Jump to content
SAU Community

Recommended Posts

i might need some bigger injectors for my little rb20 soon..

i would be happy to sell you my standard ones. but to be honest and up front with you, they are a bit weapy around the seals...

just so you know. :D

Dood,

I bought the SS's and now I am spewing. I should have gone the 2530's!, the response difference is 3,800 to about 4,200, but the top end is a lot better.

I spent an awful lot of money to end with 380rwhp at 17 odd psi with the GTSS's, poncams, manifolds, dumps, EVC, Djetro etc etc and I am being told the turbos simply cannot hold 17psi through to redline because they are too small, so they hit 17 PSI at about 4,000 rpm and then taper down to about 15psi.....???

I spent an awful lot of money to end with 380rwhp at 17 odd psi with the GTSS's, poncams, manifolds, dumps, EVC, Djetro etc etc and I am being told the turbos simply cannot hold 17psi through to redline because they are too small, so they hit 17 PSI at about 4,000 rpm and then taper down to about 15psi.....???

That sounds a bit strange.

What about these guys?

R33 GTR - RB26

HKS GT-SS Turbos

HKS dual Dump and Exhaust system

HKS air pods

HKS intercooler

Tomei Poncams/Gears

Sard 700cc Injectors, rail, and reg

Nismo Fuel pump, intank

Splitfire coils

Power FC and AVCR

Power output is 340rwkw @ 8,000rpm @ 1.5 bar BP ultimate fuel

:D

Update to Post #13

I've had my GT-SS turbos and JUN cams fitted and fettled. Mid range power improvement is dramatic. This is like a new car, almost no turbo lag whatsoever. The car pulls hard in any gear. I use for daily driver and occasional track day. The dyno run speaks for itself. 500Nm of torque at 3000rpm! The tuning was done on a Dynapack 4WD hub dyno. 488hp @ A4W. Turbos running at 1.5bar.

1997 R33 GTR VSpec

Engine

GT-SS Turbos

JUN 264 Cams

JUN Adjustable cam gears

Mines cam baffles

Tomei sump baffles

Power Enterprise Super Strong Timing belt II

Nismo engine mounts

Tomei metal head gasket

Tomei oil restrictor

Custom oil cooler and filter relocation

Electronics

Power FC

Apexi boost controller

Nismo AFM's

Breathing

K&N Pods

HKS Dump Pipes

Apexi Front Pipes

De-Cat

HKS Hi-Power cat back

Standard intercooler (probably needs upgrading, blew a pipe off recently)

Drivetrain

Exeddy twin plate clutch

Fuel

Trust fuel rail

Nismo fuel pump

Saard 700cc injectors

Nismo fuel regulator

I can recommend this setup for anyone after fast road / track day use.

Dyno_488hp.pdf

Main difference? Lag/power. Try and get a ride in a gtr powered by the -7's and -5's before spending the coin, that way you know for sure which one you prefer. FYI I vote -5, all the -7 powered cars ive been in except one felt too responsive, as in, if they were mine id rather a bit more lag and have the extra power. Im not a tech head when it comes to turbos but i know what acceleration feels good :)

Did you end up finding injectors? You couldnt get 700's? I wouldve thought they're easy to find. Im selling a set, $600 delivered 720cc. The general rule of thumb with injectors is a set of 555cc's will be good for 550hp, a set of 720cc's will be good for 720hp etc

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • For these last 7 years of ownership, I've always had to use a small scissor jack under one of the front tow hooks to raise the front just enough so my low-profile jack fits under to reach my subframe jack point. I'm beginning to get annoyed of always having to do this. Are there any lower low-profile jacks that fit under the gtr lip on a dropped car?
    • Seat of the pants assessment of the new intake: The car is way less "doughy" when hitting the loud pedal, especially off idle when stopped or in traffic, I did use a cheapo lazer thermal thingo to measure the temp around where the pod filter got its air, it was between 55 - 60°C, in saying this the car was shut off and not moving, so the OEM intake pipe was not supplying any fresh air to where the pod was when the car was at least moving A weird bonus was induction noise on the throttle in the cabin increased a bit,  I was worried that I was actually going to lose some of that induction noise I love so much, outside though, when I got the daughter to do a WOT drive by pass for me, the induction noise has increased alot when on the throttle, not quite ITB doort, but well up there I'm extremely happy with the results and have been exploring the country roads in the region  As for house mods: 1.New front fence is up and is awesome, it really upgraded how the joint looks from the street, and the added security is nice 2. Electricians have replace some interior lights, and with more lighting in the garage, a few new motion detecting lights out the front above the garage, front room, and at the front door, which I have already found heaps helpful coming and going, also now has fancy pants CCTV all round the house The only hold point for power though is the solar and batteries due to supply issues, although this will happen over the next few weeks 3. I have done a heap of landscaping out the front and I'm almost ready to do a new small retaining wall with some nice blocks to replace the brick and cemented in rocks around the raised garden beds cemented in river stone "was the fashion at the time" the house was built. I currently have a pallet of retaining wall blocks and 2 bulka bags of 20mm blue metal to replace the wood chip that is in the raised garden beds around the house 4. I now have 3 big raised garden beds for out the back to grow some vegetables, about 70cm high, 200cm long and 100cm wide 5. My 2 compost bins are already pretty full with brown, green and kitchen waste from the landscaping I'vedone so far, but they will probably take a few months to break down, so anything else that gets chopped, trimmed, and kitchen waste will just start filling the base of the raised garden beds to about 30cm before I start throwing 40cm of good compost, and stuff, for the vegetables to grow in, I'll need a few ton of compost and soil, but the local supplier can sent me bulka bags of the stuff Basically the logs, wood chips and a few strategically placed rocks for drainage, will give the beds some good organic materials down low to break down over time, and they will hold moisture during the warmer months to save the water in my big arse water tank if we don't get alot of rain So, all in all, the car and house mods are going well, and I'm really enjoying being retired, I sleep in too 0700 and slowly plod around inside until I feel like actually doing anything, and only work in the yard for as long as want, which has actually been alot over the last few weeks,  although when you look at it, it seems that not a huge amount of work has been done,  until I look at the before I started the work pics Happy days and good times indeed 
    • hahaha yeah. Plan is to get side skirts and probably just rear pods. But going to do them one-by-one. I've got a set that I really like from RHDJapen, but that one isn't shipped to AU. So need to find someone who can get it for me
    • Here's an idea, answer the questions I asked you as they are trying to work out WHY the LSD will be binding up in a straight line.
×
×
  • Create New...