Jump to content
SAU Community

Recommended Posts

Hey everyone,

Have my 1991 180sx for sale it has as follows:

143,000 kms redtop motor (oil changed every 5000Kms)

New Exedy heavy duty clutch (replaced 1500kms ago + new gearbox oil)

Full 5 stud conversion with R32 GTS front and rear brakes. Conversion done with S14 lower control arms at front and R33 handbrake cables at rear.

Also has Uras Super sticky rear handbrake shoes.

S15 wheels. Rubber on front 90%, back 60% (not from burnouts just the front wore out quicker)

Suspension is Kings springs with KYB AGX adjustable shocks (full strut leg replacement).

Genuine ARC airbox,

GT28 Turbo (bought from Just jap 1000 kms ago)

Gktech Dump Pipe, then full 3 inch exhaust (extra resonator put in to keep quiet)

Braided oil and water lines to the turbo.

Full genuine Type X kit, (took ages to find, parts from japan, adelaide etc)

Genuine Type X rear lights.

Full respray in two pack red, with black roof, guards professionally flared out and smoothed to perfection

Type X front seats

Momo steering wheel (320mm)

HKS evc 2 Electronic boost controller

Focal sound gear (splits and rear speakers) with sony deck.

Genuine Ganador electric mirrors

Rego due 15 Sept 2009

I would not have given up this car accept for the fact that we needed a bigger car. Have a 6 month old and need to fit him in the car easily. The 180 was not getting driven much other than to work 1-2 days a week.

Problems with car are, (have to disclose before anyone comes out)

Some the sphincter of the universe backed into front bar with tow ball and cracked paint, so front bar will need to be touched up or resprayed. (only paint damage, bar is ok)

Dash board has few cracks in it, (but do have a cool dash mat to cover it).

Car runs great, but sometimes idle does drop low under brakes. So will need a service.

I also have some spare parts for the car, I can offer these for free to the buyer depending upon the price that the vehicle is sold for (see below for price):

B&M short shifter, (Paid $390)

White line rear adjustable control arms both top and bottom. (Paid $400)

extra front lip to go under the Type X front bar. (Paid $400)

Am hoping for around $7800 for the car (this would include the above parts). I was initially seeking more for the car before I realised that the bar needs to be sprayed and the car needs a service etc. Will consider all serious offers.

So if anyone likes the car shoot through a pm or any questions and i will answer.

And I live around the Blacktown area (Western Sydney, NSW)

Thankyou for your time

Matt

Photos are to follow:

post-24273-1246781302_thumb.jpg

post-24273-1246781381_thumb.jpg

post-24273-1246781455_thumb.jpg

post-24273-1246781536_thumb.jpg

post-24273-1246781637_thumb.jpg

post-24273-1246781711_thumb.jpg

post-24273-1246781786_thumb.jpg

post-24273-1246781867_thumb.jpg

Edited by Gassed up
Link to comment
https://www.sau.com.au/forums/topic/277836-1991-180sx-red/
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Apologies for the long post, but needed somewhere to lay out the entire timeline of events and actions taken:   I've got an 89 GTR with a R34 RB in it. It's been running great all year, driven probably 500KM in the last month. It's not my daily driver, just a weekend fun car.    Build info: R34 RB26 - HKS 2.7 stroker kit, HKS adjustable cam gears, HKS turbo upgrades, Trust intercooler, R34 factory DENSO 440cc injectors, JUN chipped/tuned R32 ECU. All of this work was performed in Japan back in 2019.    Thursday 10/2/25 - It's a nice day and decided I'll drive it to work, I start it up in the garage and I notice it took a few extra cranks and sounded a bit funny. I figure maybe it was just because it was a pretty chilly morning. I pull it out into the driveway to warm up a bit before leaving. As I leave the driveway, it feels very off and sounds like a misfire. I pull it back in the garage to deal with after work and take the daily to work. I was able to diagnose it as a cylinder 5 misfire with the old spark plug test (unplugging each plug until a sound change with the engine running). I take off the whole ignition system, ignitor, plugs, spark. *Important note, it is still on the R32 ignition system with the separate ignitor system. I test each system with a multi-meter and nothing presents as a smoking gun. I put it all back together and it starts up no issue. I go ahead and order the PRP R35 ignition conversion kit. It should arrive today (10/13/25)   Friday 10/3/25 - Another nice day, car starts up great and drives great all day. Very pleased that everything seems to be OK   Sunday 10/5/25 - Decided I'll take it to play some golf, load up and drive to the course about 25 minutes away. Drives wonderful the whole way there, I pull in the parking lot and the engine completely comes to a stop. I do not recall if it sputtered at all, but just remember all of the sudden the engine was off. I roll it into a parking spot, try to crank it back on and nothing.  It'll crank and crank and not even try to start. End up getting it towed back to my house and push it up into the garage.    Items I have checked: Fuel in the tank Fuel Pump relay Fuel pump fuse  Spark Plugs & gap Coil packs Ignitor    I know the cylinders are getting fuel as the plugs smell like fuel after a start attempt. I tried spraying starter fluid into the manifold and cranking and not even a sputter.    I decided to do the live CAS test (removing the the CAS, ignition on and spinning the CAS stalk to see if the injectors pulse and spark is active). All of the injectors were pulsing and I have spark at the plug. The half-moon end of the CAS did seem very loose, I'm not sure how much play is supposed to be there, but it was more than I expected. There was no in/out play of the shaft, just the tip end that is pinned on had quite a bit of play.    CAS Play video   When I put the CAS back in, I stupidly did not re-time the engine. I know I need to do that tonight, however, I do not think it will start given it seemingly was not the issue. My plan is to do the PRP R35 coil kit and retime the engine at the same time.    I plan on ordering the Haltech Nexus Plug-in ECU once they are available again, but ideally would like to get this sorted before firing the parts cannon at it and potentially adding more variables.    Anything glaring that I am missing here, I'm a bit at a loss?          
    • Get it on a dyno. Get something logging Consult. Run it up and find out what is causing it.
    • Looking for a plenum for rb25 de+t neo  Not looking to push much power maybe 300kw at the wheels, is there much difference in flow for Freddy “Greddy style” compared to original Greddy or options like Proflow or Otaku garage?    I won’t be porting the de Neo head for now as I think it’ll be fine 280-300rwkw but appreciate the help and any experiences anyone has between them and any advice. Thanks  Looking at this plenum for now below 
    • engine wise almost no mods: stock ecu Greddy front mount intercooler Greddy forward facing intake w R33 TB stock fuel system, stock injectors, rail etc. Kakimoto racing hyper 3 inch exhaust system Apexi intake filter New NGK –R BCPRES (.8 gap) plugs  
    • Nice one @Pac - looks like a fair few 1600's there! 
×
×
  • Create New...