look below and see what the standard R32 layout was like. Note there was a restrictor in place immediately before "turbocharged pressure control solenoid" that, if removed, magically got you 1 bar boost.
    • I might be way off the mark here.. there must be a T junction under the manifold. That takes manifold pressure through a check valve prior to the T, one side splits out to this bleed off orifice, the other straight to the wastegate actuators. 
    • Carrying out some engine due diligence before my first drive in a 260RS that has been in storage for 10+ years, and found two lines that are susposed to be plumbed into the boost control solenoid. One of the lines (the wastegate boost supply line) to actuate the gates, had a bolt in one end blocking it. The other line (main boost signal line) from the very rear of the intake manifold (RB26DETT) and runs up to the boost controller had this pill in the end of it as seen in photos. Other than the obvious (T28 Ceramic turbos might well be cooked)  Can anyone shed any light on if there is any validity at all with this mod, bleeding a constant fixed rate of manifold boost pressure off through this 3mm hole?  Is it deliberate?  Was this a 90s Jap mod done to RB26's? Or has someone just fitted this without any idea of what happens to ceramic T28s if they are not gate controlled?    
×
×
  • Create New...