Jump to content
SAU Community

Recommended Posts

So after much searching I took the plunge and put the money on a White Series 2 RS FOUR S.

And it arrived on friday. :down: And recieved its first wash and polish today. :(

CIMG0877-1.jpg

CIMG0876.jpg

32.jpg

So far its got.

Adjustable Coilovers (Need to be adjusted higher. At the moment the lowest part of the exhaust is aprox. 105mm. So a bit too close to illegal for comfort)

3" exhaust with cannon (Which will be swapped for a twin tip one eventualy)

HKS Pod Filter

Gready Water Temp. Gauge

Gready Boost Gauge

Blitz Turbo Timer

and an Earthing Kit

Edited by mattye

looks nice and tidy. I really like them in white.

Is the chrome on the rear lights standard? Always thought the s2 lights looked better than the s1 lights but dont particularly want chrome on mine

Very clean Stagea, Well done.

On the topic of the lights, I've found that there's a few different versions, The twin reverse lights type, Cold Weather Pack with rear fog light, but I found a set that has the twin reverse lights but has shadow chrome opposed to the normal shiny chrome. Only seen the one set, any one else seen or have them?

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...