Jump to content
SAU Community

Inner West Crew Whoretown (toowong/st Lucia/kenmore/indooroopilly And Sometimes Sunnybank?)


Recommended Posts

Just chillin. Site is pretty empty today because of union march. Getting a programme sorted for basement works but other than that pretty relaxed eh.

im doing nothing but have to stay here until 5 as its my turn to man the phones, gay. I guess i could do some of these mountains of work on my desk.

Man the phones. What's your number lets have a conference call

pfft no wai, all day i think of ways to avoid being on the phone, there is no way im going on the phone on purpose regardless of how sexy you happen to be

anyone know where i can buy some sheets of 3mm polycarbonate?

If none of the other suggestions come through then go to an Electrical supplies/wholesaler. The use it to make switch boardsnpanelsnshiz.

pfft no wai, all day i think of ways to avoid being on the phone, there is no way im going on the phone on purpose regardless of how sexy you happen to be

furry muff

Im a kept man Andy, I only need to keep an eye on 9am and 3am.

Otherwise youll find me a whoring on here or making trouble elsewhere.

Im a kept man Andy, I only need to keep an eye on 9am and 3am.

Otherwise youll find me a whoring on here or making trouble elsewhere.

oh man i couldnt handle that, i get crazy after a few days off, that said i could go for a holiday right about now! Will just have to wait till long service leave early next year!

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • Did and sync timing with light 
    • Have you done the Ignition Sync Wizard in the AEM software?
    • Find out what RPM it was idling at with the IACV unplugged. It's very weird that the rpm didn't change at all, and then it stalled. When it stalls is it nearly like a switch off, like you've turned the engine off? Or is it more stutters and sputters and coughs to death over a few seconds? Or does the RPM just slowly keep going down and down? Have you done a test of trying to start it with the AFM unplugged? Does it still die?     If you Follow Josh's advice on using Nistune to check the voltages (which is a perfect method!) if you see anything out of wack voltage wise, THEN get the multimeter out and read the voltage directly at the sensor. If the two vary, then you're now looking for a wiring issue vs a sensor issue. So be aware, what the ECU sees, may not be what the sensor is actually saying too...
    • You very likely need to get it on a dyno and tune it. My assumption is, you've got an RB25DET tune in it, which has a different manifold, different injectors, and different cams as a minimum. What O2 sensor are you running?   When you say it runs extremely rich from idle all the way to redline, is this just free revving it you see that?
    • I seem to the be only person that is using a Haltech 2500 on an NA motor, I've installed a Bosch DBW throttle body to the OEM intake manifold and am having problems maintaining AFR even with the wideband o2.  It will run extremely rich at idle and up to redline, but under load it will go extremely lean in the 20s and i'm essentially having to rev it over 4k and feather the clutch to get it up to speed.  I've read a few other threads of about the butterfly, it seems removing the vacuum to it is supposed to have it remain open, i've noticed no difference under 4k with the vacuum line to it plugged.  I'm hoping someone here has had luck using the NA manifold with Haltech, and if they happen to have a tune for it.  
×
×
  • Create New...