Jump to content
SAU Community

Recommended Posts

gday guys recently had some probplems with my r32 ...it wil start and idle but idle wil slowly come down to a stall and if i try to rev it it wil hesitate something shocking al i can hear is air poping back through the pod filter .. and it wil rev to 4 grand and then just back fire as if rev limit was at 4grand any help please

check your afm and also youur O2 sensor...sorta had the same prob and i changed afm and it fixed it for a bit and then i scanned my car and it said the O2 sensor was buggerd so i just disconnected it and now it runs a dream..hope this helps.

  • 3 weeks later...

yo man this happened to me, what mods are you running on your car?. what you can do is, first clean afm like said above, then check coil packs for any cracks, then make sure all spark plugs are good, and have got the proper gapping.. If it still doesn’t work and if your car has a decent amount of mods, change the fuel pump..

i had the same problem a week or so back, where my car would hit 3.8k-4.2k and start back firing very loud and the car wouldn’t go, so i put a gtr fuel pump in and it fixed the problem so it could be a fuel pump issue

Good luck man

niran

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Then, shorten them by 1cm, drop the car back down and have a visual look (or even better, use a spirit level across the wheel to see if you have less camber than before. You still want something like 1.5 for road use. Alternatively, if you have adjustable rear ride height (I assume you do if you have extreme camber wear), raise the suspension back to standard height until you can get it all aligned properly. Finally, keep in mind that wear on the inside of the tyre can be for incorrect toe, not just camber
    • I know I have to get a wheel alignment but until then I just need to bring the rear tyres in a bit they're wearing to the belt on the inside and brand new on the outside edge. I did shorten the arms a bit but got it wrong now after a few klms the Slip and VDC lights come on. I'd just like to get it to a point where I can drive for another week or two before getting an alignment. I've had to pay a lot of other stuff recently so doing it myself is my only option 
    • You just need a wheel alignment after, so just set them to the same as current and drive to the shop. As there are 2 upper links it may also be worth adding adjustable upper front links at the same time; these reduce bump steer when you move the camber (note that setting those correctly takes a lot longer as you have to recheck the camber at each length of the toe arm, through a range of movement, so you could just ignore that unless the handling becomes unpredictable)
    • I got adjustable after market rear camber arm to replace the stock one's because got sick of having to buy new rear tyres every few months. Can anyone please let me know what the best adjustment length would be. I don't have the old ones anymore to get measurements. I'm guessing the stock measurement minus a few mm would do it. Please any help on replacing them would be fantastic I've watched the YouTube clips but no-one talks about how long to set the camber arm to.
    • Heh. I copied the link to the video direct, instead of the thread I mentioned. But the video is the main value content anyway. Otherwise, yes, in Europe, surely you'd be expected to buy local. Being whichever flavour of Michelin, Continental or Pirelli suits your usage model.
×
×
  • Create New...