Jump to content
SAU Community

Recommended Posts

I was looking at my cat the other day, and i noticed that there is a sensor in the cat,i think its a secondary 02sensor.Anyway its been weld to the cat so if it is a 02 then im guess that it would be stuffed after the heat of being welded.Where can i get new 1 and whats it there 4.

Link to comment
https://www.sau.com.au/forums/topic/25201-wtf-is-the-sensor-in-the-r33-cat/
Share on other sites

The EGT sensor illuminates a warning light which looks like a side view of the catalytic converter with wavey heat lines coming off the top of it (looks more like a BBQ!) It will illuminate when the temperature has reached around 850 degree celcius. This is very hot, and is usually due to either driving the car very hard continuously (ie: around a race track) or if driving normally is due to an extremely lean engine conditions (not good! perhaps a lazy fuel pump?)

This doesn't affect the operations of the ECU, but serves its purpose to help protect both the turbo from excessive heat (ceramic turbines in particular) from high temp failure and also to help the Platinum Rhodium material in the catalytic converter from being heat damaged.

Heat damage reduces the cat's ability to convert carbon monoxide and other poisonous gases back to a safe (and legal) emissions standards. Most cats don't work too well after 80,000km's anyway, from what i've been told.

If you ignore the warning light, then i think you'd be taking a blind eye to a possible engine problem if the light come on when you were just driving around normally (ie: not doing laps on a track)

Hmm, could be a faulty EGT sensor, but i still think that it could be indicating an engine that is running a bit too lean. I hear stories from a dyno operator i know here that sees cars that come in every day that have been so called "tuned" or "dynoed" that run extremely lean in the quest to extract as much power as possible. He says that some performance shops tune the cars so aggressively to extract as much power as possible to impress their customers, when in reality it's better to tune conservatively on a street car taking into consideration different qualities of fuel from batch to batch, different ambient temps, etc, etc. Too many variables to consider, and you should be factoring in some reliability into the engine with some form of thermal control. (A bit richer from Stoichiometric)

Anyway, i'm rambling again, get it looked into! At least check your fuel pressure and A/F ratios, as a EGT warning is a rare instance on a street car, i'm told.

um mods where safc,fmic,9psi,hks filter hi flow muffler. 212hp or round there.They told me my exhaust is causing issue's.I think the fuel pump is stuffed to.Seeings im not driving it im saving heaps of cash and im getting 3inch turbo back exhaust,255lpr pump,malapasi reg,To4e,plenum modified like a gtr style.Cause i think the turbo is a bit tired.Ill see how that runs if it still unpowerd then wolf3d,injectors,manual.I do alot of my mods myself (still building 327hp sohc vtec civic,time for body work:)

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • You just need to remove the compressor housing, not the entire turbo. I would not be drilling and tapping anything with the housing still on anyways. 
    • So, I put my boat on a boat. First of all, I'm going to come out and say it. Why is Tasmania not considered a holy goal, an apex that all road-legal modified cars go to, to experience? This place is an absolute wonderland of titanic proportions. If people are already getting club runs for once in a lifetime 30 person cruises to Tassy then I've never seemed to see it. It is like someone replaced the entire place with an idyllic wonderland for cars, and all of the people living there with paid actors who are kind, humble, and friendly. Dear god. After doing a lap of almost all of the place I've found that it's a great way to find out all of the little things that the car isn't doing quite right and a great way to figure it all out. All in all, I drove for 4 hours a day for a week and nothing broke. I didn't even need to open the engine bay. This is by all means a great success, but it has left me with a list of things to potentially address. I also now have a 3D printed wheel fitment tool which annoyingly hasn't got any threads in it to actually assemble it. I might be able to tape it together to check the sizing I actually want to use, but it'll likely involving pulling the shocks out to properly measure travel at least at the front, and probably raise the car while I'm at it, at least in the rear. I scraped on quite a few things and I'm not sure how else to go about it. I was taking anything with a bump at what felt like 89 degree angles. And address those 10 other tasks. And wash the car. God damn it is dirty. And somehow, the weather was perfect the entire time - And because I was on the top of Mt Wellington it turns out it was very much about to freeze up there. I did something I typically never do and took some photos up there in what must have been -10 and the foggy felt like suspended ice, rather than mere fog. If you own a car in Australia, you owe it to yourself to do it.
    • Damn that was hilarious, and a bit embarrassing for skylines in general 😂 vintage car life ey. That R33 really stomped. Pretty entertaining stuff
    • Hi, I have a r32 gtr transmission. Does any of you guys have an idea how much power it will hold with the billet center plate and stock gearset? At what power level and use did yours brake with or without billet plate? Thanks, Oystein Lovik
    • Saw this replica police car based on a Mitsubishi Starion XX parked next to a 'police box' (it's literally a box) in Hirohata, Himeji City in Hyogo prefecture the other day. It's owned by Morii-san who is a local Mitsubishi Starion enthusiast. According to a local radio station blog post, he always wanted to make a police car himself based on ones he saw in his favourite Manga comics.  As it's illegal to modify a car to look like a police car and drive on the road, Morii-san tried many times to get permission from Aboshi police station headquarters nearby. They refused initially by after they got tired of that they granted him permission. However, the car can only be displayed on private property and obviously can't be registered as long as the police livery is present. The car was completed at a cost of 1.5 million yen (US$ 10,000) in addition to the car cost. A location was chosen outside Hirohata Police box where the car can easily been seen from the street. Morii-san has two other Starion road cars, both widebody GSR-VRs.
×
×
  • Create New...