Jump to content
SAU Community

Recommended Posts

I have a R31 Nissan Skyline 1989 sedan which is overheating. I have checked the water pump and it is fine and i have replaced the thermostat. It has new radiator fluid and all belts have been replaced. Oil changed and correct level. Does anyone know what could be causing it to overheat. I have thought about replacing the radiator cap but apart from that i'm not sure what else i can do. Regards, Rob Lane. :D

Link to comment
https://www.sau.com.au/forums/topic/278636-overheating-issues/
Share on other sites

It's not a blocked radiator or a blown head gasket because i've had the radiator cleaned and flushed and the head gasket has gone and i fixed it. I think the only thing it can be now is the fan clutch as i've checked everything else. New thermostat, radiator good, water pump good, new belts. Anyone think of any other possibilities? Regards, Rob.

i would say yeh the fan clutch as youve eliminated everything else does ur clutch fan seem loose (worn out) eg. with the engine going can u stop the clutch fan? (use something like a rag to stop it)

anyway should only be like $30 for a second hand clutch fan

another suggestion may be the stock guage is reading wrong like most skylines

try an aftermarket gauge as itll be tons more accurate

Defective fan clutches are a common and often overlooked cause of overheating. The sheer characteristics of the clutch fluid gradually deteriorates over time, with an average loss in drive efficiency of about 200 rpm per year. Eventually slippage reaches the point where effective cooling is no longer possible and overheating results. On average, the life of a fan clutch is about the same as a water pump. If one needs to be replaced, the other usually does too.

Sometimes a lower radiator hose will collapse under vacuum at high speed and restrict the flow of coolant from the radiator into the engine. This can happen if the reinforcing spring inside the hose is missing or damaged.

Also, if the coolant is overflowing from the overflow tank, replace the radiator cap.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • This sounds like someone who would have owned an R33 in their past... It's okay, I'm 100% picking up what you're putting down Mark.
    • Just back on what was raised about jacking off the the tow/tie down point on the front of cars. I've used it plenty. I've also watched it on a car where you could see it move the front end of the car. It was like the front end/whole car being tweaked and twisted a bit. I will say, I struggle to find good jacking points on MOST cars. The ones that have good points, I then normally struggle to find a jack tall enough to make the car change height!   One of my go to points for either the jack, or the axel stands though, is either a suspension pickup point, OR a subframe to chassis major bolting point. I actually think its the subframe on my R33 that has a bit of a bend in it, from being jacked in the middle too. However, it could have been one of my many other cars I've had over the years! Or it could also be the from me jacking it up, and the fact the top of the front radiator support isn't there, so it can allow the front of the car to move and bend etc.
    • My apologies. I forgot we were talking about weird beard M series stuff. Had been talking elsewhere with someone about an R33 with similar subject and got confused.
    • Nope, I don't like the look of ND RF, or any ND really, I don't like their faces or arses, why, because of their "modern" lines, the NC, whilst "modernish" has a more rounded shape that I like Well, that's how my overly judgemental eyes see it anyway  
    • Should be more than fine, especially the overall fuel pressure would never exceed 3.5bar (assuming that thing never gets more than 0.5bar of boost in stock form). According to the chart, it's 11amps.
×
×
  • Create New...