Jump to content
SAU Community

Inner West Crew Whoretown (toowong/st Lucia/kenmore/indooroopilly And Sometimes Sunnybank?)


Recommended Posts

Morning,

Sooo bit of drama on the way home last night. Got to around Browns Plains with Tony following me and the car started to overheat. Pulled over into the Maccas at Browns Plains and there was steam pouring out the engine bay. Not cool. So after 30mins trying to get the bonnet to open with no luck we jacked the car up and I got underneath to have a look. Bottom radiator hose had been patched with a bike repair kit :D So time to dodgy some shit up. Selleys kwik grip and some duct tape to the bottom hose and we were on our way again.

Decided I would probably only to get to Mum n Dads place rather than back to the coast. About 10mins from home the car starts to overheat again. I soldiered on until the Shell outside Jimboomba when the car conked out. Let it cool down again and drove it home. By the time I got it into the drive at Mum n Dads it was knocking pretty badly so 31 is dead.

Anyone got a RB30e long motor they want to sell?

Dude, it took me years of practice (and a racetrack + old GTX2 oil) to kill an RB30. It took you what, about a week? Mad props :P

Pretty sure dan has an engine lying around. Alternatively, I can get my hands on a GTS1 motor for you. Its the motor from the car in second/first place on all the QLD tracks here: http://motamota.r31skylineclub.com/index.php?topic=132340.0

Alternative 2: Alfa motor. Yours for free if you're going to put it in the 31 ;)

In other sad news, I dropped my oakleys and they broke in half :D

Whats happening with the 32? Have you reg it yet?

Not regoed.

Dude, it took me years of practice (and a racetrack + old GTX2 oil) to kill an RB30. It took you what, about a week? Mad props :P

Pretty sure dan has an engine lying around. Alternatively, I can get my hands on a GTS1 motor for you. Its the motor from the car in second/first place on all the QLD tracks here: http://motamota.r31skylineclub.com/index.php?topic=132340.0

Alternative 2: Alfa motor. Yours for free if you're going to put it in the 31 :D

In other sad news, I dropped my oakleys and they broke in half :D

To be fair to it. It was driven for like 5 mins with no water in it. Hopefully Dan has something. I'll call some wreckers today, see how I go. How much for the GTS1 motor?

To be fair to it. It was driven for like 5 mins with no water in it. Hopefully Dan has something. I'll call some wreckers today, see how I go. How much for the GTS1 motor?

On the bright side if its a bottom end knock it should be good for several more weeks of abuse if you can get water back in it and stop it overheating again :P *knows from experience*

I just sms'd him on price, will send you a PM. Its more than I thought it would be, but still a good price for what you get.

On the bright side if its a bottom end knock it should be good for several more weeks of abuse if you can get water back in it and stop it overheating again :D *knows from experience*

I just sms'd him on price, will send you a PM. Its more than I thought it would be, but still a good price for what you get.

lol awesome.

P.S. Dibs on helping with the engine swap. That will be so much more enjoyable than having to work on thristians dirty SR :P

Too easy lol.

you'll need to sort out fuel delivery and ECU (and exhaust) for the 30ET. Probably want a FMIC too. Plus its a VL motor :P

not to mention you'll need brakes and a mod plate etc

300 for a stocko 30 isn't bad from a wrecker. Worth about a carton if you can find one on the club though

ET it.... Haha.

What time did you get to the Brown Stains? I jumped back onto the centenary and did the logan motorway. I think your problem was caused by giving it a boot load from the lights after the detour, that and Tony seemed to be monitoring your A/F's. He had his sniffer so far up your pipe... :P

you'll need to sort out fuel delivery and ECU (and exhaust) for the 30ET. Probably want a FMIC too. Plus its a VL motor :P

not to mention you'll need brakes and a mod plate etc

300 for a stocko 30 isn't bad from a wrecker. Worth about a carton if you can find one on the club though

Yeah I didn't think it was too bad.

ET it.... Haha.

What time did you get to the Brown Stains? I jumped back onto the centenary and did the logan motorway. I think your problem was caused by giving it a boot load from the lights after the detour, that and Tony seemed to be monitoring your A/F's. He had his sniffer so far up your pipe... :D

Tony likes to get up close and personal lol.

Morning,

Sooo bit of drama on the way home last night. Got to around Browns Plains with Tony following me and the car started to overheat. Pulled over into the Maccas at Browns Plains and there was steam pouring out the engine bay. Not cool. So after 30mins trying to get the bonnet to open with no luck we jacked the car up and I got underneath to have a look. Bottom radiator hose had been patched with a bike repair kit :D So time to dodgy some shit up. Selleys kwik grip and some duct tape to the bottom hose and we were on our way again.

Decided I would probably only to get to Mum n Dads place rather than back to the coast. About 10mins from home the car starts to overheat again. I soldiered on until the Shell outside Jimboomba when the car conked out. Let it cool down again and drove it home. By the time I got it into the drive at Mum n Dads it was knocking pretty badly so 31 is dead.

While all this bit ^ sucks rather large unshaven donkey balls

This part:

Anyone got a RB30e long motor they want to sell?

is completely unnecessary as you have a perfectly good RB26 sitting at your parents' house :P:D

Edited by Isola
While all this bit ^ sucks rather large unshaven donkey balls

This part:

is completely unnecessary as you have a perfectly good RB26 sitting at your parents' house :P:D

:D 26 isnt going in the 31 lol

this set lasted me for years, although i did go through a few sets of lenses (due to my own stupidity)

they are without a doubt the best quality non-polarised lenses around, and I can't stand polarised.

unfortunately all their current models seem to range from being a bit gay to being a lot gay :(

RB30ET FTW! damn you sabbai!

nothing wrong with getting up close and personal.

i can give you a hand with the engine swap. not like i have a job :(

Do the RB30ET!

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • Was there ever a model of the Stagea m35 that didnt have a badge on the grill? I thought I saw that somewhere, some aero edition or something? I cant find it again? davemoto
    • Its a 2002 vr-x four VQ25DET, silver. Coil overs, lowered, polished alloys and sport exhaust. Bit of a project, was sitting in a shed for a while but runs and drives great.
    • I wasn’t able to replicate the sound anymore. It was a one time sound so maybe it was just coincidence but it was like small pebbles being dropped in a coke can.   should I try cleaning the MAF? It could be it’s functioning but dirty? I don’t know.
    • Update 4: Hi all. The car drives again! Haven't driven for long, only to store it in the garage again, but the test drive was successful. The coolant and oil leaks seem to be fixed for now. Temps on the engine were also very good, while moving I never even saw 80C water during the approx. 30 minute drive. Ate up all the coolant in the reservoir though so will have to fill that even more when I go to the car next time. One thing that pisses me off is that the RPM gauge is still f**ked, I even resoldered the board twice and used copper paste on the silly screws that are used as connections. Next time I take it out I'll take apart the board and fit new components, I'll see if I can get a replacement IC for it.  I have an appointment set for 22nd of September for the engine tune to 370hp. Alignment also still needs to be done. My hope is that I can get all the legal stuff over with by the end of this season. Anyone of you have advice regarding intercoolers? Currently there is an APEXI core fitted, one of those weird hybrid ones, 600x270x76. I don't think it's bad but it's not new and now I still have the chance to change it now to legally include it in the paperwork. Only issue is that the only options that would arrive in time are a HKS Type R intercooler or generic Ebay spec intercoolers comparable to a JustJap one. Ideally I'd order a Plazmaman but it takes over a month to receive which would mean making the car legal has to wait until next season. Would love to hear some input on this. Same story for my injectors, the previous owner was a nunce and put ID 1050x on the engine. They work but are obviously not ideal at "normal" power levels. But I don't see a reason to change them unless the tuner says it's necessary. I read online before buying a different exhaust that the top secret style rear diffusers won't fit due to the size of the rear resonators. My buddy and I made it work by slightly "adjusting the shape" of the mounting bracket and making some spacers out of 3d print for the mounting bolts. Fits like a charm. Just putting this here in case someone has this problem. Even the hefty HKS Silent Hi Power rear can fits without hitting anything.
    • Well they got my money but they are not getting my gearbox ! 
×
×
  • Create New...