Jump to content
SAU Community

Recommended Posts

  • Replies 40
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

Thats been for sale for quite awhile...... I wonder why it hasnt sold.

Someone had too much time on their hand.

But hey its currently at $2.5k - spray it matte black, rebuild the engine and got a somewhat cheap-ish R32 track car.

Link to comment
https://www.sau.com.au/forums/topic/275344-what-the-hell/#findComment-4665213
Share on other sites

did the head gasket get attacked by barney :D

repray idea aint half bad, id daily it matt black :P didnt see it mention na or turbo

lols to below guess i didnt read that much into it. then again wouldnt be the 1st car i see without turbz with a fmic

Edited by Inline 6
Link to comment
https://www.sau.com.au/forums/topic/275344-what-the-hell/#findComment-4665260
Share on other sites

Thats been for sale for quite awhile...... I wonder why it hasnt sold.

Someone had too much time on their hand.

But hey its currently at $2.5k - spray it matte black, rebuild the engine and got a somewhat cheap-ish R32 track car.

yeah, if i had the cash I'd buy it :D chuck in a 26/30, use it as a 'shit my pants' track car

-D

Link to comment
https://www.sau.com.au/forums/topic/275344-what-the-hell/#findComment-4665355
Share on other sites

would look like a can aswell, could get 10c from the depo these days for it

Or maybe you could cut it into several pieces and get more?

that is until you take the shrapnel down to the depot and the dude is like, is that a headlight switch in that can?

You could always try Sims.

Link to comment
https://www.sau.com.au/forums/topic/275344-what-the-hell/#findComment-4665374
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Hopefully it ends up being something manageable, like a hone, rather than a full bore—it would be a huge relief if it’s not as bad as it looks. Hang in there; these setbacks are annoying, but it sounds like you’re handling it as smartly as possible.
    • At the end of the day, it’s all about understanding the odds and being comfortable with the potential cost, whether it’s horsepower on a build or chips on a roulette table. And I have to say, the Laine example made me laugh—some people really do embrace that carefree, “roll and see” attitude!
    • Thanks MBS206, i got that PDF but got abit overhelm with all the connections and tracing of wires. I wasn't expecting to plug the dash harness anywhere. i was just going to use my electronics jumper wires to plug into the right pins like ECU power, ecu ground, ignition trigger etc... I do have a few ratchet straps locking it down tight. Fire extinguisher ready and only a small amount of fuel at a time, enough to submerge the pump.
    • Thanks GTSBoy, i will do abit more digging. I am missing a blue relay near the ECU connector... so i will chase that up in the next few days as well  
    • https://yariksteel.ru/manual/R33/Skyline_R33_elektroprovodka.pdf   Page 18 should be what you want for the Dash Cluster wiring. Though, you don't need the dash plugged in to get the motor running. What you want is power as how GTSBoy said. You need to power the ECU. Find in the above link the ECU pin outs (Verify them before just connecting them up from things written on the internet). Find anything needing power, give it power, find anything needing ground, give it ground. Then give the starter motor power through a big cable, and bridge the solenoid on the starter straight to power too.  ECU will be on, and when you give the starter power, it'll spin the starter motor, and it should start. I also hope you have a proper stand, and not just the engine sitting on some wood. You will want it bolted down properly.
×
×
  • Create New...