Jump to content
SAU Community

Recommended Posts

Hi guys,

what would be the best place to keep amp in R34's car boot? any ideas guys? or pics? I don't want to spend heaps on car boot setup.

Thanks.

depends on how big it is?

behind the side panels on both sides there is a lot of room, move your jack under spare tire area. silicone a piece of MDF wood to outer fender (not a thin peice), screw the amp to it using short screws after it dry's over night, check or you will have holes in fenders outside .. critical to check, did I say that enough yet..lol then put panels back on to hide the amp, most amps wont get super hot since the floor is vented on driver side. place amp so fins let hot air go up, not sideways. cant steal what you cant find.lol

also behind rear seats on a wooden spacer ? spaced off the computers mount

suspended under rear deck ?on metal mounts isolated with rubber grommets to stop noise from ground loops

or screwed to the side of sub box if you have one ?

a false floor over the spare works too.more work but you can replace the wonky flimsy panel over the spare then too.

every thing else is lots more cost to mount it.

but that covers most option

Edited by sapphiregraphics
  • 2 years later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Bummer...yeah i "need" something to "ease" up the work and for my driving it would be enough.    Iam counting the tune "without" turbo. I do not mean "cheap" like something from Temu around 200 USD, "Cheap" is something around 1000 USD? 
    • Starter motors used to use the weight of metal (magnets) to provide torque. Now they use (more) current instead. This. It's completely normal.
    • So thing that had me stumped, but I think is OK....is that when it was up in the air, in neutral I had it running to bleed to coolant while I put the wheels back on. I noticed the rears were turning (slowly) which I'd never seen before 20250928_163512.mp4     Because there had been an issue with clutch slip due to pedal adjustment on the dyno, I assumed there was still and issue so spent some quality time upside down under the dash adjusting the pedal....but no matter what I did the wheels still turned in neutral. Even disconnected the master cylinder to pedal rod and same. In despair, I even removed the clutch slave so there was no chance of any preload causing it.....still happened. So either: 1. Something is not right in the bellhousing, or 2. Its a thing sometimes with cold, thick gearbox oil Internet says it might be 2, I hope so!
    • OK, few more things sorted and it is ready for a shakedown on 10-Oct, with one weird thing. Changed the run in oil and filter for the good stuff. 8l came out, about 8.5 went in with filter so that looks all good. Changed the starter (again), this time for a brand new one, works good. Interesting that the Taaaarks one is shorter than factory but spins harder, I guess electronics have moved on a little in the last 30 years. Will be nice to have a bit of extra space under there. Put the timing cover back on, and noted where the cam gears were set as a record.  Will need to double check the timing but it is pretty close. Also put the coil pack cover and intake snorkel back on. Exhaust Inlet Changed the water out for coolant, bled up nicely. Removed the rear brake pads (well worn factory sumitomo ones!), gave the hardware a good clean and reassembled. I've put bendix XP on the back again because the price is excellent at $150 a set and they worked well on the V37. Front pads have plenty so no issue there
×
×
  • Create New...