Jump to content
SAU Community

Recommended Posts

My fuel gauge is all over the place at times..... I will start the car in the day and it will sat half a tank which is true but as soo as I go down the road and give her a lil curry , it dropps to almost empty and it will sit there for ages......... I will go to the car again later ant it is back at half a tank again......]

I think the gauge in the tank is buggered.... Does anyone know how to take it out of the tank???

Or do I have to take the whole tank out??

Thanks

Shaun,.

Link to comment
https://www.sau.com.au/forums/topic/245145-fuel-gauge-problem/
Share on other sites

Make sure its not electrical first, check the simple things like fuse connection [swap it for another fuse even], also the wiring to the gauge from the tank, and the plug behind the front dash etc

If its a float, it usually stays bad, doesn't change or jump around. I'm pretty sure its a tank out job, I've never done it, but I've changed fuel pumps a few times and can't see how you could get at it from the top. Somebody else may confirm????

The guage is connected to the fuel pump isnt it? If this is what you guys are talking about then it comes out when you pull the pump out. Check its mounted and working properly and if it is then thats not the problem.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Have you done the Ignition Sync Wizard in the AEM software?
    • Find out what RPM it was idling at with the IACV unplugged. It's very weird that the rpm didn't change at all, and then it stalled. When it stalls is it nearly like a switch off, like you've turned the engine off? Or is it more stutters and sputters and coughs to death over a few seconds? Or does the RPM just slowly keep going down and down? Have you done a test of trying to start it with the AFM unplugged? Does it still die?     If you Follow Josh's advice on using Nistune to check the voltages (which is a perfect method!) if you see anything out of wack voltage wise, THEN get the multimeter out and read the voltage directly at the sensor. If the two vary, then you're now looking for a wiring issue vs a sensor issue. So be aware, what the ECU sees, may not be what the sensor is actually saying too...
    • You very likely need to get it on a dyno and tune it. My assumption is, you've got an RB25DET tune in it, which has a different manifold, different injectors, and different cams as a minimum. What O2 sensor are you running?   When you say it runs extremely rich from idle all the way to redline, is this just free revving it you see that?
    • I seem to the be only person that is using a Haltech 2500 on an NA motor, I've installed a Bosch DBW throttle body to the OEM intake manifold and am having problems maintaining AFR even with the wideband o2.  It will run extremely rich at idle and up to redline, but under load it will go extremely lean in the 20s and i'm essentially having to rev it over 4k and feather the clutch to get it up to speed.  I've read a few other threads of about the butterfly, it seems removing the vacuum to it is supposed to have it remain open, i've noticed no difference under 4k with the vacuum line to it plugged.  I'm hoping someone here has had luck using the NA manifold with Haltech, and if they happen to have a tune for it.  
    • I don't know any details, but I really wouldn't be surprised if they do it as a LHD only version, at least initially.
×
×
  • Create New...