Jump to content
SAU Community

Recommended Posts

Hi all,

Im putting in a new head unit in my brothers Volvo haha V40. Went with entry level alpine unit with hi-speed ipod control from Tonkins (cheers Ben :) )

The old unit didnt have a constant power to it just to acc powers and 2 grounds (WTF stupid germans). Where will be the easiest place to steal constant power from? The ciggie lighter is acc aswell :P Im thinking maybe the ignition itself would be the shortest to run a cable and their must be constant power their. Any ideas?

I really CBF running a line direct from the battery and fusing it...

Also the stock headunit controlled all 6 speakers (4 2 ways i think and 2 tweaters) the alpine unit ive hooked up to the 4 speakers is their anyway i can hook up the tweeters aswell without buying more gear cos hes a full on tight ass when it comes to his car. as long as its got fuel and a few empty iced coffee cartons floating in it he's happy :down:

Cheers,

Chris

Link to comment
https://www.sau.com.au/forums/topic/275391-head-unit-install-in-brothers-car/
Share on other sites

Hi all,

Im putting in a new head unit in my brothers Volvo haha V40. Went with entry level alpine unit with hi-speed ipod control from Tonkins (cheers Ben :) )

The old unit didnt have a constant power to it just to acc powers and 2 grounds (WTF stupid germans). Where will be the easiest place to steal constant power from? The ciggie lighter is acc aswell :P Im thinking maybe the ignition itself would be the shortest to run a cable and their must be constant power their. Any ideas?

I really CBF running a line direct from the battery and fusing it...

Also the stock headunit controlled all 6 speakers (4 2 ways i think and 2 tweaters) the alpine unit ive hooked up to the 4 speakers is their anyway i can hook up the tweeters aswell without buying more gear cos hes a full on tight ass when it comes to his car. as long as its got fuel and a few empty iced coffee cartons floating in it he's happy :down:

Cheers,

Chris

wrong area mate

http://www.skylinesaustralia.com/forums/Ca...ecurity-f9.html

post audio here

the car has two grounds????, one is a light switch which shows ground until the lights are turned on, then goes to 12volts if you use a test meter ?

this is a volvo wiring diagram, check your model here

http://www.volvoclub.org.uk/faq/MaintenanceManuals.html

Main radio harness 13-pin connector (for large 14-pin radio connector):

pin 1 (brown/white) left dash speaker (+)

pin 2 (grey/red) right dash speaker (+)

pin 3 (brown) left dash speaker (-)

pin 4 (grey) right dash speaker (-)

pin 6 (yellow/white pair) night dimmer (from headlight switch & relay)

pin 7 (white) dash dimmer (+) (connected to dash lighting rheostat)

pin 8 (blue) dash dimmer (-)

pin 9 (green/red pair) +12v from battery (and to optional CD player)

pin 10 (black pair) chassis ground

pin 11 (orange) +12v from ignition (via fuse 14)

pin 12 (green/grey) power antenna motor control output (switched on/off with radio on/off) or power for in-window antenna amplifier (see note below)

pins 5,13 (not connected)

Speaker harness 13-pin connector (from small 10-pin radio connector):

pin 2 (green/orange) left front door +

pin 6 (orange/black) left front door -

pin 3 (orange/white) right front +

pin 7 (black/orange) right front -

pin 8 (blue/pink) left rear +

pin 12 (brown/pink) left rear -

pin 9 (pink/white) right rear +

pin 13 (pink/black) right rear -

pins 1,4,5,10,11 (not connected)

funny enough I answer questions in the audio forum part, and so does chris rogers and a few others...lol

http://www.the12volt.com/installbay/vehicl...eard/Volvo.html

your guide is located here, pm me if you need help still, cheers

see it says Chasis ground plack pair?

So i should look for green/red for the constant 12V

What about the illumination/dimmer on the unit what one of those do i use?

mate , use a multimeter to test it, guides can be wrong and I take no responsibility if you fry a radio, set off the airbag, or toast the car computer with a test light.

if your not sure have it installed by a pro installer. what part of town do you live in ? I might be able to test the wires for you time permitting?

Jack 88 on here does mobile installs, pm him

check to see if you have a dash clock, dome light ? I would suss you have a blown fuse off the constant power wire. you dont need to run a wire to the battery on new car?

check the fuses

is there anything else on the dash that doesnt work ? or has anyone hacked up the harness before ?

if all else fails, I would take it somewhere to have it looked at, to cut into the main harness to solder one on is best left to someone who knows what to do, there is a wire in the steering wheel area and possibly elsewhere depending on the year that contains the airbag, ground it out and bang the airbag goes off with your face mm from it.

best of luck, but check the fuses as above , if the car electrical is working properly, you shouldnt have trouble finding constant power near the radio

do not circumvent a fuse,or increase the amp rating .. fix it right or risk fire

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yes I can see how that would put you off HFM, especially with the price of good quality brake fluid. From what I understand it as you say the BM50 is the standard BMC for a R32 GTR, I must admit I would like to go far a Genuine Nissan BM57, but lack of cash prevents that at present. With the price being so close between the genuine BM50 and BM57 a BM57 New it seems a better choice as you gain that 1/16 bore size with the BM57, I would be interested in how much difference you feel with the BM57 fitted. I am going to take SteveL's advice in the short term and see how much actually comes out of that proportioning valve vent and save up for the Genuine Nissan part. Thanks for clarifying the HFM failure
    • Thanks mate. I just got the post inspection 1/2 done from state roads when the starter motor packed up, either that or the car alarm system is having trouble.  OEM part number 23300-AA112.
    • Hi, I though I was coming to an end in finding a replacement starter motor for a rb25de neo. I came across a starter motor from Taarks and a message below stating: Direct fit. 11 Tooth count. All below part numbers have been superseded to 11 teeth. Can some body shed some light on going from 8 teeth to 11 teeth apart from 36-month / 25,000 km warranty for passenger vehicles to 12 Month Warranty. Compatible with the following Nissan part numbers: 23300-20P00 23300-20P01 23300-20P05 23300-20P10 23300-20P11 23300-AA111 23300-AA112 23300-AA300 23300-08U10 23300-08U11 23300-08U15  
    • Low battery? Maybe check capacity? I know first-hand, on BMWs if your battery drops below 80% capacity, it starts causing strange issues.
    • 8.5 +37 = should fit rear, but I think it'll hit on front. What you want is low 30s/high 20's front, mid 30's rear. That 17" screenshot you posted looks good, I'd run it on my R32 (but that's long dead now). For tyre sizes, my rule of thumb is: 8': 235, 9": 255. But that's just my opinion. Nismo sizes: 18x8.5+35/18x9.5+38 is a good starting point.
×
×
  • Create New...