Jump to content
SAU Community

Recommended Posts

Engine

Forged Pistons

Forged Rods

Performance rings

Balanced and blue printed block

Ported head

Billet crank

Kevlar timing belt

Tensioned valve springs

550cc injectors

HKS Cams

HKS Cam gears

HKS Silicon hoses

HKS Duel dump pipe

HKS 3 layer head gasket

HKS POD filter

GFB BOV

Engine resprayed candy apple red

Intake

Upgraded roller bearing turbo

Z32 AFM

R33 radiator

Big cooler

Thermo fans

Stainless induction

Powder coated black cooler pipes

Driveline

OS Giken custom clutch

Lightened fly wheel

2 way mechanical LSD (Cusco I think)

Fully adjustable JIC Gold coilovers

Exhaust

Blitz NUR-Spec 3" stainless exhaust

Interior gadgets

HKS incab duel stage boost control

HKS Turbo timer

HKS Boost gauge

HKS Stainless shifter

Momo steering wheel

Recaro adjustable back race seat

HUD (speedo on windscreen)

Black wired alarm

Keyless entry

Electric windows

Full stereo including sub and amp

Origional 180sx floor mats

ECU

Dr Drift tuned ECU

Suspension etc

Strut brace

Nolathane bushes etc

P1 Buddy light weight race rims

Upgraded cross drilled disks

Upgraded callipers

Project Nu race pads

Body

Car resprayed Polar White

C-West front bar

Buddy club side skirts (I think)

Vertex rear bar (I think)

Shaved rear wing

Type x tail light and centre

I've just paid a years rego.

If you'd like any info just ask.

I'm looking for $13,000

Will neg for serious buyer

The car puts out close to 250rwkw on an aggresive tune, I drive it around at 170rwkw because it's just used to get me too and from work.

n586867363_1826830_4443285.jpg

4435_85669702363_586867363_1826822_2892650_n.jpg

Link to comment
https://www.sau.com.au/forums/topic/283331-180sx/
Share on other sites

  • 2 weeks later...

G'day mate, it's an 89 model so it's a ca18, great on fuel and massive amounts of torque, it's above 600nm on a high tune.

I dont have reciepts for the work unfortunately due to a horrible house move where i ended up living in a shed for 4 weeks!

The turbo is a modified Garret roller bearing turbo, I'm only running 12psi as it's only used as a daily driver, it sure makes some noise when it's boosting!

Im located in Ballarat Victoria, about an hour from Melbourne.

Link to comment
https://www.sau.com.au/forums/topic/283331-180sx/#findComment-4791155
Share on other sites

  • 2 weeks later...
  • 1 month later...
  • 2 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • What copper washer do you guys use on the bleeder bolts? The existing one I have I had no idea where to find it in a local store, I did buy some online but that are only 1mm thick whereas my old one is 2mm+ thick and when I put the new washer out and squeeze the top radiator hose I can hear a bit of air but not with the old one. Does this matter? The new one doesn't leak, but the inner diameter is a bit loose whereas the old one threads on the bolt.
    • Howdy all, after being out a few weeks ago on a spirited drive in my GTR I have 2 issues that oddly have appeared at the same time. Whilst accelerating quickly through the gears all of a sudden i’ve lost power at the top of third gear (below redline around 6000rpm) for no obvious reason.    From that point onwards the car has been running rich on idle, won’t really rev under load without a ton of black smoke and the odd backfire, and dying as a pull up to a set of lights unless I keep the revs up around 1500rpm. In addition when shutting down the car that same night (I was 10 minutes from home) I noticed one of the turbos was significantly noisy on wind down when shutting off the engine. After letting the car cool down overnight it starts up fine, although once it gets to temp the revs start to creep up and down, the exhaust is darker than it should be and it also sounds like it’s running rich (fat note) I’ve put a new set of plugs in it - no change, the old plugs all seemed OK with two of them being somewhat richer/fueled up than the other 3 with 1 being borderline. I’ve smoked tested the intake system via the front of the Turbos, found a split vacuum hose going to the factory boost gauge sender, which I have since replaced.  Also found another leak on the gasket coming off the rear turbo outlet, have also replaced this. After fixing both of these leaks - still have the running rich issue. I’ve also tried another pair of AFM’s - no change here After pulling off the front turbo intake pipes, there is obvious shaft play in the front turbo, which now hisses loudly on light revvs although I can’t see why this would make the car run funny even under idle. I’m curious to know why it’s running rich before I potentially replace/rebuild turbos. The car is completely stock <50,000kms  other than an exhaust. Oil and coolant are all clear. I haven’t bothered with coil packs as it looks like they won’t be the issue due to condition of the plugs. Any help appreciated as I cry myself to sleep!
    • No probs at all. I used to love trying to dig up obscure info for those in need where possible going back 20+ years on SAU.  I did have another look and couldn't come up with any closer match. I'm leaning towards those skirts in your first pic are custom fitments, cut down/extended or from another car entirely and modded to fit an R34 sedan. I would've thought someone in Japan had them and taken a photo at some stage over the last 2 decades but there's nothing. Someone out there must know surely.
    • Welcome mate. Any pics? Even with a DE I'd be well happy if I had that as a 1st car. 
×
×
  • Create New...