Jump to content
SAU Community

Recommended Posts

Hi

Set of R33 GTR wheels in very good condition, no chips or damage. Very hard to find a set of R33 GTR wheels in this condition these days so don't miss out!! The wheels are a forged wheel, 17 x 9 + 30 and very light

They come with HANKOOK VENTUS S1-EVO tyres, 245/45/R17 - Rears have about 70% and front's have about 50%

Price is $1400 NEG

Located in Melbourne, south eastern suburbs

PM or call/SMS 0416 623 381 - PICK UP ONLY

Thanks

r33gtr1.jpg

r33gtr2.jpg

r33gtr3.jpg

r33gtr4.jpg

r33gtr5.jpg

r33gtr6.jpg

Link to comment
https://www.sau.com.au/forums/topic/258699-r33-gtr-wheels-with-tyres/
Share on other sites

  • 7 months later...
Hi

Set of R33 GTR wheels in very good condition, no chips or damage. Very hard to find a set of R33 GTR wheels in this condition these days so don't miss out!! The wheels are a forged wheel, 17 x 9 + 30 and very light

They come with HANKOOK VENTUS S1-EVO tyres, 245/45/R17 - Rears have about 70% and front's have about 50%

Price is $1400 NEG

Located in Melbourne, south eastern suburbs

PM or call/SMS 0416 623 381 - PICK UP ONLY

Thanks

ey mate have you still got the wheels for sale or have they been sold??

r33gtr1.jpg

r33gtr2.jpg

r33gtr3.jpg

r33gtr4.jpg

r33gtr5.jpg

r33gtr6.jpg

Guest
This topic is now closed to further replies.


  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...