Jump to content
SAU Community

Recommended Posts

Make: Nissan

Model: Skyline R33 GTST

Milage: 115,000

Transmission: Manual

Colour: Maroon

Location: Canberra

Currently registered? Yes - NSW Rego

Full insurance.

Regular service from Trojan, Autotech Canberra and Overdrive performance Braidwood

Price: $14,000 ono

Contact: J on 0412 097 311 or PM me.

Reason for selling: Moving to the USA. (selling everything).

Comments / Modifications:

Below is a list of all the modifications that have been done to the car, making well over 350rwkws. If there are any questions please feel free to pm me or give me a call on my mobile. I'll do my best to answer them but I'm no grease monkey.

Pics are already on the forum from when I bought it early last year.

1995 dec built r33 gtst, 115000kms,

ECU/Engine/Exhaust

350rwkws

APEXi power FC with H/C

Garrett T04Z 800HP twin ball bearing turbo.

Turbo smart 45mm waste gate with dump to atmosphere.

6 boost high flow exhaust manafold

Trust type-R BOV

Tomei 264 in/ex camshafts

Tomei 280L/H Fuel pump

NISMO 550cc injectors (This is what he was told when he purchased the car, but when the car was dyno'd the tunner said they were more likely 660cc)

NISMO Fuel regulator

NISMO Oil cap

Fujitsubo 3.1/2in exhaust with high flow cat

3 1/2in custom dump

Greddy Exhaust Adjustable Cam Gear.

Greddy Engine Oil Cooler

Greddy Oil Catch Can

Greddy Intake Plenum

Greddy Profec B boost controller

Port and polished RB25DET head

Q45 Throttle Boddy 90mm

Q45 AFM 90mm

Suction and cooling

APEXI power Intake

TRUST V-SPL Intercooler kit

Drivetrain

C's Quickshift kit

OS Giken Twin Plate Cllutch with lighten Flywheel

NISMO Oversixe slave clutch cylinder

Handling

Tomi Brake Master Cylinder Brace

FET Strut Tower Brace(f)

CUSCO Strut Tower Braces ®

DBA Drill and Slotted Roters (F&R)

Bilstein Strut and Whinelint Spring

Section HICAPS Lock Bar

Whiteline Handling Pack

Whiteline Urethene suspension bushes (F&R)

Whiteline anti-roll bars (F&R)

Interior

APEXI EL Mechanical Boost Gauge

APEXI RSV with DIY shift light

MOMO Steering Wheel

MOMO Gear Knob

Pioneer MP3 Head Unit with Pioneer Speakers/Spliters (F&R)

New Clarion AMP

Alpine 12'' sub woofer.

Exterior

R33 GT-R Front Bar with indicators

R33 GT-R style Rear Wing

R33 GT-R Style side skirt

3 Point immobiliser Alarm

Hi All.

Thanks for the interest...all PMs replied to.

Forgot to mention it still has 10 months rego on it.

Or nearest offer - I'd like to get the car sold asap - overseas awaits.

Cheers.

  • 3 weeks later...
  • 4 weeks later...
  • 1 month later...
Guest
This topic is now closed to further replies.


  • Similar Content

  • Latest Posts

    • Ok so after much research and talking with knowledgeable people I've got my turbo conversion done and it's all running great other than 1 small issue.  Car has remained auto with the na auto and tcm, I've used a stagea ecu with. NIstune board and everything is great other than my gear selection on the dash. It illuminates park, reverse, neutral, 3rd and 2nd. But nothing drive or what gear your in when you pop it into tiptronic.  I'm sure there is may e 1 wire in the ecu plug I need to move to rectify this. Dose anyone here have any ideas?   Cheers guys
    • Sorry I haven't been following all the detail, so you may have tried this. Does it idle with the tiniest bit of throttle you can add? You've mentioned the IACV, does it have an AAC valve and have you adjusted it at all (ie, screw the idle adjust screw all the way in, then back it out a couple of turns until idle is stable)?
    • My bad, I unplugged the one underlined in red instead of yellow before. With the car started, after unplugging the IACV (the one underlined in yellow), it idled at around 400/500 for 3 seconds before stalling. Attempting to start the car without the IACV will not start the car.   It does stutter and sputter for around 5 seconds before dying. However, immediately after starting it, you can already hear some slight sputters from the exhaust.   It won't start with the AFM unplugged. If it is when the car has already started, it stalls in a few seconds.   Yesterday, I did take some logs using Nistune of 3 scenarios. Car idling till it stalls Car idling and unplugging the IACV Car idling and removing the AFM I also have some previous logs of when the Car is idling till it stalls and when driving and it cuts. I am not really knowledgeable enough to understand what to look for. After every test, car idles rougher and rougher, until I have to stop. It will be fine the day after.
    • There is no difference between a 17x8 and an 18x8. The total diameter of the tyre needs to remain +/- the same (so you don't mess up the gearing, speedo reading, and clearance when turning front wheels..... so you just need to use a lower profile tyre on th 18 than you do on the 17. /rocket surgery.
    • I thought the same to start with. But then I thought it was one of those LCAs where the end of the ARB goes through a bushing in the LCA itself, instead of having an end link.
×
×
  • Create New...