Jump to content
SAU Community

Recommended Posts

Guest sssnowdon

AS FEATURED IN AUST.INCAR ENTERTAINMENT

SPENT OVER 35500

FEATURES INCLUDE

BODY.full custom usc bodykiy with vp v8 supercar rear wing,ser3 taillights,prof.lowered 2 in.with whiteline springs and monroe shocks new w/screen

INTERIOR

custom saas interior including saas avenger front seats,bolstered and retrimmed rear seat custom door trims for stereo,momo s/w ,g/knob,custom mats,c/fibre dash kit

ENGINE

RB30N/A 5 sp.02 rush filter with custom perspex cover,extrac.with custom s/steel cover 2.5 in.ex. with hiflow cat,mild head port and polish12 new lifters,custom s/steel injection cover,paragon 500 alarm faultless detail in engine bay

WHEELS AND TYRES

new citic 18 inch chrome 5 spokes with new falken grb rubber

STEREO EQUIPMENT

r/ford f/qate punch 100,punch 4020 with heatsink ext.

pheonix gold eq232 with bal. line transmitter,mb quart 3 way front splits,soundstream b69 3way rear fill,2-kicker10 inch subs,2-r/ford f/qate 4 inch center channel ph.gold half farad cap.coustic multy chan. crossover,ph.gold rca,s,s/wires cabling,sony xrc750h/u with remote,sony cdx45 10 stack

STEREO FEATURES

FULL CUSTOM INCLUDING

recessed amps,capacitor fuses crossover in boot floor,subs in perspex box with neons and halagon lighting,dual 30band eq recessed in bootlid and covered in perspex,custom rear shelf,custom moulded front door trims for 3 way splits,neon display in glovebox,sep bass control in front.SPENT OVER $13000

SPARES INCLUDE

2-18inch michelin tyres 95 percent

1 new rer bumper

all orig. seats interior

complete bottom end ,trav. only 60000 klms

CAR HAS TOO MANY MODS TO MENTION,IMMAC COND.

READY FOR SHOW N SHINE OR AUDIO COMPS,11 MTHS REGO

POST HERE OR EMAIL [email protected].

OR PHONE 0438219922 VICTORIA

WINNER OF 12 TROPHIES

Link to comment
https://www.sau.com.au/forums/topic/2554-r31showcar-for-sale/
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • The final part arrived today to un-clampify and simplify the intake Who would have though a 1/2" hose stainless bulkhead fitting designed for below waterline bilge pumps would be what I needed Test fit on a 3" offcut I had laying around to see if it would work, and it worked a treat All going well the intake will be on its "final version" tomorrow 
    • Good luck on the weekend mate
    • Must have been an absolute nightmare to drive when the power steer was out, the rack ratio/wheel size/caster is all set up for power assistance
    • Welcome to SAU, what are you looking at buying?
    • I checked the injectors again (1 and 2, since they’re easiest to access) to make sure they weren’t clogged. Even though the entire fuel system had been cleaned, I wanted to be certain. Everything looked clean, so I reinstalled and connected everything. When I started the car to confirm everything was okay, it immediately revved up high, so I shut it off straight away. I checked to see if I’d missed a vacuum hose or something, but everything was connected. On the second attempt, the car ran without the high idle, but I noticed a distinct “compressed air” sound coming from the engine bay. Tracing the sound, I pushed injector #6 forward slightly and the noise stopped — it turned out it wasn’t seated properly, despite the fuel rail being bolted down. While holding it in place, the car idled steadily without stalling and ran for over 5 minutes. At this point, I pulled all six injectors out just in case I hadn’t seated them correctly or dirt had gotten onto the O-rings. Unfortunately, I discovered that I had damaged 3 out of 6 injectors (the OEM 270cc ones) during installation. So yes, this was my fault. Since only the pintle caps were damaged, I’ve ordered a Fuel Injector Service Kit from NZEFI to refurbish them. In the meantime, I reinstalled my new injectors – the car now idles fine for over 15 minutes without stalling. I have not attempted to drive it so far. It’s not perfect yet, as it hesitates when the throttle is pressed, but it’s a big improvement. Unplugging the IACV with the new injectors idles at around 800rpm, even with the IACV screw tightened fully. But this is probably due to tune.
×
×
  • Create New...