Jump to content
SAU Community

Recommended Posts

Want to clean out the shed. Buy my stuff. Located Mt Gambier, SA. Can organise free freight to Adelaide. Other locations buyer pays. PM or call on 0435 281 536. Don't expect prompt replies if you PM or SMS.

Falken RT615. Stickiest non semi slick rings out there. 215/45/17 x2. BRAND NEW. $400

post-18999-1237794176_thumb.jpg

PowerFC with hand controller. Suit ST185 GT4. $900

post-18999-1237794127_thumb.jpg

RB20det ECU. $150

post-18999-1237793776_thumb.jpg

R32 GTR front diff and drive shafts. No pinion gear. $200

post-18999-1237793369_thumb.jpg

R32 GTR front sub frame. $100

post-18999-1237793655_thumb.jpg

R32 GTR front hubs. $50

post-18999-1237793681_thumb.jpg

3 piece wheels x2. 17inch and I think 9 wide. Shit 245/40 attached. 5 stud. $100

post-18999-1237793906_thumb.jpg

Trust Rebic II. $100

post-18999-1237793997_thumb.jpg

Trust Rebic III. $100

post-18999-1237794078_thumb.jpg

Link to comment
https://www.sau.com.au/forums/topic/262362-falken-powerfc-gtr-bits/
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Swapped the injectors around and the misfire followed. I went ahead and ordered the Deatschwerks 550cc injectors and am currently waiting for them to be ship and arrive. In the meantime, I've had my Nistune soldered to the ECU. Tested it, and and tried it out with the software. Everything should be prepared for when the injectors arrive.  
    • Yeah they charge a little extra for mods , last year I noted no mods but I did have an exhaust fitted after that so  better to let them know cause these kinds of things can cause the policy to be void if you ever need to claim.
    • Hello, just just bought an 1999 enr34 with a stock rb25neo and I'm looking to upgrade the engine to 500whp I know some basic things but wondering if there are things I'll need to do to upgrade the stock block and all the bits and pieces to achieve this.
    • Thanks everyone for the replies and suggestions. Got the seats out (hoping I could find some existing grommets but no such luck). By tapping and measuring etc. I could figure out where I could drill through if needed. But first I borrowed an inspection camera and managed to go through factory holes in the chassis rail and could see that the captive nut was holding steady which is why it could retighten. So it was indeed a stripped section of thread, so I applied downforce by levering the bolt head with a screwdriver and went slowly back and forth until it came out. Camera helped a lot cos I could monitor that the captive nut was holding tight. Now I just have one very seized main subframe nut to tackle 😅
    • BOVs do have a purpose, if you ever log pressure before and after the throttle body, you will see a spike pre throttle on lift off from a WOT condition. Enough to bend throttle blades / damage e-throttle motors or simple assist in blowing off cooler pipes. FWIW, the above on really applies to those running at least 2 bar of boost. OP shouldn't have an issue, on the other hand, here are some videos of my shit box over a decade ago with some succulent dose with the airbox on and off. That shit box is unrecognisable these days 🫠    
×
×
  • Create New...