Jump to content
SAU Community

Recommended Posts

Hi guys, i'm just curious what is the best oil to use in my RB25. It currently has 126,000 KM's. I changed the oil around 2,000KM's ago and used a Nulon 15w-50.

What do you guys use? I mean, thicker, thinner, etc?

Cheers!

I got a 96 R33, use 0w30 mobil synthetic. There are heaps of threads regarding what oil to use

Link to comment
https://www.sau.com.au/forums/topic/263318-96-r33-rb25det/#findComment-4506766
Share on other sites

personally I would use a slightly heavier oil than the 0 stuff in a 13 year old 100,000km+ rb

also I dont know what nissan australia recommend for the vq35 on their aus delivered 350z but the jap/usa v35s use a super light weight low friction oil and weve seen some slight issues with a heavier oil in them here

Link to comment
https://www.sau.com.au/forums/topic/263318-96-r33-rb25det/#findComment-4508994
Share on other sites

I just checked the oil during my lunch break, was barely any in the sump :s yet the dash oil-light wasn't on and the engine sounded normal o.O

Anywho, just brought 2 litres of that nulon till i completely change it on saturday.....

Link to comment
https://www.sau.com.au/forums/topic/263318-96-r33-rb25det/#findComment-4509435
Share on other sites

I just checked the oil during my lunch break, was barely any in the sump :s yet the dash oil-light wasn't on and the engine sounded normal o.O

Anywho, just brought 2 litres of that nulon till i completely change it on saturday.....

was the engine hot?

Usually to get accurate oil readings you have to drive it around till it hits operating temp. Stop the car and let it rest for about 5 mins (to let the oil drop down) and then check the oil.

Pull the stick out, wipe it and put it back in. When you take it out again, that's how much oil is left in the sump.

If you did that, ignore the above haha. :)

Link to comment
https://www.sau.com.au/forums/topic/263318-96-r33-rb25det/#findComment-4509744
Share on other sites

i used to run Castrol EDGE 10W-60, valvoline 15w-40 and nulon 10w-40 but then i finally decide to settle with Motul 300V 10w-40 (gotta admit its expensive), all synthetic, nothing less.

how much oil did u put in? RB25s carry 4.7L including oil filter. i used to run 10W-60(pretty thick stuff) and 15W-40 and had no oil consumption, though it takes awhile 2 warm up

Edited by R33_NICK
Link to comment
https://www.sau.com.au/forums/topic/263318-96-r33-rb25det/#findComment-4509977
Share on other sites

lol

i have a feeling this debate on what brand of oil to use can go on forever... Basially tho theres a few things you need to look at

1. 100% fully synthetic... Like Mobil 1 or most other high end brands like redline.

2. Cold weight... should be max of 15... lowest of 0. This weight doesnt matter as much, as this is only when its cold... when it heats up it will get thicker. Thinner oil is better for cold start up anyway as it takes less time to move around and coat all ur engine parts. Its not like you are going to be thrashing the car while its cold. Easy driving only!

3. Hot weight... should be around 30-50... i wouldnt go anything above 50 as its a bit thick for street use.

Other then that theres not much else to think about.

So why do i use mobil 0-40? (apart from the above) Xspeed who check out my car recommended me to use it... so i did.

Edited by br3ndan
Link to comment
https://www.sau.com.au/forums/topic/263318-96-r33-rb25det/#findComment-4510132
Share on other sites

personally I would use a slightly heavier oil than the 0 stuff in a 13 year old 100,000km+ rb

+1

and WOHOoO 30/50, thats like tank oil? you must have high crank pressure 24/7 haha, and then again i wouldnt use the THIN LIGHT oil,

engines pretty worn in at that km's and remember the engine oil goes throught the turbo.. so if you dont want to see blue smoke get something mid range

also I dont know what nissan australia recommend for the vq35 on their aus delivered 350z but the jap/usa v35s use a super light weight low friction oil and weve seen some slight issues with a heavier oil in them here

Nah sorry mate, i think you miss understood what i was saying. I had a skyline r33 low 100k km's just my reccomendations for his.

And also nissan i believe they reccomend 7.5w/30 in the 350z its a semi synthic i think... pretty much watery as.. its not too shabby so i dnt use it.

Also what problems have you seen lol? I've head some burn oil, maybe that super light thin oil justs run pasts the rings lol?

Edited by Mr_GaZZa
Link to comment
https://www.sau.com.au/forums/topic/263318-96-r33-rb25det/#findComment-4510581
Share on other sites

Haha i always seem to create threads that turn into debates :sick:

I think i'll try to Motul 300v chrono oil and see how it goes.

I put in 4.5 litres of oil when i last changed it, so it wasn't full but it was close to it.

I was thinking, as the oil passes through the turbo, maybe it is burning oil? My brother told me he saw a little bit of blue smoke but that was a few weeks ago and he recommended changing the oil to a diff viscosity and it shouldnt burn any....

Anywho, thank you all for your input, i will try a different oil and let you know how it goes!

Link to comment
https://www.sau.com.au/forums/topic/263318-96-r33-rb25det/#findComment-4511522
Share on other sites

and WOHOoO 30/50, thats like tank oil? you must have high crank pressure 24/7 haha, and then again i wouldnt use the THIN LIGHT oil,

engines pretty worn in at that km's and remember the engine oil goes throught the turbo.. so if you dont want to see blue smoke get something mid range

30/50 oil?

If u look again closely, i was saying thats the hot weight a skyline street driver should be looking out

0-15 is the cold weight that a skyline street driver should look at.

i did not mean the cold weight being 30 and the hot weight bbeing 50 :S not even a commodore should be running that!

So far ive been using mobil 1 and ive blown no blue smoke and it doesnt seem to use a drop of oil.

Ive also heard good things about motul 300v chrono.

Link to comment
https://www.sau.com.au/forums/topic/263318-96-r33-rb25det/#findComment-4512560
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • My experience with Rising Sun Exports Before agreeing to the sale I tried to do as much research as I could (obviously), his Facebook reviews are 98% and he goes Live at least once or twice a week. I contacted 2 people in the UK who had used him for their imports, both had positive feedback. His explanation and talk through of the import process was thorough, answering any query no matter how stupid it was. It felt as soon as the money was sent, communication dropped off. I asked for shipping updates every 2 weeks or so, not wanting to pester him, he never had any updates. I wasn't informed the car had been dropped off at the port, I only found out by his Facebook story. I asked for the photos taken at the port, knowing he would need some for insurance purposes. I received a few 5 second clips and that's it. When asked again, he said his staff had them. Weeks later I asked again, he tells me he doesn't have any, but does have 50 photos from the original advert. I never received them. I eventually got the documents sent via WhatsApp after I mentioned the port was requesting them. I purchased a CarVX report, to find out the vehicle is a Grade R with recorded accident damage, first recorded in 2017 when it was first auctioned. He never told me the grade, then again I didn't ask. His response was "Grade R means nothing, it wasn't chassis damage". Still, I would have liked to have been informed about it. Jon prides himself on being open and honest when it comes to inspecting cars, it's his main job doing so at the auctions for customers. When the vehicle arrived in the UK I noticed a few little cosmetic issues. It's a 21 year old car so it wasn't going to be mint condition. The side skirts are cracked on each corner and the sealant is failing. The front grill on the bonnet/hood isn't secured very well, mounting studs are missing. Both minor things, but again, it would have been nice to be told. During a Facebook Live walk around video of the vehicle, he mentioned it has a front Whiteline anti roll bar/sway bar. While on the inspection ramp, I noticed the stock item has been installed. When first questioned, his response was "the ARB? Switched? Since when, it never had them". Since sending video and photo evidence I've not received a response. I'm probably being over critical of the overall condition of an old car, but all I wanted was honesty (which he claims to have). I'm aware I wasn't his only customer, he's busy doing XYZ but other reviews praise him for great communication with regular updates and photos, I felt I didn't receive the same treatment. 
    • I was able to get some underside photos while the car was on the ramp The suspension is all Altezza/IS200/IS300 so getting part's will hopefully be less of a headache
    • Welcome to my 2004 Toyota Mark ii IR-V Fortuna (series 2) With a 1JZ-GTE powerplant under the bonnet (hood) it'll give me plenty of scope for power upgrades. For those who aren't familiar with imports, the 1JZ-GTE is a 2.5L 6 cylinder VVTi engine with a single turbocharger. This has the factory R154 5 speed gearbox, along with a aftermarket 2 way LSD differential (brand unknown). Under the arches are a set of CST Zero 1 alloys, 18x9 +30 225/40 up front and 18x9.5 +15 265/35 on the rear. The car was quite low in Japan and there's evidence of the wheels catching the rolled arches/fenders. The tyre's aren't great so I'm in two minds whether to replace both or just the tyres and put up with the wider wheels on the rear. The car still uses stock brakes with the addition of some braided hoses. The exterior is stock with the exception of a BN Sports front bumper and a replacement Fortuna grill  Moving to the interior, the steering wheel has been replaced with a dished MOMO steering wheel (which will get swapped for my Momo Tuner for the time being) Defi Link Gauges are mounted above the climate controls and on the A pillar, the Oil Temp,Oil Pressure,Water Temp and Boost gauges should help with spirited and track driving  The stock seats have been replaced with some retrimmed Recaro bucket seats. Being a larger build these are a little snug, unfortunately the orange isn't for me so I'll look into replacing these down the line. Other modifications include a twin plate clutch, Blitz intercooler, Evolve alloy radiator, a stainless exhaust with decat, HKS EVC-S boost controller and coil overs
    • Apologies for the long read My R34 GTT was up for sale at the beginning of spring due to a few repairs creeping up. The strut tops needed replacing, roof and bonnet (hood) painting (yay for 3 stage pearl) and the underside stripped and treated. I sold the car which allowed me to be in a much better place financially. Leading up to the sale I was already thinking about the replacement. In an ideal world it needed to be a good all-rounder. Something I can mess around with, modify, do track days, do the school run, go on long drives etc.  Options included but not limited to... Laurel C35, Evo 8/9, Civic FD2, Impreza Hawkeye, Aristo and even an Audi S4 Avant (I've already got the Mazda 6 wagon). But there was always one car at the top of the list The Toyota Mark ii JZX110 I found an advert on a Facebook group for an example in Japan, from a seller called Jon at Rising Sun Exports. A few messages back and forth and Jon calls me from Yokohama one morning (or afternoon in his case). He briefly explained the import process, the costs involved and a repeat of the advert. After much deliberation, the price was agreed and the sale was locked in. I've never imported a vehicle so I jumped into the unknown head first. The money transfer was completed through wise.com (fees apply), very easy to use and the money was with him within a day or two.  The car suspension was raised for the vessel and the car dropped off at the port. It was 7 weeks later when the bill of lading was received and the freight invoice sent to me, followed by the export certificate a couple of days after (both digital copies) In the mean time the port had been in contact. I needed an agent to deal with the NOVA (notification of vehicle arrival) along with the tax/duty invoice, this was £75.00. The port also had a fee of £100, I'm guessing to cover the cost of the 10 day 'free storage' and for moving the car off the boat etc. They need a copy of the vehicle invoice, freight invoice and export certificate to allow the vehicle to pass through customs. The vessel arrived on Tuesday 5th August, the tax/duty invoice was generated and sent over. This is generally tax 20% and duty 10% of the vehicle value. Although the invoice came in at a higher amount than I had calculated. Once HMRC had received the payment the vehicle could be released from customs. I thought once the tax/duty was paid you could collect at any point, that's not the case. Your agent will need to book a collection slot, I requested Thursday 7th which was accepted, with a 9:00am slot allocated. It was a 5:00am start from Norfolk heading to Southampton. We eventually found the compound, upon presenting the bill of lading and some ID they released the car (they drove it out of the compound to the front ready for us to load up). The email from the port stated each slot had a 10 minute window, which seemed abit farfetched but the staff said it's not a strict rule. We were there for approx. 30-40 mins in total. A week prior to collecting I contacted my garage and explained the situation, I was able to get an inspection slot that afternoon. For the registration, DVLA require the car to be insured, for this I used a company called Adrian Flux who can insure the vehicle using the VIN number. 
    • Hey guys, looking for these side skirts if anyone can help me out. 
×
×
  • Create New...