Jump to content
SAU Community

Identifying Engine Bits

paddles

By paddles,
in Engines & Forced Induction

 Share

Recommended Posts

paddles Rookie

paddles

Posted
Posted

Hey Guys,

I'm currently finishing off an rb25det into 260z conversion and there's a few bits on the motor that I'm unsure of. Would love to know what these bits do and if they are necessary (if they aren't necessary it would be nice to tidy things up a bit!).

Any help would be great!

1) Has coolant lines running into and out of it - located on a sammich plate between block and oil filter.

P1040157a.jpg

2) Located on the underside of the inlet manifold, this guy has coolant lines running into and out of it. Also has two wires going into it.

P1040163a.jpg

3) These two connectors are connected to... nothing... To the left of the pic the wires have been cut. What did the wires go to and are they necessary? Had a look at a wiring digram to try and sort this one out but it didn't seem to cover everything.

P1040161a.jpg

Any help would be very much appreciated!

Cheers

Link to comment
https://www.sau.com.au/forums/topic/267625-identifying-engine-bits/
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • MBS206
      NC MX5

      By MBS206 · Posted

      This sounds like someone who would have owned an R33 in their past... It's okay, I'm 100% picking up what you're putting down Mark.
    • MBS206
      Jacks that fit under GTR lips that can reach the subframe?

      By MBS206 · Posted

      Just back on what was raised about jacking off the the tow/tie down point on the front of cars. I've used it plenty. I've also watched it on a car where you could see it move the front end of the car. It was like the front end/whole car being tweaked and twisted a bit. I will say, I struggle to find good jacking points on MOST cars. The ones that have good points, I then normally struggle to find a jack tall enough to make the car change height!   One of my go to points for either the jack, or the axel stands though, is either a suspension pickup point, OR a subframe to chassis major bolting point. I actually think its the subframe on my R33 that has a bit of a bend in it, from being jacked in the middle too. However, it could have been one of my many other cars I've had over the years! Or it could also be the from me jacking it up, and the fact the top of the front radiator support isn't there, so it can allow the front of the car to move and bend etc.
    • GTSBoy
      M35 Aftermarket Fuel Pump

      By GTSBoy · Posted

      My apologies. I forgot we were talking about weird beard M series stuff. Had been talking elsewhere with someone about an R33 with similar subject and got confused.
    • The Bogan
      NC MX5

      By The Bogan · Posted

      Nope, I don't like the look of ND RF, or any ND really, I don't like their faces or arses, why, because of their "modern" lines, the NC, whilst "modernish" has a more rounded shape that I like Well, that's how my overly judgemental eyes see it anyway  
    • Dose Pipe Sutututu
      M35 Aftermarket Fuel Pump

      By Dose Pipe Sutututu · Posted

      Should be more than fine, especially the overall fuel pressure would never exceed 3.5bar (assuming that thing never gets more than 0.5bar of boost in stock form). According to the chart, it's 11amps.
×
×
  • Create New...