Jump to content
SAU Community

Recommended Posts

Hmm, neither JJR or Yellow Jacket make coils to suit NEO engines yet. So that means that the only coilpack options available to series 2 owners are OEM Nissan coilpacks (not REALLLY an option, in my case at least, at $1000+) or Splitfires.

...or chop up your $200 coilpack harness and wire in different coils...

can someone suggest any other solutions for S2 owners?

just shell out for the splitfires, they aren't really that expensive for a proven good product when you consider it (half the cost of new OEM). your only other option is to run a butchered setup like you said, either in the form of a wasted spark 3/2 coils setup (falcon/commodore) or 6 single coils in a sequential setup which could end up costing the same as getting the splitfires.

Pepople have gone off the wasted spark option over here for various reasons. The other option is to isolate the dud coil or coils and get some second hand stockers. People often replace the lot when some are fine. Someone on this forum had a set of S2 coils a while back (can't remember who, sorry). I guess i'm lucky - still on original coils at 225awkw at 16 psi and up to 7200rev/min.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Well the install is officially done. Filled with fluid and bled it today, but didn't get a chance to take it on a test drive. I'll throw some final pics of the lines and whatnot but you can definitely install a DMAX rack in an R33 with pretty minor mods. I think the only other thing I had to do that isn't documented here is grind a bit of the larger banjo fitting to get it to clear since the banjos are grouped much tighter on the DMAX rack. Also the dust boots from a R33 do not fit either fyi, so if you end up doing this install for whatever reason you'll need to grab those too. One caveat with buying the S15 dust boots however is that the clamps are too small to fit on the R33 inner tie rod since they're much thicker so keep the old clamps around. The boots also twist a bit when adjusting toe but it's not a big deal. No issues or leaks so far, steering feels good and it looks like there's a bit more lock now than I had before. Getting an alignment on Saturday so I'll see how it feels then but seems like it'll be good to go       
    • I don't get in here much anymore but I can help you with this.   The hole is a vent (air relief) for the brake proportioning valve, which is built into the master cylinder.    The bad news is that if brake fluid is leaking from that hole then it's getting past the proportioning valve seals.   The really bad news is that no spare parts are available for the proportioning valve either from Nissan or after market.     It's a bit of a PITA getting the proportioning valve out of the master cylinder body anyway but, fortunately, leaks from that area are rare in my experience. BTW, if those are copper (as such) brake lines you should get rid of them.    Bundy (steel) tube is a far better choice (and legal  in Australia - if that's where you are).
    • EMU Classic. For what I need it to do I see no reason to upgrade. Link and Haltech would both cost an extra chunk of money for a lot of unutilized features
×
×
  • Create New...