Jump to content
SAU Community

Recommended Posts

Hey guys, recently just had this issue. The problem is that when i put my foot down in 3rd or 4th or any of the gears well mainly the 3rd or 4th(MANUAL), my rev just goes back a little bit like the car dies out but comes back a second.. Could this be my clutch? it feels like a clutch issue. My current mods to my car atm are a Full 3" exhaust with highflow cat, Bleed valve @ 10-11psi, Apexi Pod,FMIC,walbro fuelpump 255l,splitfire coil packs with plugs BCP6RES 0.8mm. Thanks. I was thinking if it was the clutch?

Geraus.

Edited by geraus

Clutch would mean the car rev's up more easily/free without actually going any faster.

To me, basically the same as every other thread on the mid RPM 'hole'.

Your running 10-11psi on the stock ECU so its likely to be having a fit and going into R&R mode (which is impecably well documented)

when im doing about 70kms on 3rd gear full throttle, the car just splutters or for like half a 2nd then clims up ... usually when you put your foot down it just pulls off... now it does some sort of half a 2nd stutter...

i just checked em before. everything is fine, it still goes down like i duno how to explain it, i thnk its the clutch sleeping when i put my foot down......

Edited by geraus
i just checked em before. everything is fine, it still goes down like i duno how to explain it, i thnk its the clutch sleeping when i put my foot down......
Clutch would mean the car rev's up more easily/free without actually going any faster.
i just checked em before. everything is fine, it still goes down like i duno how to explain it, i thnk its the clutch sleeping when i put my foot down......

Red bull would really wake up a sleeping clutch......

so it could be the timing? Because it was fine just a couple of days ago............could it be the gearbox?

il try and explain it again.... Just say im on 3rd gear and my rev is at about 3-4prm .. If i plant my foot down, my car will stutter for about half a mili second n then just pull a lil.... sometimes it does it and sometimes it doesnt. .. its wierd...

Edited by geraus

ive got a similar problem. except mine does it in 3rd 4th at about 2-3000rpm. i could notice it more when i got my new turbos put in.

ive been told my car runs lean and the timing retards which causes like a jerking sensation, only for a split second or while im "cruising" and my revs are floating from 2-3000rpm.

correct me if im wrong.

hopes this helps

not a clutch, gearbox or diff issue, its 100% around the engine,

as R31Nismoid has said, check things like spark and timing, AFM, to be honest, could be something to even do with fuel,

say when you put your foot down, it just puts a lot more fuel into the engine then wat its ment to which causes the drop in power because it cant really burn it (splutters), then once thats out of the system 0.5secs or what ever it might be it will burn normal again and you get power back,,

If it was your clutch and you put your foot down, revs will go up, speed will go down becuase your not going anywhere, and normally once it starts burning like that it wont grab at the higher revs,

so take the point of gearbox or clutch completely out,

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • The 296mm rotors are the R33 turbo brakes. The 310mm rotors are the R34 turbo brakes. The calipers are nearly the same, but not. They're the same caliper but the R34 caliper has longer legs so that it sits out far enough to go over the rotor. The pads are the same for both. When you say, "I bough tsome EBC"....did you just mean pads? Or rotors? 310mm rotors fit under 17" wheels. There may be some wheels without enough clearance though. I can't fit my fingers between the barrel of my wheel and the "corners" of my R34 calipers, but there is plenty of room behind the spokes. This is on Enkei RPF1. You can fit 324mm rotors inside a 17" wheel, but I'd be willing to bet that it would be close to impossible with the Nissan/Sumitomo caliper (using an adapter, of course), because the Sumitomo caliper is fatter than the Brembo caliper that is supposed to go on the 324mm rotors.
    • Hi. Can someone tell me what brakes(and mainly WHERE) can i buy brakes on R34 GTT? I bought some EBC which SHOULD go on my car(i have GT but it has GTT brakes) but it does not fit, Brakes are "too" small(296mm) Are 310mm be good or? I have 17 inch wheel so no "big boys" but for me driving i just need one that fits and i can get here in EU/Czech.
    • Since winter isn't that harsh anymore in Poland, i will definetely drive it 365 days a year 😉. But if the snow hits i will try it for sure and let U know. Only swap i am planning to do is of course R34 GTR front 😍.
    • Hey. Very valuable information about pitwork, I will pay attention when buying any consumable parts 🙏 As for the carpets - I got a handful of information from nengun, from which it appears that indeed the carpets for the driver's side are OEM. They are not able to show me any pictures due to the long chain of different sales entities but after I place the order, as soon as the goods arrive at the nengun warehouse from which they will send the shipment to me they can send me photos and if my purchase differs from OEM I can immediately return it / cancel the purchase. I think I will give it a try 😉. Of course i'll let you know what's what as soon as i get them P.s. I know the topic is not relevant to the thread, but both nengun and amayama have these SICK 😍 trunk room lamps available. Do you know anyone who ordered them? I need to have one in my car
    • I've managed to find this: Nissan_Stagea_AutechVersion260RS (1).pdf
×
×
  • Create New...