Jump to content
SAU Community

Recommended Posts

Thanx guys, I do like the look of the r32 -> (looks more like the r34) Will be test driving the R32 GTS4 today. With features regarding safety , it has ABS which is a big plus in my books.

It is pretty stock under the bonnet but previous owner is a GTR enthusiast and has modified the interior and exterior accordingly. Will have to test drive r33's for comparison but sounds like the general consensus is that the R32 provides a good mix of performance, quality, looks and handling.

Pentae, you've quoted GTS-t power but GTR weight there. Actually even then I think they're too heavy, Motortraders says the R32 GTR is only 1430kg, and R33 1530kg. If the figures you quoted were really for a GTS-t, they would run into the 16's I reckon :D Also only the S13 1.8T Silvias are 1140kg or so. S14 2.0T are around 1220kg.

Anyone curious about power, weight, and standard features of grey imports should have a look at Motortraders Network. It might not be 100% accurate, but I think it's pretty close, and it's definitely the most comprehensive list of these cars and their features that I've seen.

XPL_Vspec, here are some other things to consider when comparing the R32 with R33.

The R33 has, compared to R32:

Bigger injectors

Better flowing engine head (it's not all just about the extra 500cc)

Stonger gearbox

Better brakes (except for compared with R32 Type M, which are about the same)

Smaller boot space (battery is in boot, along with a lot of HICAS gear)

More room

More weight

If you plan on upping the power, the R33 is probably a better base to start with. However, if you can pick up a bargain on an already modified R32, that may be the way to go. Especially if you can find one that has already had an RB25 conversion with gearbox.

I would also like to point out that Nobody has mentioned yet that the R32 is about 5-8k cheaper.. for those of you saying 'the r33 is a more powerful base to start with..' how does the r32 compare as a base to start with after you've used the money you've saved on mods?

I'd rather a totally decked out r32 gtst with 8k of performance mods than a stock r33.

Originally posted by pentae

I would also like to point out that Nobody has mentioned yet that the R32 is about 5-8k cheaper.. for those of you saying 'the r33 is a more powerful base to start with..' how does the r32 compare as a base to start with after you've used the money you've saved on mods?

I'd rather a totally decked out r32 gtst with 8k of performance mods than a stock r33.

Wasn't it only me that said that?

Ok, if you start with a stock R32, to bring up to similar spec (hp handling-wise) as an R33 you will need:

Bigger injectors $200?

Bigger brakes $500?

RB25 box and engine $3000?

Laber to fit all the above $1000?

That $8k is already half used up and you haven't even done anything to the power yet. Plus all the time off the road to put it all in. Like I said, if you want an R32 it's probably better to find one with some or all of the above mods already done, unless you plan on keeping it stock. Or just go the whole hog and get a GTR.

I would rather an R32 GTS-t with $8k of performance mods than a stock R33 GTS-t too. But that is assuming that the choices are as black and white as that. They aren't.

Edit: And this is assuming you can even get an R32 for $8k less. I just had a quick look in the trading post and the cheapest R32 GTS-t I could find is $14k. Average around $16k. At least they are holding their value pretty well.

Can someone confirm that Type M R32's are the only R32's with 4 piston calipers? Ive never seen an R32 that has the 2spot front brakes, does that mean the vast majority of R32 GTSTs in Aus are type M?

Originally posted by XPL_Vspec

Thanx guys for your input. If i was to get an r32 completely stock under the hood, what would the first thing you guys would do? maybe less than $1500 - $2k worth of mods?

Full 3 inch exhaust, including cat and front and dump pipes

Probably wouldnt bother with a pod filter, just get an aftermarket element.

???

No need for bigger injectors unless u're going after big HP like 200RWKW+

Bigger Brakes? - R32 Type-M brakes are almost identical to R33 brakes.

RB25Box I can understand this cause the RB20DET box has problems with big HP.

RB25Engine? - mate its only 27kW or so diff between the two DET engines and the 32 is a slightly lighter car.

Originally posted by JimX

Wasn't it only me that said that?

Ok, if you start with a stock R32, to bring up to similar spec (hp handling-wise) as an R33 you will need:

Bigger injectors $200?

Bigger brakes $500?  

RB25 box and engine $3000?

Laber to fit all the above $1000?

That $8k is already half used up and you haven't even done anything to the power yet. Plus all the time off the road to put it all in. Like I said, if you want an R32 it's probably better to find one with some or all of the above mods already done, unless you plan on keeping it stock. Or just go the whole hog and get a GTR.

I would rather an R32 GTS-t with $8k of performance mods than a stock R33 GTS-t too. But that is assuming that the choices are as black and white as that. They aren't.

Edit: And this is assuming you can even get an R32 for $8k less. I just had a quick look in the trading post and the cheapest R32 GTS-t I could find is $14k. Average around $16k. At least they are holding their value pretty well.

I can't figure out why people choose their cars based on how common they are. Do you really care that much about what other people think?

Yer, people are silly choosing a car on that basis. If you look at it that way then ANY skyline is common, except maybe for an R34 GTR or something.

They are much of a muchness in terms of most things and everything seems to balance out a bit.. and don't forget being "more common" for a 33 is often a good thing, means parts and advice might be more readily available.

Personally I think this 'common' argument is a little specious.

GTS Skylines are cheap performance cars. For less than $20,000 you're not gonna get a whole lot of exclusivity.

Even twice that for a GT-R isn't gonna get you into some sort of "LOOK AT ME, I CAN DUST FERRARI's" fraternity.

I was looking for power, handling, braking, size (yes I like BIG cars), reasonably cheap mods and a big cabin (show me a bigger coupe interior).

The 33 is really close enough. I really want that 33 GT-R - it's not twice as good but I'll be willing to pay the price to find out.

T.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Haha, i kow right? Could have bought so many cars for the same amount of money (or less) but driving Unicorn gives you at least +1mln to style 😅. Like wise man said "life's to short to drink cheap wine and drive boring cars" 😉
    • Newbie here, proud owner of an Autech 260RS. I'm on the hunt for wiring diagrams specific to the 260RS, particularly S1. I've ran my eyes through R33, R34 Diagrams, there are some similarities, however continue to find incorrect wire colours and pins on connectors in the 33,34 diagrams.   I was hoping someone could point me in the right direction? I'd be happy to pay for the originals in Japanese. I can translate them, at least they would be accurate.   Any help please would be greatly appreciated, never heard an RB26DETT before let alone driven one, and I've got a spaghetti monster of goodness to sort out.   Cheers Benny  
    • Hey all  im wondering if you can help me please I have put a rb20 box in my r34 gtt as my auto packed up and a friend had a spare box I know it’s not ideal but it will get me up and running for now. we have done the conversation and everything is working great but my Speedo we got a s13 speed sensor but my Speedo reads double now and I bought a speed converter but still not having any luck.  so I thought I’ll reach out and pick your brains  any help would be appreciated please as I wanna drive my car again 
    • Drain it. I got official Matic D but you can get whatever is listed as Matic D compatible.
    • Thanks guys,  Yeah I should at least have them dynoed, at least then I know what I've got as a starting point.  The springs on these are hard as rocks. I vaguely remember Russman saying he was going to sell the shocks to me with the rocks fitted, as he was keeping the softer springs for his new setup.  I didn't click at the time but of course that was to let me know the shock/spring wouldn't be matched.  I also remember pricing up new springs around 2014-15, but, house, money etc. it never happened. So that was another reason to have them rebuilt. I have rebuilt the forks on many motorcycles so I think I could handle the seals on these easily enough, but getting the valving right would be a rabbit hole I cbf exploring.  Duncan, interesting to hear RP was tuning these back then. I might give them a call.  In the mean time I have been busy fitting sway bars. The Whiteline rear sway bar I purchased 15 years ago finally got fitted, along with the Whiteline front bar that showed up last week. Just waiting on new links for the front sway bar to finish that off.  And my spare set of advan AVS VS5's should be back from the powder coaters in a Pearl White finish sometime this week, with a set of Hankook RS4's lined up for fitting.  And then I just have all the suspension bushes to do. A comprehensive kit is on the way... Lots to do before the Ararat hill climb. Cheers guys 🍻   
×
×
  • Create New...