Jump to content
SAU Community

It's Time To Party! - Tursday 2nd October - Great Northern Hotel Chatswood


Recommended Posts

Come and celebrate our birthdays at the Great Northern Hotel Thursday 2nd October from 7 - 7:30pm onwards. :/

Everyone is welcome to come along.

Don't forget your partay hats. :P:) Oh and hugs!

P.s you all better be there.. :dry:

* Chubbs +1

* Steveo

* - Sl!m (Haha!)

* Abo

thursday........ yeah probably won't be there sif do it on weeknight

ps. Corinne pls post in the appropriate section, this is an event. Dont make me report your thread to me. :thumbsup:

thursday........ yeah probably won't be there sif do it on weeknight

ps. Corinne pls post in the appropriate section, this is an event. Dont make me report your thread to me. :thumbsup:

Well.. you're ghay! I can't do it on the Friday because it's a long weekend.. and I'm going away. Durhhh!!!

Liz Jane and I are too cool for the events section. It's not an event.. It's a invitation. Plus who the hell is going to see it in the events section!

p.pp.s LIZ JANE IS GOING TO SHANK YOU IF YOU DON'T GO!

assuming we will be there..... no arm twisting required to get us to the northern... I miss living near there :(

Might drive zeddles for a change!!



  • Latest Posts

    • The final part arrived today to un-clampify and simplify the intake Who would have though a 1/2" hose stainless bulkhead fitting designed for below waterline bilge pumps would be what I needed Test fit on a 3" offcut I had laying around to see if it would work, and it worked a treat All going well the intake will be on its "final version" tomorrow 
    • Good luck on the weekend mate
    • Must have been an absolute nightmare to drive when the power steer was out, the rack ratio/wheel size/caster is all set up for power assistance
    • Welcome to SAU, what are you looking at buying?
    • I checked the injectors again (1 and 2, since they’re easiest to access) to make sure they weren’t clogged. Even though the entire fuel system had been cleaned, I wanted to be certain. Everything looked clean, so I reinstalled and connected everything. When I started the car to confirm everything was okay, it immediately revved up high, so I shut it off straight away. I checked to see if I’d missed a vacuum hose or something, but everything was connected. On the second attempt, the car ran without the high idle, but I noticed a distinct “compressed air” sound coming from the engine bay. Tracing the sound, I pushed injector #6 forward slightly and the noise stopped — it turned out it wasn’t seated properly, despite the fuel rail being bolted down. While holding it in place, the car idled steadily without stalling and ran for over 5 minutes. At this point, I pulled all six injectors out just in case I hadn’t seated them correctly or dirt had gotten onto the O-rings. Unfortunately, I discovered that I had damaged 3 out of 6 injectors (the OEM 270cc ones) during installation. So yes, this was my fault. Since only the pintle caps were damaged, I’ve ordered a Fuel Injector Service Kit from NZEFI to refurbish them. In the meantime, I reinstalled my new injectors – the car now idles fine for over 15 minutes without stalling. I have not attempted to drive it so far. It’s not perfect yet, as it hesitates when the throttle is pressed, but it’s a big improvement. Unplugging the IACV with the new injectors idles at around 800rpm, even with the IACV screw tightened fully. But this is probably due to tune.
×
×
  • Create New...