Jump to content
SAU Community

Recommended Posts

When I was working on a road crew we used to use unleaded fuel to remove bitumen from paint work.

The secret is to clean it off with the fuel then wash it immediately with car wash to stop the fuel staining the paint work then re-apply polish over freshly washed area.

Others have recommended orange based cleaners but we found them to be a bit abrasive and prone to scratching duco

Good luck mate

T

Another method is to press ice to bitumen as to freeze it then pick it off with fingernail-like chewing gum on fabric type method

Link to comment
https://www.sau.com.au/forums/topic/265068-blody-roadworks/#findComment-4528655
Share on other sites

Always found Kero was really good at removing tar and other shit that carwashes struggle to get off. i always washed my cars once a month with kero and water. other weeks I used carwash

^^^+1 Absolutely correct!

The chemical formula for Kero is not too different from the tar you're trying to remove!

Analogy:- To remove red wine stains, you use white wine first!

Kero does not harm the paint.

But it does remove most waxes.

I stand corrected by Polish Doc if it's a wrong approach.

Afterwards, you shouldn't need polish (unless there are scratches) - just rewash & then, rewax.

Link to comment
https://www.sau.com.au/forums/topic/265068-blody-roadworks/#findComment-4528976
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • Hope you aren't too sore after that one, might take a day or 2 to notice yet and I guess it is a loooooong drive home. On the bright side, tube frame front end is a thing at superlap, right?
    • https://www.facebook.com/share/p/18rmVb1SKB/ 
    • The chart of front pressure to rear pressure (with one being on the x axis and the other being on the y axis) is not a straight line on a typical proportioning valve. At lower pressures there is a straight line with one slope, and at higher pressures that changes to a lower slope. That creates a bend in the line at that pressure, called the knee point. If you do not change the proportionng as the pressure gets higher, you will suffer excessive pressure (at one end of the car or the other, depending on which way you look at the proportioning action) and then get lockups at that end. The HFM BM57, from my memory of previous discussions, is based on the BM57 from a different car (to a Skyline), with a different requirement for the location of the knee point and the distribution of pressure front to rear, and so is not a good choice for an upgrade on a Skyline. Here's a couple of links to some old posts, one from here, one from elsewhere. A lot of it pertains to adjustable prop valves, but the idea is the same. There are plenty of discussions on here about this issue from al the many years of people wanting a cheap/accessible option. https://grassrootsmotorsports.com/forum/grm/learn-me-brake-proportioning-valves/236880/page1/ https://grassrootsmotorsports.com/forum/grm/learn-me-brake-proportioning-valves/236880/page1/  
    • Yeah dunno why johhny posted that here with no context, just post on FB/insta bro where he put it up?  Laine had an off at T4 during Thurs prac, he's ok, car is less than perfect, they are done for the weekend, he can fill in the rest. Bando also binned it like 100m up the road.   
    • I feel there must have been a FB/insta post and the weekend did not start well at all I hope everyone is all okay
×
×
  • Create New...