Jump to content
SAU Community

Recommended Posts

OK, I had a bunch of work done on my R33 GTR before xmas - incluing transfer case rebuilt and pan baffle. I'm sure they had to pull a bunch of the front suspension and cross member as they did the pan baffle with the motor in the car.

Now, my problem is really bad understeer. In the wet the car will understeer out of a round about if I accelerate out from normal speed. In fact at speed limit speeds, if I just aggresively turn the wheel the fronts slide and slip.

The car also kicks in the diff lock really agressively as even turning at 5 kph out of my driveway it will lock up the rear diff and make the car surge a bit as it turns.

I've only ever driven the car in 2wd mode as the transfer was stuffed when I bought it. But it never understeered this badly. In fact I think it drove better before becasue at least it oversteered when I put the power on.

I'm thinking I need to bring it in for an alignment check up as the first place to start. If that isn't the prob then I guess back to the shop for more check up (but I'm not really feeling confident as the shop has really taken me for a expensive ride so far).

Link to comment
https://www.sau.com.au/forums/topic/256972-gtr-understeering-badly/
Share on other sites

Ok, it's got greddy S-Tune all the way around. I lighted up the front adjustment all the way to hope to give it some more grab on the front.

Lowered 1" with whiteline camber bushes and aftermarket sway bars front and rear. The sway bars aren't adjustable so they aren't whitelines, but I don't know which brand.

Adjustable upper camber arms in rear.

Camber at front 1.5-2 negative and rears @ 1 negative degree.

In the wet this is what happens. The understeer happens entry, mid and exit. So entry if I just turn the wheel a bit too much will just slide. Mid if I accelerate will just slide. And exit will slide if I accelerate.

I don't drive that hard in the dry so I cannot comment too much aside from you can still feel the understeer a lot, it just takes a bit more speed and harder acceleration so I'm sure it will be the same as on the wet.

I just feels so wrong and really compromises my confidence.

Have you got a 4WD alignment done recently? Its worth a try and may improve things quite a bit....

I only had serious understeer issues when the transfer case was dying, the GTR does still understeer but not that easily.

The diff does lockup as you described depending on how cold it is.

It's a pity you cant soften the front bar that would be a good start after checking tyre pressures, How low is the front end, top of the guard inside to the deck? What are the spring rates? In the end it looks like a few things and I guess the diff isn't helping. I'd talk with the guys in the NSW section to get a referral to a good suspension shop...Heasmans or similar.

This is why I get my tuner to go the mechanical and a specialist suspension shop to do the suspension

Tyre pressures are 32 PSI all around. I've got Toyo Transas 275 35 18's all around with plenty of tread so those aren't the prob either.

It could be that the car didn't have the prob before as the diff (and 4wd) wasn't working before so it would spin a back tyre before breaking the fronts loose. I just can't belive how easily the fronts break loose now.

May have to investigate a better front roll bar.

Thanks for the input fellas.

Get a 4 wheel alignment done first. That way you know the wheels are pointing straight. Secondly, what oil are you using for the diff and transfer case? Maybe wrong type of oil used? The diff should not lock up in the driveway. Just some suggestions.

If you have redline light weight shock proof in the rear diff then that can make it lock up at low speeds. Its probably not ideal for a street car if you just want it to be quiet, damn good oil though and makes the diff tighter which is great for track days/spirited driving...

Ok, it's got greddy S-Tune all the way around. I lighted up the front adjustment all the way to hope to give it some more grab on the front.

Lowered 1" with whiteline camber bushes and aftermarket sway bars front and rear. The sway bars aren't adjustable so they aren't whitelines, but I don't know which brand.

Adjustable upper camber arms in rear.

Camber at front 1.5-2 negative and rears @ 1 negative degree.

In the wet this is what happens. The understeer happens entry, mid and exit. So entry if I just turn the wheel a bit too much will just slide. Mid if I accelerate will just slide. And exit will slide if I accelerate.

I don't drive that hard in the dry so I cannot comment too much aside from you can still feel the understeer a lot, it just takes a bit more speed and harder acceleration so I'm sure it will be the same as on the wet.

I just feels so wrong and really compromises my confidence.

Rake angle (or front to rear balance) plays a huge part in how the GT-R corners. Lowering overall by 1" as you say is OK, but you must make sure you keep the front (as measured from the centre of the wheel to the arch) is around 10mm higher than the rear. If you have a neutral (or worse rear elevated) rake the car will understeer like a bitch.

You don't mention if you have a subframe alignment kit (aka "pineapples") installed. If you do, make sure the setting is neutral rather than "traction" or "squat".

Gav

  • 3 weeks later...

Thanks all. Had the 4 wheel alignment done and they said there was a ton of toe in at the front causing my issue. Must have gotten out of alignment with the work that was done.

Driving today in the rain and all seems good so far.

Glad it was just an alignment issue.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • My experience with Rising Sun Exports Before agreeing to the sale I tried to do as much research as I could (obviously), his Facebook reviews are 98% and he goes Live at least once or twice a week. I contacted 2 people in the UK who had used him for their imports, both had positive feedback. His explanation and talk through of the import process was thorough, answering any query no matter how stupid it was. It felt as soon as the money was sent, communication dropped off. I asked for shipping updates every 2 weeks or so, not wanting to pester him, he never had any updates. I wasn't informed the car had been dropped off at the port, I only found out by his Facebook story. I asked for the photos taken at the port, knowing he would need some for insurance purposes. I received a few 5 second clips and that's it. When asked again, he said his staff had them. Weeks later I asked again, he tells me he doesn't have any, but does have 50 photos from the original advert. I never received them. I eventually got the documents sent via WhatsApp after I mentioned the port was requesting them. I purchased a CarVX report, to find out the vehicle is a Grade R with recorded accident damage, first recorded in 2017 when it was first auctioned. He never told me the grade, then again I didn't ask. His response was "Grade R means nothing, it wasn't chassis damage". Still, I would have liked to have been informed about it. Jon prides himself on being open and honest when it comes to inspecting cars, it's his main job doing so at the auctions for customers. When the vehicle arrived in the UK I noticed a few little cosmetic issues. It's a 21 year old car so it wasn't going to be mint condition. The side skirts are cracked on each corner and the sealant is failing. The front grill on the bonnet/hood isn't secured very well, mounting studs are missing. Both minor things, but again, it would have been nice to be told. During a Facebook Live walk around video of the vehicle, he mentioned it has a front Whiteline anti roll bar/sway bar. While on the inspection ramp, I noticed the stock item has been installed. When first questioned, his response was "the ARB? Switched? Since when, it never had them". Since sending video and photo evidence I've not received a response. I'm probably being over critical of the overall condition of an old car, but all I wanted was honesty (which he claims to have). I'm aware I wasn't his only customer, he's busy doing XYZ but other reviews praise him for great communication with regular updates and photos, I felt I didn't receive the same treatment. 
    • I was able to get some underside photos while the car was on the ramp The suspension is all Altezza/IS200/IS300 so getting part's will hopefully be less of a headache
    • Welcome to my 2004 Toyota Mark ii IR-V Fortuna (series 2) With a 1JZ-GTE powerplant under the bonnet (hood) it'll give me plenty of scope for power upgrades. For those who aren't familiar with imports, the 1JZ-GTE is a 2.5L 6 cylinder VVTi engine with a single turbocharger. This has the factory R154 5 speed gearbox, along with a aftermarket 2 way LSD differential (brand unknown). Under the arches are a set of CST Zero 1 alloys, 18x9 +30 225/40 up front and 18x9.5 +15 265/35 on the rear. The car was quite low in Japan and there's evidence of the wheels catching the rolled arches/fenders. The tyre's aren't great so I'm in two minds whether to replace both or just the tyres and put up with the wider wheels on the rear. The car still uses stock brakes with the addition of some braided hoses. The exterior is stock with the exception of a BN Sports front bumper and a replacement Fortuna grill  Moving to the interior, the steering wheel has been replaced with a dished MOMO steering wheel (which will get swapped for my Momo Tuner for the time being) Defi Link Gauges are mounted above the climate controls and on the A pillar, the Oil Temp,Oil Pressure,Water Temp and Boost gauges should help with spirited and track driving  The stock seats have been replaced with some retrimmed Recaro bucket seats. Being a larger build these are a little snug, unfortunately the orange isn't for me so I'll look into replacing these down the line. Other modifications include a twin plate clutch, Blitz intercooler, Evolve alloy radiator, a stainless exhaust with decat, HKS EVC-S boost controller and coil overs
    • Apologies for the long read My R34 GTT was up for sale at the beginning of spring due to a few repairs creeping up. The strut tops needed replacing, roof and bonnet (hood) painting (yay for 3 stage pearl) and the underside stripped and treated. I sold the car which allowed me to be in a much better place financially. Leading up to the sale I was already thinking about the replacement. In an ideal world it needed to be a good all-rounder. Something I can mess around with, modify, do track days, do the school run, go on long drives etc.  Options included but not limited to... Laurel C35, Evo 8/9, Civic FD2, Impreza Hawkeye, Aristo and even an Audi S4 Avant (I've already got the Mazda 6 wagon). But there was always one car at the top of the list The Toyota Mark ii JZX110 I found an advert on a Facebook group for an example in Japan, from a seller called Jon at Rising Sun Exports. A few messages back and forth and Jon calls me from Yokohama one morning (or afternoon in his case). He briefly explained the import process, the costs involved and a repeat of the advert. After much deliberation, the price was agreed and the sale was locked in. I've never imported a vehicle so I jumped into the unknown head first. The money transfer was completed through wise.com (fees apply), very easy to use and the money was with him within a day or two.  The car suspension was raised for the vessel and the car dropped off at the port. It was 7 weeks later when the bill of lading was received and the freight invoice sent to me, followed by the export certificate a couple of days after (both digital copies) In the mean time the port had been in contact. I needed an agent to deal with the NOVA (notification of vehicle arrival) along with the tax/duty invoice, this was £75.00. The port also had a fee of £100, I'm guessing to cover the cost of the 10 day 'free storage' and for moving the car off the boat etc. They need a copy of the vehicle invoice, freight invoice and export certificate to allow the vehicle to pass through customs. The vessel arrived on Tuesday 5th August, the tax/duty invoice was generated and sent over. This is generally tax 20% and duty 10% of the vehicle value. Although the invoice came in at a higher amount than I had calculated. Once HMRC had received the payment the vehicle could be released from customs. I thought once the tax/duty was paid you could collect at any point, that's not the case. Your agent will need to book a collection slot, I requested Thursday 7th which was accepted, with a 9:00am slot allocated. It was a 5:00am start from Norfolk heading to Southampton. We eventually found the compound, upon presenting the bill of lading and some ID they released the car (they drove it out of the compound to the front ready for us to load up). The email from the port stated each slot had a 10 minute window, which seemed abit farfetched but the staff said it's not a strict rule. We were there for approx. 30-40 mins in total. A week prior to collecting I contacted my garage and explained the situation, I was able to get an inspection slot that afternoon. For the registration, DVLA require the car to be insured, for this I used a company called Adrian Flux who can insure the vehicle using the VIN number. 
    • Hey guys, looking for these side skirts if anyone can help me out. 
×
×
  • Create New...