Jump to content
SAU Community

Recommended Posts

Item:R33 GTST S2 Front end, comes with Head lights in good condition, front bar with fog lights attatched and a Carbon fibre bonnet for S2 - the carbon fibre bonnet not in good condition but works normally

Age:unknown!

Condition:bar and lights good, bonnet average to bad condition but does the job!

Price:$1000 FIRM

To Fit:R33 GTST s1 or S2 (What car)

Location:Newcastle - PICKUP ONLY - can organise to be delivered close by for a price

Contact:Me 0412417579

Comments: Pics will not be available till the weekend. I WAS going to keep this for my car but i need some cash desperately, this front end was on a Series 1 but it is a S2 front end!

Item:RB25DET Engine

Age:13 years??

Condition:Good!

Price:$1100 !!!! CHEAP

To Fit:Anything :thumbsup: (What car)

Location:Newcastle NSW

Contact:ME 0412417579

Comments:This RB25DET has NO coilpacks (but can supply a set of S2 coilpacks and loom for a extra $100 and has NO turbo. It does have all the turbo lines and the inlet manifold is complete with throttle body and exaust manifold is there. I need this Gone ASAP as i need the money so its going for CHEAP - working engine, i have seen it running for a few hours before i pulled the car down and it did not blow any smoke ran properly etc etc.

Engine comes complete

Minus coil packs and coil pack loom

Minus Turbo

Harmonic balancer / power steering pump INCLUDED

Starter motor if you need one little extra (we can neg)

Inlet manifold side complete with throttle body and injectors & wire loom INCLUDED

Stock AFM & Pod filter INCLUDED

Take this off my hands and make some cash!

Item:R33 S1 steering wheel

Age:same as car

Condition:good

Price:$100

To Fit:r33 S1 (What car)

Location:Newcastle

Contact: ME

Comments:good condition wheel. $100 pickup only.

No time wasters please. this is going cheap as and won't last long so if your not sure don't bother me im busy!

Sorry forgot to mention, the altanator is included with the engine and the CAS is there as well as well as the engine harness.

Have a 3" turbo back exaust.

Includes dump pipe and front pipe (in one) and catco 3" cat and full exaust with big cannon on rear. looking at $400 for the LOT!!

If you are not able to get rid of it quickly would you consider separating and shipping the s2 front bar to Melbourne as that is all i need.

Please PM me if you happen to change your mind.

-Jack

not seperating anything. This needs to go as a whole. Ive seen front ends like this go for over $1500.

someone snap this shit up! make a decent offer

forgot to mention it ALSO comes with a S2 aftermarket grill, its a GTR one i think has a big area in the middle.

Would be keen to see pics of the front end!! has the bonnet just gone shitty an oxidized or is it actually damaged?

You sure you dont want to post? I could be up for a road trip though :cool:

i think the front end is sold. I am def not keen to post it. i just cannot possibly do it. sorry guys.

Surely someone wants a nice cheap RB25DET ? i know im going to regret selling this later!

Would be keen to see pics of the front end!! has the bonnet just gone shitty an oxidized or is it actually damaged?

You sure you dont want to post? I could be up for a road trip though :merli:

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Don't even try to run it on the stock ECU if you're going to have the boost controller bring boost above ~10 psi. I've already told you that. If you use the Nistune ECU, you will need to CAREFULLY read the available documentation for Neo tuning, and read some threads on the Nistune forums, to discover the various things you have to do to prevent the ECU from going bananas when the boost is too high. The is a table associated with th boost sensor that must be modified to prevent it from shitting the bed. This is just one of the things that you will need to do to the tune in Nistune, because the Neo turbo ECU will be expecting to see a number of things (such as the TCS) that are not there, and you have to block the DTCs on those. It is totally not surprising to me that you are having the problems that you are, but the solutions to these problems have been known for >15 years. So just get it done.
    • Hi. Sry iam not a mechanic and iam not at the car atm so i dont know 100% but they told they measure those and even try to change those. AFM they have two. Coils are new a they have my old one too. Plugs too. ECU...we have 25 NEO stock and Nistune 25 NEO.   But i dont know if any one those could be the problem and why/if/what can cause this, Only thing they did not check is fuel...but that walbro 255 is new(like 1,5 years)... That fuel pressure gauge idk...but i let them know Any suggestions?   EDIT: how can they know if it is like you say he ECU pull power when it reaches a specific boost level that is too high? Tha car has boost controler
    • Can you clarify what you mean by boost cut, do you mean it misfires both when under load (driving) and when stationary and out of gear? Or does the ECU pull power when it reaches a specific boost level that is too high (boost control issue)? Does it occur at idle with no throttle? When you say "the ECU is OK", what ECU is it and why do you think it is OK? Have you used the NEO ECU, and if so do you have a MAP sensor attached? Same for the AFM, why do you think it is OK? Do you have any way to put a fuel pressure gauge on it (even just a mechanical one between the fuel filter and fuel rail)?
    • Hi.. Just another problem. So maybe you can help. I(my mechanic) done swap from my RB20DE NEO to RB25DET NEO. Everything is OK but we have a boost cut. Coils/Plugs are ok...AFM is ok. ECU is ok. I have Walbro 255 but it "changed" sound few months ago(you can hear it ouside) you did not hear that when it was new(maybe faulty?) Sooo...what now? What can cause this boost cut? It is even when you standing still...
×
×
  • Create New...