Jump to content
SAU Community

Problem With Microtech

mad082

By mad082,
in Engines & Forced Induction

 Share

Recommended Posts

mad082 Grand Master

mad082

Posted
Posted

ok i'm posting this up for a mate.

he has just wired a microtech (not sure on number but it is a LT, not LTX) into his ceffy (turbo rb25) and isn't getting spark... sort of. when it does all the self test it comes up fine. now i'll start the story from the start....

when he first bought it it was wired up for wasted spark but when he hooked it up it fried the drivers in the ecu. so he sent it away to microtech and got it fixed and was supposedly bench tested and worked fine. he has now got it back and wired up for normal spark. when he uses th stock s2 coils he gets no spark. when he uses rb20 coils with an ignitor he gets no spark, but when he uses rb20 coils and no ignitor he gets spark (he only has 1 rb20 coil though). he has gone over the wiring with a multimeter and test light and everything is getting enough voltage to fire but it won't. anyone got any ideas on why it won't run with the s2 coils. he was under the impression that the LTX had a built in ignitor but the LT didn't.

pretty much been over everything we could think of so throw out any ideas you have

Link to comment
https://www.sau.com.au/forums/topic/274689-problem-with-microtech/
Share on other sites
mad082 Grand Master

mad082

Posted
  • Author
Posted

ok just double checked the model number. it's a LT12S. he also rang up a tuning company this morning to double check the compatiability of using the stock coils and they agreed it should work fine.

he has wired up and tuned a few microtechs in the past so it isn't a lack of knowledge issue.

The Dan Grand Master

The Dan

Posted
Posted
ok just double checked the model number. it's a LT12S. he also rang up a tuning company this morning to double check the compatiability of using the stock coils and they agreed it should work fine.

he has wired up and tuned a few microtechs in the past so it isn't a lack of knowledge issue.

RB20 (S1 33 coils) and S2 33 coils are wired differently.

Can you please post up a MSPAINT wiring diagram of how they are wired ie. which wires (colours or output numbers from ECU) are going to which wires on the coilpack

mad082 Grand Master

mad082

Posted
  • Author
Posted

yeah he has emailed microtechefi.com (and not microtech-efi.com which is actually mazfix which i think was who fixed the board last time) and has sent the ecu away to them. they suspect the ecu may have had a LTX board put in it and not had the sticker changed when it was fixed last time because of the fact that it will spark without an ignitor but not with an ignitor.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • bilbo117
      R34 GTR Seats / No longer reclining

      By bilbo117 · Posted

      Hi all, Long time since I've posted here. Looking for some advice on what I can remove to further identify the cause of my issues.  I can move the passenger seat forward and back but the knob used to adjust the seat angle is pretty much free spinning, there's very little resistance.  Removing the side cover I can see that the chain is intact but the shaft for the adjustment spins without the gear attached to it moving.  What's my next step for disassembly here? Is this a common fault? Just being a little cautious as I didn't want to start removing bolts for a spring to fly out or something equally as stupid.  Cheers
    • Dose Pipe Sutututu
      Ethanol Content Sensor - Always at 11%?

      By Dose Pipe Sutututu · Posted

      Those above shitboxes, mediocre and above usually have a turbo strapped to them, hence the slightly higher octane is required.  
    • sinn3r
      R34 Skyline climate control unit transistor

      By sinn3r · Posted

      Hi all,   long time listener, first time caller   i was wondering if anyone can help me identify a transistor on the climate control unit board that decided to fry itself   I've circled it in the attached photo   any help would be appreciated
    • Kinkstaah
      Blue slip

      By Kinkstaah · Posted

      I mean, I got two VASS engineers to refuse to cert my own coilovers stating those very laws. Appendix B makes it pretty clear what it considers 'Variable Suspension' to be. In my lived experience they can't certify something that isn't actually in the list as something that requires certification. In the VASS engineering checklist they have to complete (LS3/NCOP11) and sign on there is nothing there. All the references inside NCOP11 state that if it's variable by the driver that height needs to maintain 100mm while the car is in motion. It states the car is lowered lowering blocks and other types of things are acceptable. Dialling out a shock is about as 'user adjustable' as changing any other suspension component lol. I wanted to have it signed off to dissuade HWP and RWC testers to state the suspension is legal to avoid having this discussion with them. The real problem is that Police and RWC/Pink/Blue slip people will say it needs engineering, and the engineers will state it doesn't need engineering. It is hugely irritating when aforementioned people get all "i know the rules mate feck off" when they don't, and the actual engineers are pleasant as all hell and do know the rules. Cars failing RWC for things that aren't listed in the RWC requirements is another thing here entirely!
    • GTSBoy
      Best place to order Authetic R32 Parts in Japan

      By GTSBoy · Posted

      I don't. I mean, mine's not a GTR, but it is a 32 with a lot of GTR stuff on it. But regardless, I typically buy from local suppliers. Getting stuff from Japan is seldom worth the pain. Buying from RHDJapan usually ends up in the final total of your basket being about double what you thought it would be, after all the bullshit fees and such are added on.
×
×
  • Create New...